blupura WAVE HOT Fiche technique
WAVE HOT
WAVE BOX HOT
U
s
e
&
M
a
i
n
t
e
n
a
n
c
e
M
a
n
u
a
l
U
s
e
&
M
a
i
n
t
e
n
a
n
c
e
M
a
n
u
a
l
Before Install or use the product read to the precautions and
general recommendations inside.
1
6
0
3
7
2
1
6
0
2
E
N
3
Precautions and general recommendations
This appliance is intended to be used in household and similar
applications such. Appliance for internal use only. Place the
unit away from water jets.
Always connect the water cooler to a water main that supplies
drinking water only.
Before each installation, the unit must be sanitized by an
authorized technician.
After installation, ensure that the unit is not resting on the
power cable.
Check that the unit is level and that it is resting on a floor with
sufficient load-bearing capacity, in an environment that is suitable for its dimensions and its
use.
Before any maintenance or cleaning operation is carried out, remove the plug from the
socket or disconnect the power supply.
Ensure that the product is not sited close to sources of heat.
To guarantee adequate ventilation, leave at least 10 cm of space around the unit.
Install the product in a clean, dry, well-ventilated environment. The product is designed
to function in environments with a temperature range of between 5°C and 32°C - Climate
Class N.
Take care not to damage the cooling fluid circuit: it is filled with R290, which is a highly
flammable gas. It is essential to ensure that the tubes of the refrigerant circuit are not
damaged.
Ensure that it is possible to disconnect the power supply either by removing the plug or via
a two-pole circuit-breaker, with an opening distance of the contacts that allows complete
disconnection in the conditions of overvoltage category III, placed upstream of the plug.
Check that the voltage shown on the serial number plate corresponds to the voltage being
supplied at the installation site.
The unit must not be cleaned with a water jet. Do not position other electrical equipment in
the immediate vicinity of the water cooler.
Turn off the main water inlet tap if the unit is not to be used for a long period.
Keep the areas surrounding the unit dry to avoid the risk of people slipping.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified person in order to avoid a hazard. Do not use extension
leads or adapters.
This appliance is intended to be used by persons (including children aged from 8
years) with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, provided that they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance. The appliance is only to
be installed in locations where it can be overseen by trained personnel.
The Appliance shall be protected by a ground-fault circuit interrupter.
This equipment is to be installed in compliance with the local plumbing codes. Water
pipe connections and fixtures directly connected to a potable water supply shall be
sized, installed, and maintained in accordance with federal, state, and local codes.
This publication is based on information available when approved for printing. Continuing
design refinements could cause changes that may not be included in this publication.
4
Index
• BEFORE INSTALLING THE WATER COOLER 5
• RECOMMENDATIONS FOR SAFEGUARDING THE ENVIRONMENT 6
• CERTIFIED 7
• ASSOCIATIONS 8
• INTERNATIONAL AWARDS 8
• DESCRIPTION OF THE UNIT 9
• DESCRIPTION OF THE KEYPAD 15
• TECHNICAL FEATURES 16
• INSTALLATION 19
• HANDLING THE GAS CYLINDERS 25
• FILTRATION (OPTIONAL, MOD. WAVE HOT) 26
• SANITIZATION – NOTES 29
• ORDINARY MAINTENANCE 30
• SERVICE HISTORY 31
• WARRANTY CONDITIONS 32
5
Before installing the water cooler
Congratulations for choosing a BLUPURA product.
We have designed and manufactured this product with great care to ensure that
it will dispense water of the highest quality.
In order to get the most out of your water cooler, please read the instructions in
this manual and retain the manual for future reference.
6
Recommendations for safeguarding the environment
Packaging materials
The packaging materials are 100% recyclable.
Please follow the local guidelines on waste
disposal. For safety reasons keep the packaging
material out of the reach and sight of children.
Scrappage
The water cooler is made using recyclable material.
This unit is marked in compliance with European Directive 2012/19/UE
on Waste Electrical and Electronic Equipment (WEEE). By ensuring that
the product is scrapped correctly, you are helping to prevent potential
negative consequences for the environment and for health. The symbol
on the unit indicates that the product should not be treated as domestic waste
but should be taken to a dedicated recycling centre for electrical and electronic
equipment. Immediately prior to scrapping, cut off the power cable.
