Bosch C 1210 ESC Manuel de référence

Technical Service Bulletin:

A3 / E3 Error Code Troubleshooting

Models: C1210ESC, C1210ES, C1050ES, C950ES, 940ES, 940ESO, 830ES

Introduction

The following procedures are for gathering information to assist

Bosch Tech Support in determining the cause and solution to the

problem. Unplug power cord and remove outer and inner covers

from heater (refer to Installation Manual).

Note: The following bulletin applies only to serial numbers up to

FD986

Error code explanation:

A3 error code: Open jumper circuit

E3 error code: Incorrect resistance in jumper circuit

Tools needed:

Phillips head screwdriver

Ohmmeter

Troubleshooting procedure

1. Check position of jumper at top right of heat exchanger plugged

into connector on green wires (Fig. 1, pos.1).

Figure 1

If jumper is near heat exchanger or ﬂue gas collector, move

jumper to the right and tuck wires into clip on right side to

prevent jumper from overheating (Fig. 2, pos. 1).

Figure 2

2. Check that jumper is connected tightly to connector. Disconnect

and reconnect to improve connection.

3. Check for correct appliance type setting (model 830ES skip this

step):

a. Plug in heater's power cord and place heater into diagnostic

mode (refer to manual section 6.7).

b. Push “+” button until “P7” is displayed.

c. Push “P” button. Display should read “NO” or “NC”.

d. If display reads “Cd”, push “+” button until “NO” is dis-

played. Push “P” button for 5 seconds to save correct

appliance type.

e. Push power button to "off" position and back to "on"

position.

Before proceeding to the next step, plug in power cord and reset

the heater to see if error code has cleared. If error code will not

clear or occurs again during operation, move to step 4.

4 |A3 / E3 Error Code Troubleshooting Technical Service Bulletin

Data subject to change without notice | Printed in the USA | BTC 740002307 B | 06.2011 Bosch Thermotechnology Corp.

Bosch Thermotechnology Corp.

50 Wentworth Avenue

Londonderry, NH 03053

Tel: 1-800-283-3787

Fax: 1-603-584-1687

www.bosch-climate.us

4. Remove control unit from heater and reseat wire connector on

circuit board:

a. Unplug heater‘s power cord.

b. Remove 3 screws attaching control unit to heater.

c. Turn control unit over.

d. Remove 6 screws attaching rear cover to control unit.

e. Remove rear cover.

f. Locate shorter of 2 multiple wire connectors on edge of

circuit board (Fig. 3, pos.1).

g. Remove and reinstall connector onto edge of board to

improve the electrical connection.

Figure 3

5. Ensure power cord is still unplugged or push power button to

"off" position. Disconnect jumper from connector and measure

resistance through jumper.

a. If less than 115 or greater than 125 ohms, jumper is faulty.

b. If between 115 and 125 ohms, contact Bosch Tech Support

for further instructions.

Autres manuels pour C 1210 ESC

Ce manuel convient aux modèles suivants

Autres manuels Bosch Chauffe-eau

Bosch

Bosch Greentherm 9800 SEO 160 Manuel utilisateur

Bosch

Bosch WR400 K T2 Series Manuel du propriétaire

Bosch

Bosch Aquastar 2400 ES Manuel utilisateur

Bosch

Bosch Model GWH 425 Manuel utilisateur

Bosch

Bosch Greentherm T9800 SEC 160/199 Instructions d'utilisation

Bosch

Bosch Tronic 5000 Manuel utilisateur

Bosch

Bosch 940ESO Manuel utilisateur

Bosch

Bosch GWH 1600 P NG Manuel utilisateur

Bosch

Bosch Therm 6000 S Manuel utilisateur

Bosch

Bosch TRONIC 3000 US3-2R Document technique

Bosch

Bosch SST150-40 Manuel utilisateur

Bosch

Bosch AQ 125BO LP Manuel utilisateur

Bosch

Bosch C 1210 ES/ESC Manuel utilisateur

Bosch

Bosch WH36 Document technique

Bosch

Bosch C 1210 ESC Manuel de référence

Bosch

Bosch WR 11 B Document technique

Bosch

Bosch Tronic 1000 T Manuel utilisateur

Bosch

Bosch PowerStar AE115 Manuel utilisateur

Bosch

Bosch WR430-7K Instructions de montage

Bosch

Bosch TR5500T Series Manuel utilisateur

Bosch

Bosch GWH 425 EF Manuel utilisateur

Bosch

Bosch TR7000 Series Manuel utilisateur

Bosch

Bosch Tronic 3000 C Pro US12 Manuel utilisateur

Bosch

Bosch 520HN Manuel de référence

Manuels Chauffe-eau populaires d'autres marques

Kenmore

Kenmore 153.582400 Manuel utilisateur

Applimo

Applimo Edel AIR Manuel utilisateur

STIEBEL ELTRON

STIEBEL ELTRON Eltronom SHU 5 S Manuel utilisateur

clage

clage E-Mini Series Manuel utilisateur

Toyotomi

Toyotomi Oil Miser OM-180 Manuel utilisateur

Bradford White

Bradford White EF Series Manuel utilisateur

Eccotemp

Eccotemp 40-H Manuel utilisateur

Dimplex

Dimplex ECSd125-580 Mode d’emploi

Dux

Dux 32FCR6N Manuel utilisateur

Toyotomi

Toyotomi Oil Miser OM-148 (Type D) Guide de dépannage

Noritz

Noritz N-132M Manuel d'instructions

TESY

TESY GCV7/4S 10047 Fiche technique

A.O. Smith

A.O. Smith Gphe 50 Manuel utilisateur

Koryo

Koryo KWHZF15Y Manuel utilisateur

Pentair

Pentair PSC-14-4-02 Manuel utilisateur

GE 40M06AAG Instructions de montage

Thermor

Thermor AEROMAX SPLIT 2 Manuel utilisateur

American Hometec

American Hometec AHQ-B03X Manuel utilisateur