Billion BiPAC 7402NXL Manuel utilisateur

BiPAC 7402NX(L)

802.11n 3G/ADSL2+

(VPN) Firewall Router

Quick Start Guide

Billion BiPAC 7402NX(L) 802.11n 3G/ADSL2+ (VPN) Firewall Router

- 1 -

Package Contents

BiPAC 7402NX(L) 802.11n 3G/ADSL2+ (VPN) Firewall Router

CD containing the on-line manual

RJ-11 ADSL/ telephone cable

Ethernet (CAT-5 LAN) cable

Three 2dbi detachable antennas

AC-DC power adapter (15V DC, 1.6A)

PS2-RS 232 console cable

This Quick Start Guide

Splitter/ Micro-filter (Optional)

Attention

Warning

PLEASE READ THE QUICK START GUIDE AND FOLLOW THE

STEPS CAREFULLY. THIS QUICK START GUIDE WILL HELP YOU

INSTALL THE DEVICE PROPERLY AND AVOID IMPROPER USAGE.

IF YOU NEED MORE INFORMATION ON THIS SOFTWARE

CONFIGURATION, PLEASE REFER TO THE USER’S MANUAL ON

CD-ROM.



Do not use the

router

in high humidity or high temperatures.

Do not use the same power source for the router as other

equipment.

Do not open or repair the case yourself. If the router is too hot, turn

off the power immediately and have it repaired at a qualified service

center.



Avoid using this

product

and all

accessor

ies

outdoors.



Place the router on a stable surface.

Only use the power adapter that comes with the package. Using a

different voltage rating power adaptor may damage the router.

- 2 -

Hardware Overview

The Front LEDs

The Rear Ports

Connect the

supplied power

adapter to this jack

Connect the supplied

RJ-11 cable to this port

when connecting to the

ADSL/telephone

network

Connect your compute

to a LAN port, using the

included Ethernet cable

Connect the

detachable antenna

Lit when connected to

an Ethernet device.

Green for 1000Mbps;

Orange for 100Mbps.

Without shining for

10Mbps.

Blinking when data is

Transmitted / Received

Lit green when IP connected

Flashes green when IP connected and

IP traffic is passing thru the device.

Lit red when device attempted to

become IP connected and failed

Lit when power is ON.

Lit red when POST

(Power On Self Test)

failure (not bootable) or

device malfunctions

Lit green when the wireless

connection is made.

Flashes when sending/receiving data.

Flashes regularly when WPS is active

Lit green when

successfully

connected to an

ADSL DSLAM

(“line sync”)

Press it to reset the

device or restore to

factory default

settings

Push WPS button to

trigger Wi-Fi Protected

Setup

BiPAC 7402NX(L) has 802.11n draft Wireless Access Point and Giga

Switch Support.

Power ON/

OFF switch

3G/ HSDPA USB

modem backup

for Internet

access

Lit

green when the

USB device is ready.

Flashes when

sending/ receiving

data.

Connect Conso

cable

Billion BiPAC 7402NX(L) 802.11n 3G/ADSL2+ (VPN) Firewall Router

- 3 -

Hardware Connection

Hardware Installation

1. Power Connection

Plug the supplied power adapter to the wall jack and the

other side to the router. Please

note that the plug type may differ according to different countries.

2. LAN Connection

Connect the supplied RJ-45 Ethernet cable to one of the Ethernet ports, and the other

side to the PC’s Ethernet interface.

- 4 -

3. USB Connection

The USB 2.0 port supports 3G/ HSDPA modem connectivity; users can even more

conveniently enter access with 3G service to eliminate the limitation of the wired network

and extends the last-mile service wirelessly. Incorporated the wired environment, the

solution applies the auto fail-over feature to provide various applications and ensure

always-on connectivity for SOHO users.

4. ADSL Connection

Connect the supplied RJ-11 phone cable to the router’s ADSL port, and the other side to

the phone jack on the wall.

Billion BiPAC 7402NX(L) 802.11n 3G/ADSL2+ (VPN) Firewall Router

- 5 -

5. Splitter/ Micro-filter Connection

Splitter / Micro-filter are important for ADSL installation. It helps high-

frequency

signals are directed to the ADSL modem, and low-

frequency signals are directed to

the telephone or other analog voice-channel device to prevent inter-

modulation

distortion and get good speed and stable ADSL sync rate.

a) Splitter connection

If the installation has only a single telephone and a single ADSL modem, then a

splitter can be employed.

b) Micro-filter connection

If the installation has several

telephones or other analog devices, then an internal

micro-filter can be employed at each analog device.

- 6 -

Setup Utility

After you complete the hardware installation, insert the CD-ROM to the CD-ROM drive to

perform Setup Utility for network configuration. The Setup Utility will auto-run. Follow the

step-by-step configuration wizard, the utility will guide you complete the basic network

configuration.

