Black Box MT910A Manuel utilisateur

Connect to V.35,

RS-530, or 10BASE-T

terminal interface

types.

VT100™ control port

ith full DS0 mapping.

Nx56-/64-kbps

channel selection

ith speeds up to

1.544 Mbps.

Loaded ith

diagnostics.

Available as a card

for the Managed

MicroRACK.

1 CSU/DSUs terminate T1/FT1

circuits over a 4-wire RJ-48C

interface. They convert this

interface to .35, RS-530, or

10BASE-T, depending on model.

T1 CSU/DSUs are an excellent

choice for terminating leased

lines, Frame Relay backbones,

and Internet access. They support

Nx56/Nx64 kbps T1 framing as

well as D4/ESF framing options

and AMI/B8ZS/B7ZS line coding,

plus internal, external, and

network clocking.

Data rates, framing, and

coding options are programmed

by DIP switches or through the

consol port from a T100 terminal

or terminal emulator.

A full range of system and

diagnostic features make setup

simple. T1 CSU/DSUs respond to

central-office-initiated D4 loopup

and loopdown codes, ESF line

loop, and payload loop FDL

Terminate T1/FT1 and convert to V.35,

RS-530, or Ethernet.

KeyFeatures

T1CSU/DSUs

messages. They’re compatible

with three .52 (Bit Error Rate)

test patterns and both local and

remote Telco diagnostics.

T1 CSU/DSUs support

framed Nx56/64 kbps rates up to

1.536 Mbps and unstructured

rates to 1.544 Mbps.

The 10BASE-T model is

particularly suited for LAN-to-LAN

connection. MAC forwarding and

PPP/BCP built-in bridging

provides seamless connection

over the T1 link without the need

of routers. PPP/BCP also enables

you to extend a router’s serial

interface for connection to a

remote Ethernet LAN over the

T1 network.

T1 CSU/DSUs are available in

a choice of .35, RS-530, or

10BASE-T interfaces. Choose

from a standalone version or a

rackmount card which fits into our

Managed MicroRACK.

Managed MicroRACK

When space is at a premium,

choose the 16-Port Managed

MicroRACK system. It holds up to

16 cards and fits into only 2U of

rack space.

The MicroRACK accepts one

or two AC or DC power supplies in

any combination. Each power

supply is capable of providing

100% of your rack power

requirements. In the event of

failure, the other supply

immediately takes over and the

MicroRACK notifies you of the

power failure.

The network management

module enables you to configure,

control, and perform diagnostics

using SNMP or HTTP over a

10BASE-T Ethernet connection.

Black Box Corporation • 1000 Park Drive • Lawrence, PA 15055-1018 • Tech Support: 724-746-5500 • www.blackbox.com • e-mail: [email protected]

Black Box Corporation.

2/14/2002 #25955

T1 CSU/DSUs

Agency Compliance:

FCC: Part 15 class A and Part 68,

3N8USA-35977-DE-N;

UL: E127709

Clocking: Internal, external, or

network

Coding: AMI or B8ZS

Compliance: FCC Part 15, Class A

and Part 68; AT&T®62411,

TR54016; ANSI T1.403

Diagnostics: .52 511 BERT;

.54 local/remote loop: responds

to CO-initiated loop-up and loop-

down codes; ESF line-loop and

payload FDL messages;

Diagnostics patterns: 511, 2047,

QRSS

DS0 Start Position: Any position,

contiguous/ non-contiguous

mapping when configured via

T100 console

DTE Rates: Nx56/64 kbps

Framing Format: D4 or ESF

perating Temperature: 32 to 122°F

(0 to 50°C)

Humidity Tolerance: 5 to 90%,

noncondensing

Speed: Up to 1.544 Mbps

Interface: T1; plus .35, RS-530, or

10BASE-T

Connectors: All: (1) RJ-48C T1,

(1) DB9 console port;

MT910A-35, MT911C-35:

(1) M/34 F;

MT910A-530, MT911C-530:

(1) DB25 F;

MT910A-10BT, MT911C-10BT:

(1) RJ-45

Power: 100–240 AC

ConnecttwoEthernetLANsoverT1

T1 CSU/DSU

(MT910A-10BT)

T1 CSU/DSU

(MT910A-10BT)

T1 10BASE-T

Network

10BASE-T

Network

CAT5 Cable

(E N737A)

