Bose X Manuel utilisateur

Headset Installation

Remove all 4 screws (2 on each side) on pivot-

ing arms that sides of ear cups are attached to.

(gure 1)

Place headset over approximate area where

it would go over the helmet (be aware of left/

right of headset, as well as helmet). (gure 2)

Secure headband straps over headband of

headset. (gure 3)

1900 Weld Blvd. Ste. 140 El Cajon, CA 92020 • 800.440.5904 • gibson-barnes.com

Bose®X Headset

Installation of headset into cloth/leather helmet

Tools Required

Small Phillips Head Screwdriver

gure 1

gure 2

Insert ear cup entirely through bottom portion

of helmet’s ear opening (take precaution as to

not pull/stretch the wire exiting the ear cup).

(gure 5)

Starting with one side, gently pull pivoting arms

apart to release ear cups. (gure 4)

Insert threaded silver stand-off (on the same

side of the ear cup that the cord exits)into the

hole that is on the strap covering the helmet’s

ear hole. (gure 6)

1900 Weld Blvd. Ste. 140 El Cajon, CA 92020 • 800.440.5904 • gibson-barnes.com

Bring he lower part of the helmet’s ear-hole

opening under the ear cup so that the seam is

sitting between the plastic and foam portion.

(gure 7)

gure 3 gure 5

gure 6

gure 4

1900 Weld Blvd. Ste. 140 El Cajon, CA 92020 • 800.440.5904 • gibson-barnes.com

Locate the silver stand-off on the other side of

the ear-cup.Verify it is placed above the portion

of the strap that supports that side of the ear-

cup. (gure 8)

Gently but rmly pull the opening up and over

the top of the ear-cup so that the seam of the

opening is sealed around the entire circumfer-

ence of the ear-cup (between the plastic portion

and the foam ear seal). (gure 9)

Once the ear cup is secure, verify that no por-

tion of the strap is covering the microphone port

in the center of the ear cup.

Repeat same process on opposing ear cup.

gure 7 gure 9

gure 8

1900 Weld Blvd. Ste. 140 El Cajon, CA 92020 • 800.440.5904 • gibson-barnes.com

Reinstall screws. (gure 12)

Reverse steps to uninstall

gure 12

CAUTION: Installation of third-party head-set products is done at the user’s own risk. Gibson & Barnes assumes no responsibility for damage or loss

due to the installation or use of this product.

If there is any point of installation that you do not understand, please contact our Technical Support Staff at: 1-800-440-2700, or visit our website at:

www.gibson-barnes.com

Afliation Disclaimer: Any product names, logos, brands, and other trademarks or images featured or referred to within this document are the property of their

respective trademark holders. These trademark holders are not afliated with Gibson & Barnes, our products, or our website. They do not sponsor or endorse

Gibson & Barnes or any of our products.

Autres manuels pour X

Autres manuels Bose casque