Billion BiGuard 2 Manuel utilisateur

BiGuard 10

iBusiness Security Gateway Small-Office

BiGuard 2

iBusiness Security Gateway Home-Office

User’s Manual

Version Release 3.00 (FW:1.03)

BiGuard 2/10 User’s Manual

(Updated December 1, 2005)

The contents of this publication may not be reproduced in whole or in part,

transcribed, stored, translated, or transmitted in any form or any means, without

the prior written consent of Billion Electric Corporation.

Disclaimer

Billion does not assume any liability arising out of the application of use of any

products or software described herein. Neither does it convey any license under its

patent rights nor the patent rights of others. Billion reserves the right to make

changes in any products described herein without notice. This publication is subject

to change without notice.

Trademarks

Mac OS is a registered trademark of Apple Computer, Inc.

Windows 98, Windows NT, Windows 2000, Windows Me and Windows XP are

registered trademarks of Microsoft Corporation.

Safety Warnings

Your BiGuard 2/10 is built for reliability and long service life. For your

safety, be sure to read and follow the following safety warnings.

•Read this installation guide thoroughly before attempting to set up your BiGuard

2/10.

•Your BiGuard 2/10 is a complex electronic device. DO NOT open or attempt to

repair it yourself. Opening or removing the covers can expose you to high

voltage and other risks. In the case of malfunction, turn off the power

immediately and have it repaired at a qualified service center. Contact your

vendor for details.

•Connect the power cord to the correct supply voltage.

•Carefully place connecting cables to avoid people from stepping or tripping on

them. DO NOT allow anything to rest on the power cord and DO NOT place the

power cord in an area where it can be stepped on.

•DO NOT use BiGuard 2/10 in environments with high humidity or high

temperatures.

•DO NOT use the same power source for BiGuard 2/10 as other equipment.

•DO NOT use your BiGuard 2/10 and any accessories outdoors.

•If you mount your BiGuard 2/10, make sure that no electrical, water or gas pipes

will be damaged during installation.

•DO NOT install or use your BiGuard 2/10 during a thunderstorm.

•DO NOT expose your BiGuard 2/10 to dampness, dust, or corrosive liquids.

•DO NOT use your BiGuard 2/10 near water.

•Be sure to connect the cables to the correct ports.

•DO NOT obstruct the ventilation slots on your BiGuard 2/10 or expose it to direct

sunlight or other heat sources. Excessive temperatures may damage your

device.

•DO NOT store anything on top of your BiGuard 2/10.

•Only connect suitable accessories to your BiGuard 2/10.

•Keep packaging out of the reach of children.

•If disposing of the device, please follow your local regulations for the safe

disposal of electronic products to protect the environment.

