Black Box LB9019A-R3 Manuel utilisateur

Installation

This installation guide gives step-by-step instructions about how to install the Express Ethernet Switches:

LB9019A-R3

Selecting a Site for the Express Ethernet Switch: LB9019A-R3

As with any electric device, you should place the switch where it will not be subjected to extreme temperatures,

humidity, or electromagnetic interference. Specifically, the site you select should meet the following requirements:

- The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to 40 degrees Celsius).

- The relative humidity should be less than 90 percent, non-condensing.

- Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards for IEC 801-3,

Level 2 (3V/M) field strength.

- Make sure that the switch receives adequate ventilation. Do not block the ventilation holes on each side of the

switch or the fan exhaust port on the rear of the switch.

- The power outlet should be within 1.8 meters of the switch.

Connecting to Power

yConnect the supplied AC power cord to the receptacle on the back of the switch, and then plug it into

a standard AC outlet with a voltage range from 100 to 240 Vac.

Figure: Rear view of the switch

Connecting to Your Network

Cabling

yFirst, ensure the power of the switch and end devices are turned off.

<NOTE> Always ensure that the power is off before any installation.

yPrepare cable with corresponding connectors for each type of port in use.

yConsult Table 2 below for cabling requirements based on connectors and speed.

yConnect one end of the cable to the switch and the other end to a desired PC or workstation.

yOnce the connections between two end devices are made successfully, turn on the power and the

switch is operational.

Rece

tacle

Cable Length

The maximum distance of a node to a directly connected switch on a 100BASE-TX network is 100 meters with

Category 5 shielded twisted-pair (STP) cable or unshielded twisted-pair (UTP) cable. For a 10BASE-T network, it

may range up to 100 meters with Category 3, 4, or 5 STP/UTP cable.

The maximum segment distance between a node and a directly connected switch port on a 100BASE-FX network is

75 km using 10/125(or 9/125)µm single-mode fiber optic cable. It is capable of spanning at most 2 kilometers when

use of 62.5/125(or 50/125)µm multi-mode fiber-optic cable.

Table: Cable Specifications

Ethernet

Standards

Connector Port

Speed

Half/Full

Duplex

Cable Max.

Distance

10BASE-T RJ-45 10/20

Mbps

Cat. 3, 4 or 5

UTP/STP

100 m

100BASE-TX RJ-45 100/200

Mbps

Cat. 5

UTP/STP

100 m

CUSTOMER Order toll-free in the U.S. 24 hours, 7 A.M. Monday to midnight Friday: 877-877-BBOX

SUPPORT FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746

INFORMATION Mail order: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web Site: www.blackbox.com yE-mail: [email protected]

Autres manuels pour LB9019A-R3

Table des matières

Autres manuels Black Box Changer

Black Box

Black Box COS-2 Manuel utilisateur

Black Box

Black Box SW925A Manuel utilisateur

Black Box

Black Box Code Operated Switch-16 Manuel utilisateur

Black Box

Black Box ServSwitch 17S Manuel utilisateur

Black Box

Black Box ServSwitch DTX5000 Manuel utilisateur

Black Box

Black Box ICI104A Manuel utilisateur

Black Box

Black Box AVSW-HDMI4X4 Manuel utilisateur

Black Box

Black Box ServSwitch Wizard SW651A Manuel utilisateur

Black Box

Black Box ServSwitch KV5004MN-R2 Manuel utilisateur

Black Box

Black Box SWI080A-R3 Manuel utilisateur

Black Box

Black Box KV9104A Manuel utilisateur

Black Box

Black Box IC159A Manuel utilisateur

Black Box

Black Box ServSwitch SW4007A-USB-PLUS Manuel utilisateur

Black Box

Black Box IC1026A Manuel utilisateur

Black Box

Black Box SW111A Manuel utilisateur

Black Box

Black Box LGB1048A Manuel utilisateur

Black Box

Black Box SM025A-FFF Manuel utilisateur

Black Box

Black Box IC165A Manuel utilisateur

Black Box

Black Box KVT8CATUV Manuel utilisateur

Black Box

Black Box LPB5028A Manuel utilisateur

Black Box

Black Box LB8405A-R3-US Manuel utilisateur

Black Box

Black Box LGB2003A-R2 Manuel utilisateur

Black Box

Black Box KV1416A-R2 Manuel utilisateur

Black Box

Black Box KV9502A Manuel utilisateur

Manuels Changer populaires d'autres marques

URC

URC Total Control MFS-8 Manuel utilisateur

Azbil

Azbil HPQ-D11 Manuel utilisateur

Sony

Sony DFS-900M Manuel utilisateur

SICK

SICK i17S Manuel utilisateur

F&F

F&F SZR-277 Manuel utilisateur

Shure

Shure UAMS/BK Manuel utilisateur

Dräger

Dräger X-zone Switch Off Manuel utilisateur

Asco

Asco Joucomatic 349 Series Manuel utilisateur

BT Mini Hub Manuel utilisateur

D-Link

D-Link DES-1226G Manuel utilisateur

Johnson Controls

Johnson Controls FS80-C Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuel utilisateur

MicroNet

MicroNet SP1200A Manuel utilisateur

Ruijie

Ruijie RG-PF2920 Series Manuel d'installation et d'exploitation

Altinex

Altinex DA1914SX Manuel utilisateur

MiLAN

MiLAN MIL-SM2401M Manuel utilisateur

RJM

RJM MASTERMIND PBC/6X Manuel utilisateur

Atlas

Atlas MMK-KVM8 Manuel utilisateur