Specifications

Ordering Information

IT M COD

T1 CSU/DSUs

Standalone

.35...................................................................MT910A-35

RS-530 ...........................................................MT910A-530

10BASE-T ..................................................MT910A-10BT

Rackmount

.35 ...................................................................MT911C-35

RS-530............................................................MT911C-530

10BASE-T ..................................................MT911C-10BT

You may also need…

16-Port Managed MicroRACK...................................RM260

SNMP/HTTP Card ......................................RM261C-SNMP

Control Module .........................................................RM262C

AC Power Supply (90–260 AC) .............................PS466A

DC Power Supply (-48 DC) .............................PS466A-DC

Size: Standalone units:

1.5"H x 4.2"W x 5.8"D

(3.8 x 10.7 x 14.7 cm);

Rackmount cards:

3"H x 0.8"W x 7.8"D

(7.6 x 2 x 19.8 cm)

Weight:

Standalone units: 0.8 lb (0.4 kg);

Rackmount cards: 0.4 lb. (0.2 kg)

Managed MicroRACK

Connectors:

PS466A: (1) IEC-320, 3-pin alarm;

PS466A-DC: (3) screw terminals,

3-pin alarm

Power: Single or dual load sharing:

PS466A: 90–260 AC, 50 Hz;

PS466A-DC: -48 DC

Size: 3.5"H x 19"W x 7.3"D

(8.9 x 48.3 x 18.5 cm)

Weight: 6.8 lb. (3.1 kg)

CAT5 Cable

(E N737A)

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Black Box Matériel réseau

Black Box

Black Box MT190A Manuel utilisateur

Black Box

Black Box TL482A-R3 Manuel utilisateur

Black Box

Black Box VIDEO CCTV-A/V HUB Manuel utilisateur

Black Box

Black Box ACR2004A Manuel utilisateur

Black Box

Black Box Multi Quick Check RJ-11 Manuel utilisateur

Black Box

Black Box 525056 Mode d’emploi

Black Box

Black Box MT1500A Manuel utilisateur

Black Box

Black Box LrA502A-et-r5 Manuel utilisateur

Black Box

Black Box ME1240A-F Manuel utilisateur

Black Box

Black Box NTU-1 Manuel utilisateur

Black Box

Black Box IC111C Manuel utilisateur

Black Box

Black Box RADIAN 1000 Series Manuel utilisateur

Black Box

Black Box MX325A-HS Manuel utilisateur

Black Box

Black Box DT450A Manuel utilisateur

Black Box

Black Box JPM083A Manuel utilisateur

Black Box

Black Box G.SHDSL NTU LB510A Manuel utilisateur

Black Box

Black Box FT990A Manuel utilisateur

Black Box

Black Box ServSwitch KV754A Manuel utilisateur

Black Box

Black Box JPM806A-HD Manuel utilisateur

Black Box

Black Box Veri-NAC Manuel

Black Box

Black Box ACR2005A Manuel utilisateur

Black Box

Black Box LMX Series Manuel utilisateur

Black Box

Black Box LES1208A-R2 Manuel utilisateur

Black Box

Black Box SW1009A Manuel utilisateur

Manuels Matériel réseau populaires d'autres marques

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manuel utilisateur

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manuel utilisateur

Yudor

Yudor YDS-16 Manuel utilisateur

D-Link

D-Link ShareCenter DNS-320L Manuel utilisateur

Samsung

Samsung ES1642dc Instructions d'utilisation

Honeywell Home

Honeywell Home LTEM-PV Instructions de montage

evertz

evertz 7700 Series Manuel utilisateur

D-Link

D-Link ShareCenter DNS-343 Manuel utilisateur

Asante

Asante AsanteBridge 1012 Manuel utilisateur

FireBrick

FireBrick FB2700 Manuel utilisateur

Audiovox Electronics

Audiovox Electronics ARWH2T Manuel utilisateur

ADC

ADC DSX-1 Manuel

NetComm

NetComm NF2 Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 5620 Manuel utilisateur

Dell EMC

Dell EMC XC6420 Series Manuel utilisateur

Lanner

Lanner NCA-1020A Manuel utilisateur

Allied Telesis

Allied Telesis AT-TN121-A Manuel utilisateur

Arista

Arista CCA-ETM-Q12 Manuel utilisateur