Blodgett 1415 Manuel du propriétaire
1415
ELECTRIC COMPACT DECK OVEN
INSTALLATION - OPERATION - MAINTENANCE
BLODGETT OVEN COMPANY
www.blodgett.com
44 Lakeside Avenue, Burlington, Vermont 05401 USA Telephone: (802) 658-6600 Fax: (802)864-0183
PN 23326 Rev J (6/13)
© 2013 - G.S. Blodgett Corporation
Your Service Agency’s Address:
Model
Serial number
Oven installed by
Installation checked by
TABLE OF CONTENTS
INSTALLATION
Oven Description and Specications ....................................... 2
Delivery and Location .................................................... 3
Electrical Connection ..................................................... 4
Oven Assembly .......................................................... 5
Packaging ........................................................... 5
Leg Attachment ...................................................... 5
Stand Assembly...................................................... 6
Double Stacking...................................................... 6
Deck Installation ..................................................... 7
Leveling the Oven .................................................... 7
OPERATION
Oven Control ............................................................ 8
MAINTENANCE
Cleaning and Preventative Maintenance ................................... 9
Troubleshooting Guide .................................................. 11
IMPORTANT
WARNING: Improper installa-
tion, adjustment, alternation,
service or maintenance can
cause property damage, in-
jury or death. Read the instl-
lation, operation and mainte-
nance instructions thoroughly
before installing or servicing
this equipment.
FOR YOUR SAFETY
Do not store or use gasoline or
other ammable vapors or liq-
uids in the vicinity of this or any
other appliance.
The information contained in this
manual is important for the prop-
er installation, use, and mainte-
nance of this oven. Adherence
to these procedures and instruc-
tions will result in satisfactory
baking results and long, trou-
ble free service. Please read
this manual carefully and retain
it for future reference.
ERRORS: Descriptive, typo-
graphic or pictorial errors are
subject to correction. Speci-
cations are subject to change
without notice.
2
Installation
Oven Description and Specications
ELECTRICAL RATINGS- 1415
VOLTAGE
KW/SECTION
PHASE
MAX LOAD (AMPS)
ELECTRICAL CONNECTION AWG*
L1 L2 L2
60 HZ
208 3.75 1 18 0 18 10
208 3.75 3 11 11 11 12
220-240 3.75 1 16 0 16 12
220-240 3.75 3 9 9 9 12
50 HZ
220 3.75 1 17 — 17 Size per local codes
240 3.75 1 16 — 16 Size per local codes
220/380 3.75 3 6 6 6 Size per local codes
240/415 3.75 3 6 6 6 Size per local codes
NOTE: Double units can have phase loads partially equalized by matching lines during hook-up. Otherwise, load ratings are
double the above data.
Blodgett Deck ovens have set industry wide standards of
excellence for baking characteristics, performance and
reliability. They remain unsurpassed for product quality.
Simplicity of design and quality construction throughout
assure years of trouble free service when the equipment
is properly installed and maintained.
Features include a full angle iron frame, all welded radius
corners and stainless steel exteriors.
3
Installation
Delivery and Location
DELIVERY AND INSPECTION
All Blodgett ovens are shipped in containers to prevent
damage. Upon delivery of your new oven:
• Inspect the shipping container for external damage.
Any evidence of damage should be noted on the
delivery receipt which must be signed by the driver.
• Uncrate the oven and check for internal damage.
Carriers will accept claims for concealed damage if
notied within fteen days of delivery and the ship-
ping container is retained for inspection.
The Blodgett Oven Company cannot assume responsibil-
ity for loss or damage suffered in transit. The carrier as-
sumed full responsibility for delivery in good order when
the shipment was accepted. We are, however, prepared
to assist you if ling a claim is necessary.
OVEN LOCATION
The well planned and proper placement of your oven will
result in long term operator convenience and satisfactory
performance.
Be sure to place the oven in an area which is accessible
for proper operation and servicing.
It is essential that ventilation air not be obstructed in any
way if proper operation is to be assured. A minimum of
two inches (5 cm) must be maintained between both the
sides and the rear of the unit and any wall.
4
Installation
Electrical Connection
Ovens are supplied for operation on 208 volt or 220-240
volt installation. The thermostat, indicator light and related
switches are interconnected through one power source
supplied to the oven.
Before making any connection to this oven, check the rat-
ing plate attached to the bodyback to assure that the volt-
age, phase and KW rating are compatible with the electri-
cal supply. See diagram.
All ovens, when installed, must be connected and electri-
cally grounded in accordance with local codes, or in the
absence of local codes, with the National Electrical Code,
ANSI/NFPA 70-Latest Edition and/or Canadian Electric
Code CSA C22.1 as applicable.
Wiring diagrams are located on the bodyback.
The supply conduit enters through the rear of the oven
and electrical connection is made to the terminal block
secured to the panel at the back of the control compart-
ment. Electrical connection sizes for a double 1400 oven
are shown in “Electrical Connection AWG” column of the
Electrical Specications found on page 2 of this manual.
Wiring is sized for 75_C copper wire at 125% of rated
input. Reference is from the National Electric Code ANSI/
NFPA 70- Latest Edition.
Wiring Label
Rating Plate
Wiring
Schematic
Installation Instructions
“Do not install closer than 2 inches to
any side or rear wall”
Figure 1
5
Installation
Oven Assembly
PACKAGING
Before assembly and installation of the oven, check that
all components have been received. In addition to the
oven, legs, decks and/or other accessories may be re-
quired.