Troubleshooting

1. None of the LEDs are on when you turn on the router.

Check the connection between the adapter and the router. If the error persists, you may have

a hardware problem. In this case you should contact technical support.

2. You have forgotten your router login and/or password.

Try the default login and password, please refer to Chapter 3 of the user’s manual. If this fails,

you can restore your router to its factory settings by holding the Reset button on the back of

your router for 6 seconds or more.

3. Can’t ping any PCs on the LAN.

Check the Ethernet LEDs on the front panel. The LED should be on for a port that has a PC

connected. If it is off, check the cables between your router and the PC. Make sure you have

uninstalled any software firewall for troubleshooting. Verify that the IP address and the subnet

mask are consistent between the router and the workstations.

4. Frequent loss of ADSL linesync (disconnections).

Ensure that all other devices connected to the same telephone line as your router (e.g.

telephones, fax machines, analogue modems) have a line filter connected between them and

the wall socket (unless you are using a Central Splitter or Central Filter installed by a qualified

and licensed electrician), and ensure that all line filters are correctly installed and the right

way around. Missing line filters or line filters installed the wrong way around can cause

problems with your ADSL connection, including causing frequent disconnections. If you have

a back-to-base alarm system you should contact your security provider for a technician to

make any necessary changes.

Product Support and Contact Information

Most problems can be solved by referring to the Troubleshooting section in the User’s Manual.

If you cannot resolve the problem with the Troubleshooting chapter, please contact the dealer

where you purchased this product.

Contact Billion

WORLDWIDE

http://www.billion.com

Billion Product Registration

Billion is committed to before and after sales customer services. You will get the most out of your Billion's products

after registration. Please register online at www.billion.com/register to receive valuable services and support from

us.

7402NX

(L)

V10

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Billion Routeur réseau

Billion

Billion BiPAC 7401V(G)P R4 Manuel utilisateur

Billion

Billion BiPAC 5200N Manuel utilisateur

Billion

Billion BiPAC 7100SV Manuel utilisateur

Billion

Billion BiPAC 6300VNOZ Manuel utilisateur

Billion

Billion BiPAC 5100S Manuel utilisateur

Billion

Billion 810VGTX Manuel utilisateur

Billion

Billion myGuard 7500GL Manuel utilisateur

Billion

Billion BiPAC 2070 (P) Manuel utilisateur

Billion

Billion BiPAC 7100 Manuel utilisateur

Billion

Billion Bipac 74 Series Manuel utilisateur

Billion

Billion BiPAC 4700ZUL Manuel utilisateur

Billion

Billion BiPAC 8501 R3 Manuel utilisateur

Billion

Billion BiPAC 8800NL R2 Guide de configuration

Billion

Billion BiPAC 5210G RC Manuel utilisateur

Billion

Billion BiPAC 7402VGO Manuel utilisateur

Billion

Billion BiPAC 7402G Manuel utilisateur

Billion

Billion ADSL Modem / Router BIPAC-711C2 Manuel utilisateur

Billion

Billion BiPAC 7300 G Manuel utilisateur

Billion

Billion BiPAC 6300NXL Manuel utilisateur

Billion

Billion BiPAC 7401V(G)PX Manuel utilisateur

Billion

Billion 7560 Manuel utilisateur

Billion

Billion BiPAC 7300N Manuel utilisateur

Billion

Billion BiPAC 7402 Manuel utilisateur

Billion

Billion BiPAC 7300 RA Manuel utilisateur

Manuels Routeur réseau populaires d'autres marques

Allnet

Allnet ALL0333AU Manuel utilisateur

HomeSeer

HomeSeer HT-SEL Manuel utilisateur

Sercomm

Sercomm Genesis OC3505D Manuel utilisateur

TP-Link

TP-Link TD-8817 Manuel utilisateur

Motorola

Motorola MR1900 Manuel utilisateur

Digi

Digi IX14 Manuel utilisateur

Cisco

Cisco NCS 540 Manuel

XAVi

XAVi X8821e Manuel utilisateur

BEC

BEC 6200WZL Manuel utilisateur

MikroTik

MikroTik hAP ac3 Series Manuel utilisateur

Korenix

Korenix JetNet 5428G Series Manuel utilisateur

NETGEAR

NETGEAR FS526T - Switch Manuel utilisateur

Korenix

Korenix JetNet 5710G Series Manuel utilisateur

Automated Logic

Automated Logic ZN551 Manuel du propriétaire

Cisco

Cisco ASR 1000 Series Manuel de l'opérateur

EnGenius

EnGenius ESR-9710 Manuel utilisateur

Cisco

Cisco 805 Series Instructions d'utilisation et de sécurité

LevelOne

LevelOne FBR-1416 Manuel utilisateur