Canon AE-1 Manuel utilisateur

Check the Battery

Whenever you check out one of our cameras you should verify that

the battery level is good.

The battery level is checked by pressing the battery check button on

the top of the camera while watching the meter needle in the view-

nder. If the meter needle rests below the index mark or 5.6 the

battery level is ok. If the meter needle rests above the index mark ask

the lab aide to replace the battery for you.

Battery check button

Meter needle as seen in viewfinder

Getting started with the Canon AE-1

The Very Very Short Version.

Setting the Film Speed and Using the Meter.

Set the Film Speed

To set the lm speed, rst push

the lm advance lever to its stand-

o position away from the camera

body, then lift up the ASA ring

around the shutter dial and rotate it

in either direction until the proper

number is aligned with the green

index mark.

Light Meter

First set the shutter speed to the

desired setting. TIP: For hand-held

shots you shutter speed should be

set to 125 or higher. Then to use the

light meter, lightly press the shutter

release button while looking through

the view nder. Make note of the

aperature setting indicated by the

meter needle in the veiwnder then

set the aperature ring on the lens to

the setting indicated. The setting will

vary depending on your shutter speed

and lighting conditions.

Meter

Set the Film Speed

Rewinding the Film

When the lm advance lever cannot travel

all the way to the end of its stroke, the lm

counter tells you that you have reached

the end of the roll. You have to rewind the

lm into its protective cartridge before

removing it from the camera. To rewind,

press the small black rewind button on the

bottom of the camera, unfold the rewind

crank and turn it in the direction of the ar-

row. When the frame counter has reached

the “S” mark you should stop. Then pull

up the rewind crank and open the camera

back.

Rewind Button

Page 1

Page 4

It is important to load the lm correctly to avoid time comsuming

re-shoots. Follow these steps. Avoid direct sunlight when loading or

unloading lm.

How to Load the Film

Open the Back Cover

Pull up the rewind crank and the back cover will pop open. The back

cover can be securely closed by simply pressing it until it locks.

Rewind Crank

Next, Place the cartridge into the lm cartidge chamber and press

down while rotating the rewind knob until it drops securely into posi-

tion. The protuding part of the cartridge should be on the bottom. Pull

the lm leader across and insert the end into one slot of the the take-

up spool. Turn the lm advance lever and wind the lm around the

take-up spool making sure that the perforations of the lm are

engaged in the teeth of the lm transport sprocket.

Film Cartidge Chamber

Then, make sure there is no lm slack. In case there is, gently turn the

lm rewind crank in the direction of the arrow to obtain proper lm

tautness. Crank the lm advance lever to ensure that the lm leader is

wound fully on to the take-up spool before closing the camera back.

Close the back cover until it snaps shut. Gently turn the lm rewind

crank in the direction of the arrow to take up any remaing slack. Then,

advance the lm a couple of times presssing the shutter button until

the rst exposure appears in the frame counter. TIP: Watch the film

rewind knob as you advance the film. If it rotates, the film is properly

loaded. If it doesn’t, open the back cover and load the film again from

the start.

Take-Up Spool

Rewind Crank

Page 2 Page 3

Autres manuels pour AE-1

Autres manuels Canon Appareil photo numérique

Canon

Canon Digital Camera Solution Disk Version 22 Manuel utilisateur

Canon

Canon IXUS850 IS Guide de l'utilisateur

Canon

Canon 450D - EOS Rebel XSi Manuel utilisateur

Canon

Canon SD550 - PowerShot Digital ELPH Camera Guide de l'utilisateur

Canon

Canon PowerShot A95 Manuel utilisateur

Canon

Canon PowerShot A300 Manuel utilisateur

Canon

Canon Powershot S60 Manuel utilisateur

Canon

Canon PowerShot SX740 HS Guide d'installation

Canon

Canon PowerShot G3 Mode d’emploi

Canon

Canon Sure Shot 60 Zoom Manuel utilisateur

Canon

Canon VI-T Manuel utilisateur

Canon

Canon EOS EOS 30D Manuel utilisateur

Canon

Canon CR-N500 Manuel utilisateur

Canon

Canon EOS REBEL T6i Manuel utilisateur

Canon

Canon PowerShot SX50 HS Manuel utilisateur

Canon

Canon IXUX 240 HS Manuel utilisateur

Canon

Canon EOS 600D Manuel utilisateur

Canon

Canon EOS-1Ds Mark III Manuel utilisateur

Canon

Canon EOS-1D Mark II Digial Manuel utilisateur

Canon

Canon PowerShot A430 Manuel utilisateur

Canon

Canon EOS 10D Digital Instructions de montage

Canon

Canon PowerShot ELPH 110 HS Manuel utilisateur

Canon

Canon XA25 Manuel

Canon

Canon Digital IXUS II s Manuel utilisateur

Manuels Appareil photo numérique populaires d'autres marques

Mercury

Mercury 350K Manuel utilisateur

Pentax

Pentax Optio LS 465 Manuel utilisateur

Sanyo

Sanyo VPC-S1085 Manuel utilisateur

GE SMART A1255 Manuel utilisateur

Point Grey

Point Grey Gazelle Manuel utilisateur

Nikon

Nikon COOLPIX A Manuel utilisateur

Pentax

Pentax P-5 Manuel utilisateur

BlazeVideo

BlazeVideo A280 Manuel utilisateur

Sony

Sony MCA-20 Manuel utilisateur

Sony

Sony Alpha DSLR-A290 Manuel utilisateur

ATIK Cameras

ATIK Cameras One Manuel utilisateur

CohuHD Costar

CohuHD Costar 3930 Series Manuel utilisateur

Leica

Leica M10-R Manuel utilisateur

FujiFilm

FujiFilm FinePix A700 Manuel utilisateur

Lorex

Lorex LNZ81P25 Series Manuel utilisateur

GE J1470S Manuel utilisateur

Sony

Sony A6700 Guide de l'utilisateur

Nikon

Nikon Coolpix 100 Manuel utilisateur