Table of Contents

Chapter 1: Introduction

1.1 Overview

1.2 Product Highlights

1.2.1 Virtual Private Network Support

1.2.2 Advanced Firewall Security

1.2.3 Intelligent Bandwidth Management

1.3 Package Contents

1.3.1 BiGuard 10

1.3.1.1 Front Panel

1.3.1.2 Rear Panel

1.3.1.3 Rack Mounting

1.3.1.4 Cabling

1.3.2 BiGuard 2

1.3.2.1 Front Panel

1.3.2.2 Rear Panel

1.3.2.3 Cabling

Chapter 2: Router Applications

2.1 Overview

2.2 Bandwidth Management with QoS

2.2.1 QoS Technology

2.2.2 QoS Policies for Different Applications

2.2.3 Guaranteed / Maximum Bandwidth

2.2.4 Policy Based Traffic Shaping

2.2.5 Priority Bandwidth Utilization

2.2.6 Management by IP or MAC address

2.2.7 DiffServ (DSCP Marking)

2.3 Virtual Private Networking

2.3.1 General VPN Setup

2.3.2 Concentrator

Chapter 3: Getting Started

3.1 Overview

3.2 Before You Begin

3.3 Connecting Your Router

3.4 Configuring PCs for TCP/IP Networking

3.4.1 Overview

3.4.2 Windows XP

3.4.2.1 Configuring

3.4.2.2 Verifying Settings

3.4.3 Windows 2000

3.4.3.1 Configuring

3.4.3.2 Verifying Settings

3.4.4 Windows 98 / ME

3.4.4.1 Installing Components

3.4.4.2 Configuring

3.4.4.3 Verifying Settings

3.5 Factory Default Settings

3.5.1 Username and Password

3.5.2 LAN and WAN Port Addresses

3.6 Information From Your ISP

3.6.1 Protocols

3.6.2 Configuration Information

3.7 Web Configuration Interface

Chapter 4: Router Configuration

4.1 Overview

4.2 Status

4.2.1 ARP Table

4.2.2 Routing Table

4.2.3 Session Table

4.2.4 DHCP Table

4.2.5 IPSec Status

4.2.6 PPTP Status

4.2.7 System Log

4.2.8 IPSec Log

4.3 Quick Start

4.3.1 DHCP

4.3.2 Static IP

4.3.3 PPPoE

4.3.4 PPTP

4.3.5 Big Pond

4.4 Configuration

4.4.1 LAN

4.4.1.1 Ethernet

4.4.1.2 DHCP Server

4.4.2 WAN

4.4.2.1 DHCP

4.4.2.2 Static IP

4.4.2.3 PPPoE

4.4.2.4 PPTP

4.4.2.5 Big Pond

4.4.3 Bandwidth Settings

4.4.4 System

4.4.4.1 Time Zone

4.4.4.2 Remote Access

4.4.4.3 Firmware Upgrade

4.4.4.4 Backup / Restore

4.4.4.5 Restart

4.4.4.6 Password

4.4.4.7 System Log Server

4.4.4.8 E-mail Alert

4.4.5 Firewall

4.4.5.1 Packet Filter

4.4.5.2 URL Filter

4.4.5.3 LAN MAC Filter

4.4.5.4 Block WAN Request

4.4.5.5 Intrusion Detection

4.4.6 VPN

4.4.6.1 IPSec

4.4.6.1.1 IPSec Wizard

4.4.6.1.2 IPSec Policy

4.4.6.2 PPTP

4.4.7 QoS

4.4.8 Virtual Server

4.4.8.1 DMZ

4.4.8.2 Port Forwarding

4.4.9 Advanced

4.4.9.1 Static Route

4.4.9.2 Dynamic DNS

4.4.9.3 Device Management

4.5 Save Configuration To Flash

4.6 Logout

Chapter 5: Troubleshooting

5.1 Basic Functionality

5.1.1 Router Won’t Turn On

5.1.2 LEDs Never Turn Off

5.1.3 LAN or Internet Port Not On

5.1.4 Forgot My Password

5.2 LAN Interface

5.2.1 Can’t Access BiGuard 2/10 from the LAN

5.2.2 Can’t Ping Any PC on the LAN

5.2.3 Can’t Access Web Configuration Interface

5.2.3.1 Pop-up Windows

5.2.3.2 Javascripts

5.2.3.3 Java Permissions

5.3 WAN Interface

5.3.1 Can’t Get WAN IP Address from the ISP

5.4 ISP Connection

5.5 Problems with Date and Time

5.6 Restoring Factory Defaults

Appendix A: Product Specifications

A.1 BiGuard 10 Product Specifications

A.2 BiGuard 2 Product Specifications

Appendix B: Customer Support

Appendix C: FCC Interference Statement

Appendix D: Network, Routing, and Firewall Basics

D.1 Network Basics

D.1.1 IP Addresses

D.1.1.1 Netmask

D.1.1.2 Subnet Addressing

D.1.1.3 Private IP Addresses

D.1.2 Network Address Translation (NAT)

D.1.3 Dynamic Host Configuration Protocol (DHCP)

D.2 Router Basics

D.2.1 What is a Router?