For more information on the treatment, recovery and recycling of this product,
please contact the appropriate local office, the waste disposal service or the
reseller from which the product was purchased.
Information on the natural, eco-friendly refrigerant gas used in
this cooler
This product contains no CFCs or HFCs, which contribute to global warming.
Indeed, it is the first water cooler on the market to use natural refrigerant.
The refrigerating system is filled with HC R290 – Propane: a natural gas that does
not contribute to global warming and that, thanks to its specific characteristics,
allows for substantial energy savings to be made.
7
Certified
See official list
Materials compliant for contact with drinking water
This unit is intended for the dispensing of drinking water, and so the materials
that enter into direct contact with water meet the criteria for food-grade
components pursuant to the current legislation. In addition, the unit is
manufactured in compliance with Italian Ministerial Decrees 174 of 06/04/2004
and 25 of 07/02/2012.
Electrical safety
This water cooler is designed, manufactured and marketed in compliance with:
• the safety objectives of the Machinery Directive 2006/42/CE;
• the protection requirements of the Electromagnetic Compatibility Directive
2014/30/EU.
The electrical safety of the product is ensured only when it is properly connected
to an efficient, legally compliant grounding circuit.
D.M. 174
1
0
0
%
M
A
D
E
I
N
I
T
A
L
Y
C
E
R
T
I
F
I
C
A
T
E
I
T
P
I
rosso032 c
UNI EN ISO 9001:2015
UNI EN ISO 14001:2015
ANSI/UL 399
8
Associations
International Awards
2015 - BEST PROMOTION OF HEALTH AND HYDRATION
EUROPEAN AQUA AWARDS 2015, ROME
2015 - BEST ENVIRONMENTAL PRACTICE/GREEN INITIATIVE
EUROPEAN AQUA AWARDS 2015, ROME
2014 - BEST PROMOTION OF HEALTH AND HYDRATION
EUROPEAN AQUA AWARDS 2014, BUDAPEST
2013 - BEST PRODUCT INNOVATION
EUROPEAN AQUA AWARDS 2013, BERLIN
2012 - BEST ENVIRONMENTALLY FRIENDLY PRACTICE
EUROPEAN AQUA AWARDS 2012, ISTANBUL
2011 - BEST PRODUCT DESIGN/INNOVATION
EUROPEAN AQUA AWARDS 2011, ODESSA
2010 - BEST ENVIRONMENTALLY FRIENDLY PRACTICE
EUROPEAN AQUA AWARD 2010, PRAGUE
9
Description of the unit
A new product designed with the highest level of quality, design and
technology. The main features of the unit are as follows:
• A modern design using natural materials
• Highly insulated ice-bank, for greater energy
saving
• Cooling serpentine coil, without water
stagnation, made with the best stainless steel for
drinkable water
• Professional 1 litre boiler in stainless steel AISI
304 for hot water.
• 3 supply options: cold water + cold sparkling
water + hot water
• Self-diagnosing system and alarm in case of lack of mains water, lack of CO2
in cylinder and water leakage.
• ENERGY SAVING control: when needed puts the machine into stand-by
mode with an energy saving of 75% of full operational energy.
• Body and internal parts made entirely from stainless steel.
• WAVE received third prize for “Best Product Design/Innovation” for 2010
from the European EBWA association.Il mod.
• Mod. Wave Box Hot can be can be fitted to any type of tap. Visit the
website www.blupura.com to view our product range.
10
Front View (mod. Wave Hot Box)
2
1
7
5
6
3
11
10 9
4
8
8
4
11
10
9
2 7
3
1 6
5
Power button Boiler power button
Adjustable boiler thermostat
Adjustable thermostat Drinking water inlet pipe joint
8mm
Boiler condensation drain hose
Ø8mm
CO2inlet pipe joint 8mm (only
mod. FIZZ)
Ice bank overflow
Sparkling water outlet pipe
8mm (only mod. FIZZ)
Room temperature water outlet
pipe 8mm
Sparkling water outlet pipe
8mm (only mod. FIZZ)
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels blupura Distributeur d'eau
