Bosch 715ES Manuel de référence

Models: 715ES, 2400ES, 2700ES

Replacing the Attenuator

Service Bulletin G3-29

Introduction

Bosch Thermotechnology recommends the following water

heater adjustments to accomodate installations with a broader

range of operating conditions and to improve operation with

varying characteristics of LP gas combustion.

Tools needed:

Phillips head screwdriver

Preparation

1. Unplug the water heater power supply cord.

2. Loosen two Phillips head screws located at bottom rear of cover.

(Fig. 1, step 1, pos. 1).

3. Lift front cover upward and remove. (Fig. 1, step 1, pos. 2 & 3)

4. Remove secondary combustion cover by unclipping two upper

and two lower clips securing cover. (Fig. 1, step 2)

Step 1 Step 2

tep

Figure 1

Removing the attenuator

1. Locate attenuator. (Fig. 2, pos. 1).

2. Remove three Phillips head screws from attenuator.

(Fig. 2, pos. 2)

Figure 2

3. Pull attenuator free from heater. Discard the black o-ring

positioned between the fan assembly and attenuator.

(Fig. 3, pos 1.)

Data subject to change without notice | Printed in the USA | 02.2008 Bosch Thermotechnology Corp.

Service bulletin

18 | G3-29 | 715ES, 2400ES, 2700ES

Bosch Thermotechnology Corp.

50 Wentworth Avenue

Londonderry, NH 03053

Tel: 1-866-642-3198

Fax: 1-603-584-1681

www.boschpro.com

Fan

Attenuator

Fan

ttenuato

Figure 3

o-ring

(to be discarded)

Replacing the attenuator

1. Install replacement attenuator to the fan without o-ring.

(Fig. 3, pos. 1).

2. Secure the attenuator to the fan assembly with three Phillips

head screws. (Fig. 2, pos.2).

Adjusting fan speed (LP models only)

Note: Upon replacing the attenuator, if the water heater is a liquid

propane model, the fan speed should be adjusted using the

following the procedure.

1. Plug in power supply cord.

2. Press and hold the program ( ) button while pressing the On/

Off button to the On position. (Fig. 4)

Figure 4

3. Release the program ( ) button when '188' appears on the

display. The display should read 'P2'. If not, repeat process.

(Fig. 4)

4. Press the ( ) button on the control panel until the display reads

'P1'.

5. Press the program ( ) button once and the display should show

the numeric value of the fan speed.

6. Use the ( ) and ( ) buttons on the control unit to select the

new fan speed for your model. The P1 fan speeds should be set

to the following:

Model GWH 2400 ES: P1 fan speed = 37

Models GWH 715 ES and GWH 2700 ES: P1 fan speed = 42

7. Press and hold (± 5 sec.) the program ( ) button until the

display flashes. The selected value is now memorized.

8. Press On/Off button on water heater to Off position. Press On/

Off button again to turn water heater back on.

9. Replace combustion cover only.

Adjusting CO₂

1. The water heater requires a CO₂ adjustment after the installation

of the replacement attenuator. Refer to Service Bulletin G3-12

for detailed instructions on this process.

2. After adjusting CO₂, replace front cover.

3. Press On/Off button on water heater to Off position. Press On/

Off button again to return water heater to normal service.

Autres manuels pour 715ES

Ce manuel convient aux modèles suivants

Autres manuels Bosch Chauffe-eau

Bosch

Bosch AE3.4 Manuel de référence

Bosch

Bosch RDE182141M Manuel utilisateur

Bosch

Bosch C 950 Manuel du propriétaire

Bosch

Bosch OptiFlow Professional GWH12 1 CTD E23 Manuel utilisateur

Bosch

Bosch C1210ES Instructions d'utilisation

Bosch

Bosch AE12 Manuel utilisateur

Bosch

Bosch C1050ES Manuel de référence

Bosch

Bosch TR4000 4 ET Manuel utilisateur

Bosch

Bosch Pro Tankless GWH-450-ES Series Manuel utilisateur

Bosch

Bosch 10P Manuel

Bosch

Bosch C 1210 ES/ESC Manuel utilisateur

Bosch

Bosch GWH 1600 PS Manuel utilisateur

Bosch

Bosch TR2500TO Manuel utilisateur

Bosch

Bosch WR8 series Document technique

Bosch

Bosch TR2500TO 5 B Manuel utilisateur

Bosch

Bosch TR5000 Series Manuel utilisateur

Bosch

Bosch BBT NORTH AMERICA AquaStar 240FX Manuel de service

Bosch

Bosch TR7000R 18/21 DESOAB Manuel utilisateur

Bosch

Bosch GWH 10-2 G Series Document technique

Bosch

Bosch 830ES Manuel de référence

Bosch

Bosch AQUA STAR 2400E NG Manuel utilisateur

Bosch

Bosch C 1210 ESC Manuel de référence

Bosch

Bosch PowerStar AE115 Manuel utilisateur

Bosch

Bosch AQ 125BO NG Manuel utilisateur

Manuels Chauffe-eau populaires d'autres marques

Kenmore

Kenmore 153.582400 Manuel utilisateur

Applimo

Applimo Edel AIR Manuel utilisateur

STIEBEL ELTRON

STIEBEL ELTRON Eltronom SHU 5 S Manuel utilisateur

clage

clage E-Mini Series Manuel utilisateur

Toyotomi

Toyotomi Oil Miser OM-180 Manuel utilisateur

Bradford White

Bradford White EF Series Manuel utilisateur

Eccotemp

Eccotemp 40-H Manuel utilisateur

Dimplex

Dimplex ECSd125-580 Mode d’emploi

Dux

Dux 32FCR6N Manuel utilisateur

Toyotomi

Toyotomi Oil Miser OM-148 (Type D) Guide de dépannage

Noritz

Noritz N-132M Manuel d'instructions

TESY

TESY GCV7/4S 10047 Fiche technique

A.O. Smith

A.O. Smith Gphe 50 Manuel utilisateur

Koryo

Koryo KWHZF15Y Manuel utilisateur

Pentair

Pentair PSC-14-4-02 Manuel utilisateur

GE 40M06AAG Instructions de montage

Thermor

Thermor AEROMAX SPLIT 2 Manuel utilisateur

American Hometec

American Hometec AHQ-B03X Manuel utilisateur