Bosch DS940Q Manuel utilisateur

DS940Q

Passive Infrared Detector

Installation Instructions

1.0 Description

The DS940Q is a high performance Passive Infrared (PIR) Motion Detector which uses advanced signal processing to provide outstanding

catch performance and unsurpassed false alarm immunity. It is designed to detect movement in the interior of a structure by sensing the

Infrared energy emitted from the human body as it moves across the detector’s field of view. When motion is detected, the detector sends an

alarm signal to the Control Panel.

2.0 Specifications

•Input Power: 9-15 volts DC

•Current Draw: 12 mA @ 12 VDC standby and alarm

•Standby Power: No internal standby power. For UL Listed Product

Installations, 4 hours (48 mA-h) standby power

must be provided.

•Relay Form “A” Normally Closed (NC) contact set rated

for 125 mA @ 28 volts maximum DC or 18 volts

maximum AC for resistive loads.

•Tamper: Normally Closed (with cover on). Contacts rated

at 28 VDC, 125 mA max. Connect tamper circuit

to a 24-hour protection circuit.

•Temperature: -20°F to +120°F (-29°C to +49°C). For UL Listed

Product Installations, the temperature range is

+32°F to +120°F (0°C to +49°C).

•Humidity: 0 - 95% non-condensing.

•Dimensions: 3.75 in. x 2.25 in. x 1.5 in. (HxWxD)

(9.5 cm x 5.7 cm x 3.8 cm)

•Options: B335 Swivel Mount Bracket. Use of this bracket

may decrease the PIR range and increase dead

zones.

•Reading Bosch Security Systems, Inc. Product Date Codes

For Product Date Code information, refer to the Bosch Security

Systems, Inc. Web site at: http://www.boschsecurity.com/

datecodes/

3.0 Installation

3.1 Remove the cover using a

small flat-blade screwdriver.

3.2 Press the vertical adjust tab

toward the side of the case and

lift out the board.

3.4 Position detector at correct height.

3.3 Select a mounting location.

Mount the sensor where an intruder

will most likely cross through the

coveragepattern.

LED

7.5-9ft

OFF

Bottom of Detector

Insert screwdriver here or here

3.3 Avoid:

7.5-9 ft.

(2.3- 2.7 m)

Mount the detector 7.5 - 9 feet

(2.3 - 2.7 meters) above the floor

Moving Objects

Pets

Heat

Sources

Windows

and

Uninsulated

Walls

Air

Conditioning

Outlets

Direct Hot or

Cold

Drafts

Mounting

Outdoors

Direct Sunlight

2/11

DS940Q Installation Instructions

P/N: F01U035308-07 Page 2

130 Perinton Parkway, Fairport, New York 14450

www.boschsecurity.com

3.8 Wire the Detector.

3.7 Install the board into the case. Be

sure the vertical adjust tab aligns with

the correct mounting height.

3.9 Select LED Operation 3.10 If look-down is desired, peel

away the look-down mask. Do

not remove the clear plastic

lens.

5.0 Coverage Patterns

4.0 Walk test at the time of installation

and annually thereafter.

LED

9-15

VDC

040

012

Meters

Feet

11 12-

22 23-

33 34-

44 45-

55 56-

66 67-

10 20 30

0040

012

Meters

Feet1-

11 12-

22 23-

33 34-

44 45-

55 56-

66 67-

Look

Down

7.5

LED

7.5-9ft

OFF ON

OFF

LED

7.5-9ft

OFF

Peel away

the mask

3.6 Mount the unit, using the appropriate

mounting holes.

Thinwall knockouts

for wiring

Corner Mount

Surface

Mount Remove

Areas

if using the

B335 Bracket

Don't overtighten the mounting screws

Cover may not attach correctly

Note: To avoid

possible

circuit board

damage, use

only the

mounting

hardware

provided in

the

appropriate

punch-out

mounting

holes.

This detector contains an environmental

stabilization circuit which requires

approximately 2 minutes after initial

power-up to warm up. During this time

the detector will not respond to any

movement.

Please wait 2 minutes after initial power-up to

perform any walk tests.

Although generally not required, if

masking is desired, the lens diagram

shows the appropriate areas to be

masked (see shaded area on the

DS940Q lens diagram). Use an

opaque material (such as, electrical

tape) to mask the desired areas. DS940Q Lens

(inside view)

1234567891011

12 22

23 33

34 44

45 55

56 66

67 77

LED

7.5-9ft

OFF

7.5-9 ft = 2.3-2.7 m

7.5-9ft

Table des matières

Autres manuels Bosch Capteur de sécurité

Bosch

Bosch TriTech+ ISC-PDL1-WA18G Manuel utilisateur

Bosch

Bosch Blue Line D1-P Manuel utilisateur

Bosch

Bosch ISC-CDL1-W15H Manuel utilisateur

Bosch

Bosch CRS-SWM-TA869 Manuel utilisateur

Bosch

Bosch DS9360 TriTech Manuel utilisateur

Bosch

Bosch D-tect 150 Manuel utilisateur

Bosch

Bosch D603 Manuel utilisateur

Bosch

Bosch ZX835 Manuel utilisateur

Bosch

Bosch DS915 Manuel utilisateur

Bosch

Bosch DS150I Manuel utilisateur

Bosch

Bosch VMD01 M50 PAL Manuel utilisateur

Bosch

Bosch DS9360 Manuel utilisateur

Bosch

Bosch RF940U Manuel utilisateur

Bosch

Bosch Smart Home RFPR-ZB-SH-EU Manuel utilisateur

Bosch

Bosch Blue Line D1-P Manuel utilisateur

Bosch

Bosch ISC-CDL1-WA15H Manuel utilisateur

Bosch

Bosch ISC-CDL1-W15G Manuel utilisateur

Bosch

Bosch DS835 Manuel utilisateur

Bosch

Bosch DS306E Manuel utilisateur

Bosch

Bosch Blue Line D1-P Manuel utilisateur

Bosch

Bosch DS935 VdS Manuel utilisateur

Bosch

Bosch D-tect 150 SV Professional Manuel utilisateur

Bosch

Bosch DS1109i Manuel utilisateur

Bosch

Bosch Analog Detector Series Mode d'emploi

Manuels Capteur de sécurité populaires d'autres marques

THORLABS

THORLABS PDA10JT Manuel utilisateur

Waeco

Waeco UV-DETECT Manuel utilisateur

Intermatic

Intermatic IOS-DSIMF Manuel utilisateur

urmet domus

urmet domus 1083 Manuel utilisateur

Siemens

Siemens AZL66 Series Manuel utilisateur

BTI

BTI Profiline Multi Finder Manuel utilisateur

Challenger

Challenger SL01 Manuel utilisateur

DMP Electronics

DMP Electronics 1122INT Manuel utilisateur

Rielta

Rielta Ladoga MK-RK Manuel utilisateur

Mirion Technologies

Mirion Technologies ACCURAD PRD Manuel utilisateur

DBI SALA

DBI SALA EZ Stop Manuel de l'opérateur

Lamptime

Lamptime ST05C Manuel utilisateur

Ubiquiti

Ubiquiti MFI-MSC Manuel utilisateur

Subsite

Subsite 910R Instructions d'installation

Satel

Satel OPAL Pro Manuel utilisateur

Aleph

Aleph XC-1XTEU Manuel utilisateur

Pima

Pima LARIS QUAD Manuel utilisateur

Solinst

Solinst 301 Manuel utilisateur