Bosch Photobeam 5000 Mode d'emploi

Photobeam 5000

ISC-FPB1-W60QF, ISC-FPB1-W120QF, ISC-FPB1-W200QF

en Installation and Operation Guide

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

3 Photobeam 5000 Table of Contents | en

Table of contents

1 Introduction 4

1.1 About documentation 4

1.2 Bosch Security Systems, Inc 4

2 System overview 5

2.1 Features 5

2.2 Photobeam overview 6

2.3 Console overview 7

2.4 Transmitter/receiver dimensions 8

3 Installation 9

3.1 Beam spread 9

3.2 Pole mount installation 10

3.3 Wall mount installation 12

4 Wiring 13

4.1 Terminal strip overview 13

4.2 Wiring distance 14

4.3 Wiring routes 14

5 Special features 16

5.1 Selectable beams 16

5.2 Selectable AND/OR Gate 16

5.3 Level LED 16

5.4 EDC (Environmental Discrimination Circuit) 16

5.5 Beam interruption time 17

5.6 Beam power control 17

5.7 High Density 18

6 Setup 21

7 Installing multiple sets (stacking) 25

7.1 Group selection 25

7.2 Channel selection 27

7.3 Synchro wiring 29

7.4 Stacking examples 30

7.4.1 Single stacking 30

7.4.2 Double stack 30

7.4.3 Triple stack 31

7.4.4 Quadruple stack 32

8 Optical alignment 35

8.1 Level LED – alignment of the Upper Beam 35

8.2 Level LED - alignment of the Lower Beam 35

8.3 Volt meter alignment 36

9 Operational check 38

10 Troubleshooting 39

10.1 Additional information 39

11 Certifications 40

12 Specifications 41

Bosch Security Systems, Inc. Installation and Operation Guide 2016.02 | 03 | F.01U.303.478

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

4 en | Introduction Photobeam 5000

1 Introduction

This document contains information that a trained installer needs to install the Photobeam

5000 quad-beam photoelectric detector contained inside the packaging.

1.1 About documentation

This document is the intellectual property of Bosch Security Systems, Inc. and is protected by

Trademarks

All hardware and software product names used in this document are likely to be registered

trademarks and must be treated accordingly.

1.2 Bosch Security Systems, Inc

Use the serial number located on the product label and refer to the Bosch Security Systems,

Inc. website at http://www.boschsecurity.com/datecodes/.

Manufacturing date information is contained in digit no 1 – 3: DDD.

2016.02 | 03 | F.01U.303.478 Installation and Operation Guide Bosch Security Systems, Inc.

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

5 Photobeam 5000 System overview | en

2 System overview

The ISC-FPB1-W60QF, ISC-FPB1-W120QF, and ISC-FPB1-W200QF are quad-beam

photoelectric detectors designed for indoor and outdoor applications. Consisting of a

separate transmitter and receiver, an alarm is activated when a person passes through the

beams. Combination of features and adjustable parameters allow for better catch

performance, lower false alarm rates, and reduced effects of environmental disturbances.

2.1 Features

For stable operation, the detectors are equipped with the following feautres:

100% Sensitivity Allowance

Maintains stable operation even if 99% of beam energy is cut, for example by rain, fog, frost,

and so on.

Quad Beam Detection

Fewer false alarms caused by birds and other small animals because all four beams must be

blocked simultaneously to cause an alarm.

Beam Power Control

Select the appropriate beam intensity relative to the detection range to minimize reflection on

nearby walls and cross-talk with other detectors.

Beam Interruption Time Control

Use to change the beam interruption time to best fit the application.

Bosch Security Systems, Inc. Installation and Operation Guide 2016.02 | 03 | F.01U.303.478

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

2.2

6 en | System overview Photobeam 5000

Photobeam overview

Figure 2.1: Photobeam components overview

Callout ーDescription Callout ーDescription

1 ー Mounting holes 8 ー Optical alignment

2 ー Mounting plate 9 ー Vertical adjustment

3 ー Device securing screws 10 ー Horizontal adjustment

4 ー Wire entry 11 ー Console

5 ー Wiring terminals 12 ー Cover

6 ー Detector 13 ー Cover securing screws

7 ー Optical module

2016.02 | 03 | F.01U.303.478 Installation and Operation Guide Bosch Security Systems, Inc.