Single Sections
• 4” (10 cm) legs are shipped inside the oven, packed
in a separate carton.
• The decks are individually packaged and secured to
the oven back.
Double Sections
• 4” (10 cm) legs are packed in lower sections.
• Spacer is shipped attached to the upper section.
• Securing plate to attach units together is located in
the upper section.
• The decks are packaged with each section.
LEG ATTACHMENT
1. Tip bottom oven section backward.
2. Attach each of the four legs into the nuts secured in
the oven bottom.
3. Tighten each leg and adjust the leg feet to approxi-
mately the same height.
NOTE: Final leg fet adjustment will be required dur-
ing the leveling operation.
Figure 2
6
Installation
Oven Assembly
STAND ASSEMBLY
1. Attach legs to stand frame. Secure with 5/16-18 nuts
and lockwashers (4 per leg). DO NOT TIGHTEN.
2. Place shelf on legs. Holes in legs should align with
holes in shelf corner brackets. Legs should be loose
enough to assist in this alignment. Place 1/4-20
x 2-1/4” bolts through legs and into shelf brackets.
Bolts should t radius of legs. Install 1/4-20 nuts after
all four corners are in place. Tighten four nuts. Do not
over tighten these nuts, deformity of leg surface can
occur.
3. Tighten the sixteen 5/16-18 nuts installed in Step 1.
DO NOT over tighten.
4. Optional Caster Assembly - Secure caster by tighten-
ing with a wrench. Prior to placing oven section on
stand, check that locking casters are on front of stand
assembly.
5. Center oven on stand assembly.
Figure 3
DOUBLE STACKING
1. Connect the spacer assembly to the bottom of th up-
per unit using 4 hex bolts.
2. Align and secure the spacer connecting plate to the
lower unit using 4 sheet metal screws.
NOTE: First remove the 4 sheet metal screws along
the top edge of the lower unit panel.
3. Stack the upper unit on top of the lower unit.
4. Align and secure the spacer connecting to the spacer
assembly using 4 sheet metal screws.
Figure 4
7
Installation
Oven Assembly
DECK INSTALLATION
1. Remove the decks from the carton package.
NOTE: Handle cordierite shelves carefully to avoid
damage.
2. Open the oven door and remove the center element
assembly. The assembly is removed by puling for-
ward and unplugging.
3. Install one of the decks in the bottom position. The
deck should rest on the angles above the element
and should be positioned in contact with the linerback.
4. Install the other deck in the center element assem-
bly on a at surface. Reinstall the center deck and
element assembly in the oven. The assembly is sup-
ported on four angle supports.
Bottom Deck
Center Element
Figure 5
LEVELING THE OVEN
1415 ovens are equipped with NSF listed adjustable sani-
tary legs.
1. Level the oven side to side and front to back by plac-
ing a spirit level on the base frame of the lower sec-
tion.
2. Adjust the leg feet in or out as necessary.
8
Operation
Oven Control
COMPONENT DESCRIPTION
1. POWER SWITCH - Controls the power to the oven.
2. DIGITAL DISPLAY - Displays the time, temperature
and controller related information.
3. DIAL - Turn to set the cook time and temperature.
4. START/STOP KEY - Press to start and stop the tim-
ing cycle.
5. TIME KEY - Press to enter the cook time.
6. TEMP KEY - Press to enter the cook temperature.
OPERATION
1. Toggle the POWER SWITCH (1) to OVEN ON.
2. Press the TEMP KEY (6) and turn the DIAL (3) to se-
lect the desired cook temperature.
3. When the display reads LOAD, press the TIME KEY
(5) and turn the DIAL (3) to select the desired cook
time.
4. Load product into the oven.
5. Press START/STOP KEY (4). The timer counts down
the set time. Upon completion of the set time, the
buzzer sounds and the display reads DONE.
6. Press the START/STOP KEY (4) to silence the buzz-
er.
7. To shut the oven off, toggle the POWER SWITCH (1)
to OFF.
OFF ON
HEAT
START
STOP TIME TEMP
1
2
3
4
5
6
Figure 6
Autres manuels pour 1415
4
Table des matières
Autres manuels Blodgett Four
Blodgett
Blodgett 1048 Manuel du propriétaire
Blodgett
Blodgett BCX-14G Manuel utilisateur
Blodgett
Blodgett BG3240 Manuel
Blodgett
Blodgett KFC CTBR-AP Manuel du propriétaire
Blodgett
Blodgett COS-8E Manuel utilisateur
Blodgett
Blodgett BE3240 Manuel du propriétaire
Blodgett
Blodgett XR8-G Manuel utilisateur
Blodgett
Blodgett HV-50 Instructions d'installation et d'utilisation
Blodgett
Blodgett CTB SERIES Manuel utilisateur
Blodgett
Blodgett MT3870 Manuel utilisateur
Blodgett
Blodgett BCX-14E Manuel utilisateur
Blodgett
Blodgett XR8-G Manuel utilisateur
Blodgett
Blodgett BG3240 Manuel utilisateur
Blodgett
Blodgett 901 Base Guide d'application
Blodgett
Blodgett 1405 Manuel du propriétaire
Blodgett
Blodgett MT3870 Manuel d'installation et d'exploitation
Blodgett
Blodgett ELECTRIC CONVEYOR OVEN MT1828E Manuel utilisateur
Blodgett
Blodgett BE2136 DOUBLE Manuel
Blodgett
Blodgett Mark V Manuel utilisateur
Blodgett
Blodgett COS-20E Manuel du propriétaire
