Britax Steelcraft Agile SH908 Manuel utilisateur
• Do not allow children to stand on the seat.
• Do not hang bags or goods from the handle as this could cause
the stroller to tip over.
• To prevent the risk of the stroller catching fire, do not park it near an
exposed heat source such as a radiator, an open fire or a barbecue,
etc.
• Do not run while using this product.
• Always lock swivel wheels when on rough surfaces as this will help
eliminate wheel wobble.
• Always raise the leg support (where fitted) to its highest position
when transporting a baby. This will reduce the risk of the baby
falling out through the front of the stroller if not correctly
harnessed.
• It is unsafe to use accessories other than those tested and approved
by Britax. For maximum safety only use accessories designed for this
stroller.
• Do not place more than 4kg in the basket or 1kg in the Canopy
Pocket (if supplied)
• The maximum weight of the child using this product is not to
exceed 17kg for the Stroller or 9kg for the Infant Carrier.
FOR WARNINGS ON ACCESSORIES - REFER TO THEIR INDIVIDUAL
SECTIONS IN THIS BOOK. THE MAXIMUM WEIGHT VARIES FOR EACH
ACCESSORY.
03
30
NOTES
04 29
IMPORTANT
The upright positions are not suitable for use with children less
than six months old. The lowest recline position should be used
to transport babies, and the backrest can be adjusted to a more
upright position as the child grows older and is able to support
its head without assistance.
SAFETY WARNING
The sun is very strong. DO NOT LEAVE YOUR CHILD EXPOSED TO THE
SUN.The canopy or hood on this product will not give your child
total protection from the harmful rays of the sun.
PARTS LIST NOTES
05
28
PARTS LIST
A 1 x Stroller Frame, Seat & Basket
B 1 x Canopy
C 2 x Rear Wheels
D 2 x Front Wheels
E2 x Infant Carrier Adaptors
AB
CD
E
14. TO RELEASE THE INFANT CARRIER (Cont)
C Lift and remove the Infant Carrier away from the stroller.
D To remove the adaptors, press the red lever in on the inside of
the adaptor and pull the adaptor up.
C
Red lever
D
Adaptors
27
ASSEMBLED STROLLER - PARTS LIST
Handle
Tether Strap
Shoulder pads
Harness
Basket
Front leg tube
Rear leg tube
Sure Lock release button
Canopy
Front canopy tube
Upper seat
Inner seat
Folding strap
Front wheel
release button
Front wheel
swivel lock
Leg rest
Lower seat
Canopy window cover
Canopy window
Canopy back flap zipper
14. TO RELEASE THE INFANT CARRIER
A To remove the Infant Carrier, squeeze both handle latches in to
release the locks.The indicator will now be RED.
B Continue to rotate the handle forward until it returns to the
upright position. Release the latches,the indicator should now
be GREEN.
A
Handle latch
Indicator
B
Handle latch
01. TO OPEN THE STROLLER
Storage
latch
A Release the storage latch (1) located on the rear leg.
Open the frame as shown by the arrows (2) until you hear a‘click’
which indicates the frame is fully opened and locked.Push down
on the stroller handle to confirm that frame is locked.
1
2
2
2
02. TO ASSEMBLE AND REMOVE THE FRONT SWIVEL WHEELS
A To assemble the front swivel wheels,take each swivel wheel
assembly and insert and push it into each of the wheel mouldings
until you hear a‘click’ which indicates the wheel is locked in.
Check each wheel is fully locked by pulling against it.
A
A
A
B To remove the front swivel wheels, locate and press in the red
button on top of the wheel moulding.
B
26 07
13. TO INSTALL THE INFANT CARRIER (Cont)
E Squeeze and release the handle latches.Then with one hand
holding the front of the Infant Carrier, push the Infant Carrier
handle all the way down until you hear it lock into the adaptors.
The handle indicator should now be GREEN and the Infant Carrier
should be locked into the adaptors. If the indicator is RED the
Infant Carrier handle is not in the locked position, repeat step D.
IMPORTANT: Ensure that the Infant Carrier is locked into place by
pulling up on both sides. Do not use the Infant Carrier if it is not
correctly installed.
Please Note:The Infant carrier has been fitted with a hood when
using the stroller.The hood can also be used in the car. Refer to
the Infant Carrier instructions regarding placing and securing
your baby in the Infant Carrier.
E
08 25
03. TO FIT AND REMOVE THE REAR WHEELS
04. TO USE THE SWIVEL WHEELS
A To fit the rear wheels, insert each wheel axle into the moulding
and push in until locked.You should hear a ‘click’ which indicates
the wheel has locked in. Pull on the wheel to make sure it is
engaged. Repeat the process if not locked in.
B To remove the wheels, pull the metal latch downwards on the
underneath of the brake moulding to release the wheel, and then
pull the wheel off.