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

2.3

7 Photobeam 5000 System overview | en

Console overview

Figure 2.2: Console components overview

Callout ーDescription Callout ーDescription

1 ー Transmitter console 6 ー Status indicators

2 ー Power indicator 7 ーSensitivity control

3 ー Function switches 8 ーALIGNMENT CHECK TERMINALS

4 ー BEAM POWER CONTROL 9 ーHIGH DENSITY terminals

5 ーReceiver console

Bosch Security Systems, Inc. Installation and Operation Guide 2016.02 | 03 | F.01U.303.478

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

2.4

8 en | System overview Photobeam 5000

Transmitter/receiver dimensions

103 mm (4.0 in)

19.3 mm

(0.75 in)

398 mm (15.66 in)

244 mm (9.60 in)

96 mm (3.77 in)

77.1 mm

(3.03 in)

337.7 mm (13.29 in)

56 mm

(2.20 in)

220 mm (8.66 in)

39 mm

(1.5 in)

39.7 mm

(1.56 in)

Figure 2.3: Transmitter/receiver dimensions

Callout ﹘Description Callout ﹘Description

1 ー Knockout wire entrance 3 ー Center of the Upper Beam

2 ー Center of the Lower Beam 4 ー Wire entrance

2016.02 | 03 | F.01U.303.478 Installation and Operation Guide Bosch Security Systems, Inc.

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

9 Photobeam 5000 Installation | en

3 Installation

Prior to installing the devices, please review the installation considerations below:

– Install in an area that is clear of objects

– Install the transmitter/receiver within the maximum protection range of the model

– Do not install:

– Receivers into intense sources of light (for example, rising and setting sun)

– On movable surfaces subject to vibrations

– Detectors where immersion to water, corrosive liquids, or exposure to high levels of

dust can occur

– Detectors in close proximity to strong electromagnetic noises

– Do not use detectors with other photobeam detectors or receivers

– Do not disassemble or modify this detector

– Do not install while the power is on

– Avoid extreme temperature and humidity ranges as defined in the products specifications

– Avoid installing detectors near magnets and/or magnetized materials

– Avoid beam interference between other units when multiple units are installed

– Use the selectable beam’s feature when stacking detectors

3.1 Beam spread

The beam spread angle is ±0.7 °from the transmitter to the receiver. Refer to the diagram and

table below to determine the installation conditions.

Figure 3.1: Beam distance and spread

Callout ﹘Description Callout ﹘Description

1 ー Transmitter 4 ー Receiver

2 ー Horizontal spread (B) 5 ー Distance (A)

3 ー Vertical spread (C)

Bosch Security Systems, Inc. Installation and Operation Guide 2016.02 | 03 | F.01U.303.478

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

3.2

10 en | Installation Photobeam 5000

Distance, horizontal and vertical spread values: (A) / (B) / (C)

Metric Imperial unit

20 m / 0.5 m / 0.8 m 65 ft / 1.6 ft / 2.6 ft

40 m / 1.0 m /1.3 m 13.1 ft / 3.2 ft / 4.2 ft

60 m / 1.5m / 1.8 m 196 ft / 4.9 ft / 5.9 ft

80 m / 2.0 m / 2.2 m 262 ft / 6.5 ft / 7.2 ft

100 m / 2.5 m / 2.7 m 328 ft / 8.2 ft / 8.8 ft

120 m / 3.0 m / 3.2 m 393 ft / 9.8 ft / 10.4 ft

140 m / 3.5 m / 3.7 m 459 ft / 11.4 ft / 12.1 ft

160 m / 4.0 m / 4.2 m 524 ft / 13.1 ft / 13.7 ft

180 m / 4.5 m / 4.7 m 590 ft / 14.7 ft / 15.4 ft

200 m / 5.0 m / 5.2 m 656 ft / 16.4 ft / 17.0 ft

Pole mount installation

Figure 3.2: Pole mounting view

Callout ﹘Description Callout ﹘Description

1 ー Diameter 38.0 – 42.7 mm (1.50 – 1.68 2 ー Back-to-back pole mounting

in)

Attaching the mounting bracket:

1. Choose an appropriate mounting location for the devices. Install the mounting poles with

a clear line-of-sight between the transmitter and receiver.

2. Loosen the transmitter’s cover mounting screw and remove the cover.

3. Loosen the two base mounting screws and remove the mounting plate by sliding it down.

4. Attach the mounting hardware to the mounting plate using the clamping screws. Refer to

the figure below.

2016.02 | 03 | F.01U.303.478 Installation and Operation Guide Bosch Security Systems, Inc.

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Bosch Capteur de sécurité

Bosch

Bosch DS9370E Manuel utilisateur

Bosch

Bosch VMD01 M50 PAL Manuel utilisateur

Bosch

Bosch DS938Z Manuel utilisateur

Bosch

Bosch ISC-BPQ2-W12 Manuel utilisateur

Bosch

Bosch Multi-Detector DMD4 Instructions de montage

Bosch

Bosch ZX835 Manuel utilisateur

Bosch

Bosch D-tect 150 Professional Manuel utilisateur

Bosch

Bosch CRS-WM-TA869 Manuel utilisateur

Bosch

Bosch DS308EA Manuel utilisateur

Bosch

Bosch DS940 Manuel utilisateur

Bosch

Bosch Analog Detector Series Mode d'emploi

Bosch

Bosch TriTech DS970 Series Manuel utilisateur

Bosch

Bosch FCP-O 500 Manuel utilisateur

Bosch

Bosch ISC-PPR1-WA16G Manuel utilisateur

Bosch

Bosch DS9360 Manuel utilisateur

Bosch

Bosch ISC-PDL1-W18G Manuel utilisateur

Bosch

Bosch AVIOTEC IPSTARLIGHT 8000 Manuel technique

Bosch

Bosch SMT500 Manuel utilisateur

Bosch

Bosch FCH-T320 Manuel du propriétaire

Bosch

Bosch Blue Line Q1 Manuel utilisateur

Bosch

Bosch ISN-SM-50 Manuel utilisateur

Bosch

Bosch TriTech+ ISC-PDL1-WA18G Manuel utilisateur

Bosch

Bosch Blue Line P1 Manuel utilisateur

Bosch

Bosch DS915 Manuel utilisateur

Manuels Capteur de sécurité populaires d'autres marques

THORLABS

THORLABS PDA10JT Manuel utilisateur

Waeco

Waeco UV-DETECT Manuel utilisateur

Intermatic

Intermatic IOS-DSIMF Manuel utilisateur

urmet domus

urmet domus 1083 Manuel utilisateur

Siemens

Siemens AZL66 Series Manuel utilisateur

BTI

BTI Profiline Multi Finder Manuel utilisateur

Challenger

Challenger SL01 Manuel utilisateur

DMP Electronics

DMP Electronics 1122INT Manuel utilisateur

Rielta

Rielta Ladoga MK-RK Manuel utilisateur

Mirion Technologies

Mirion Technologies ACCURAD PRD Manuel utilisateur

DBI SALA

DBI SALA EZ Stop Manuel de l'opérateur

Lamptime

Lamptime ST05C Manuel utilisateur

Ubiquiti

Ubiquiti MFI-MSC Manuel utilisateur

Subsite

Subsite 910R Instructions d'installation

Satel

Satel OPAL Pro Manuel utilisateur

Aleph

Aleph XC-1XTEU Manuel utilisateur

Pima

Pima LARIS QUAD Manuel utilisateur

Solinst

Solinst 301 Manuel utilisateur