B
A
A Press the swivel lock down to lock the swivel wheels.
Push the swivel wheel lock up to allow the wheels to swivel.
Note: Always lock the swivel wheels when using the stroller on
rough surfaces as it will minimise wheel wobble.
Metal Latch
C Lower the Infant Carrier into the adaptors.Press down firmly on
both sides.
D The Infant Carrier now needs to be locked securely into the
adaptors. Squeeze in and hold the latches on either side of the
handle, rotate the handle backwards.The GREEN indicator will
now turn to RED.
05. TO ATTACH AND USE THE CANOPY
A1 To attach the canopy, insert the canopy mouldings into the frame
mouldings until they connect together.The back flap of the
canopy can be attached to the main canopy with the zipper
attachment.
24 09
A2 Attach the snaps located on the straps on the sides of the canopy
to the top of the handle tubes,then fold the strap up under the
canopy back flap and secure strap with hook and loop to the
underneath of the canopy.
13. TO INSTALL THE INFANT CARRIER (Sold Separately)
A Stand in front of the stroller and pull the fabric back from the sides
of the stroller to expose the stroller hinge.Take one Infant Carrier
adaptor at a time and insert the adaptor into the stroller hinge as
shown. Push on the adaptor until you hear a‘click which indicates
the adaptor has locked in. Pull up on each adaptor to check they
have fully locked in.
B Face the feet end of the Infant Carrier towards the stroller
backrest.With the Infant Carrier handle in the upright position
locate the Infant Carrier handle mouldings over the adaptors on
either side. Notice the indicator is GREEN.
Adaptor
Indicator
Adaptor
A
B
Please Note: Fit adaptors standing in front of the stroller. Infant
Carrier adaptors are marked Left & Right for correct fitting.
10 23
05. TO ATTACH AND USE THE CANOPY (Cont) 12. TO FOLD THE STROLLER (Cont)
A3 Attach the hook square on the inside of the canopy backflap to
the loop strip on the side of the stroller.
A4 Attach the hook strip on the inside edge of the canopy to the loop
strip on the side of the stroller.
13. TO INSTALL THE INFANT CARRIER (Sold Separately)
• THE STEELCRAFT INFANT CARRIER IS THE ONLY INFANT CARRIER
DESIGNED TO FIT THIS STROLLER.
• THE INFANT CARRIER MUST BE CORRECTLY FITTED AND
LOCKED ONTO THE STROLLER.
• THE INFANT CARRIER MUST ONLY BE USED IN THE REARWARD
FACING POSITION, FITTED TO THE STROLLER FACING TOWARD
THE STROLLER HANDLE.
• SECURE THE CHILD IN THE HARNESS AT ALL TIMES.
• DO NOT LEAVE THE CHILD IN THE INFANT CARRIER FOR
EXTENDED PERIODS.
• THE INFANT CARRIER IS DESIGNED TO PROVIDE MOBILITY
OUTSIDE OF THE CAR BUT IT SHOULD NOT BE USED INSTEAD OF
AN APPROPRIATE COT.
• THE INFANT CARRIER MUST BE REMOVED FROM THE FRAME
BEFORE FOLDING.
• THE MAXIMUM WEIGHT OF THE CHILD USING THIS PRODUCT
IS NOT TO EXCEED 9kg.
Please Note: These Instructions are for installing and removing
the Infant Carrier on the stroller only.
For installing and and proper care of the Infant Carrier in the
car please follow the Instruction book that is included with the
Infant Carrier.
Table des matières
Autres manuels Britax Poussette
Britax
Britax LAYBACK STROLLER Manuel utilisateur
Britax
Britax Zinnia Bassinet Manuel utilisateur
Britax
Britax B-Ready Manuel utilisateur
Britax
Britax B-MOTION 3 Manuel utilisateur
Britax
Britax B-LITE Manuel utilisateur
Britax
Britax B-AGILE Manuel utilisateur
Britax
Britax B-DUAL - Manuel utilisateur
Britax
Britax Car Seat Manuel utilisateur
Britax
Britax MOTION 3 Manuel utilisateur
Britax
Britax ACCLAIM - SERIES S400 Manuel utilisateur
Britax
Britax B-SAFE GEN2 FLEXFIT Manuel utilisateur
Britax
Britax Strider Compact Manuel utilisateur
Britax
Britax Y2K 03.A Manuel utilisateur
Britax
Britax B-AGILE Manuel utilisateur
Britax
Britax Steelcraft Sprint Manuel utilisateur
Britax
Britax ESPRIT Manuel utilisateur
Britax
Britax Steelcraft STROLL LITE LX5012 Series Manuel utilisateur
Britax
Britax romer BABY-SAFE SLEEPER Manuel utilisateur
Britax
Britax Stroller Manuel utilisateur
Britax
Britax PHOENIX - SERIES AX108 Manuel utilisateur