D.2.2 Why use a Router?

D.2.3 Routing Information Protocol (RIP)

D.3 Firewall Basics

D.3.1 What is a Firewall?

D.3.1.1 Stateful Packet Inspection

D.3.1.2 Denial of Service (DoS) Attack

D.3.2 Why Use a Firewall?

Appendix E: Virtual Private Networking

E.1 What is a VPN?

E.1.1 VPN Applications

E.2 What is IPSec?

E.2.1 IPSec Security Components

E.2.1.1 Authentication Header (AH)

E.2.1.2 Encapsulating Security Payload (ESP)

E.2.1.3 Security Associations (SA)

E.2.2 IPSec Modes

E.2.3 Tunnel Mode AH

E.2.4 Tunnel Mode ESP

E.2.5 Internet Key Exchange (IKE)

Appendix F: IPSec Logs and Events

F.1 IPSec Log Event Categories

F.2 IPSec Log Event Table

Appendix G: Bandwidth Management with QoS

G.1 Overview

G.2 What is Quality of Service?

G.3 How Does QoS Work?

G.4 Who Needs QoS?

G.4.1 Home Users

G.4.2 Office Users

Appendix H: Router Setup Examples

H.1 VPN Configuration

H.1.1 LAN to LAN

H.1.2 Host to LAN

H.2 VPN Concentrator

H.3 Intrusion Detection

H.4 PPTP Remote Access by Windows XP

H.5 PPTP Remote Access by BiGuard

Chapter 1: Introduction

1.1 Overview

Congratulations on purchasing BiGuard 2/10 Router from Billion. Combining a

router with an Ethernet network switch, BiGuard 2/10 is a state-of-the-art device

that provides everything you need to get your network connected to the Internet

over your Cable or DSL connection quickly and easily. The Quick Start Wizard and

DHCP Server will get first-time users up and running with minimal fuss and

configuration, while sophisticated Quality of Service (QoS) and traffic management

features grant advanced users total control over their network and Internet

connection.

This manual illustrates the many features and functions of BiGuard 2/10, and even

takes you through the various ways you can apply this versatile device to your home

or office. Take the time now to familiarize yourself with BiGuard 2/10.

1.2 Product Highlights

1.2.1 Virtual Private Network Support

BiGuard 2/10 supports comprehensive IPSec VPN protocols for businesses to

establish private encrypted tunnels over the Internet to ensure data transmission

security among multiple sites, such as a branch office or dial-up connection. Up to 2

simultaneous IPSec VPN connections are possible on BiGuard 2/10, with

performance of up to 4Mbps.

1.2.2 Advanced Firewall Security

Aside from intelligent broadband sharing, BiGuard 2/10 offers integrated firewall

protection with advanced features to secure your network from outside attacks.

Stateful Packet Inspection (SPI) determines if a data packet is permitted to enter

the private LAN. Denial of Service (DoS) prevents hackers from interrupting

network services via malicious attacks. In addition, BiGuard 2/10 firewall can be

configured to alert you via email should your network come under fire, offering both

tight network security and peace of mind.

Autres manuels pour BiGuard 2

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Billion Porte

Billion

Billion BiGuard 50G Manuel utilisateur

Billion

Billion BiGuard S10 Manuel utilisateur

Billion

Billion BiGuard 2 Manuel utilisateur

Billion

Billion BiGuard S10 Mode d’emploi

Billion

Billion SG6300NZL Manuel utilisateur

Billion

Billion BiGuard S10 Manuel utilisateur

Billion

Billion BiGuard 50G Manuel utilisateur

Billion

Billion BiGuard S3000 Manuel utilisateur

Billion

Billion BiGuard 30 Manuel utilisateur

Billion

Billion Bipac 9800 VNX Manuel utilisateur

Billion

Billion BiGuard 10 Manuel utilisateur

Billion

Billion BiGuard 30 Manuel utilisateur

Billion

Billion BiGuard 50G Manuel utilisateur

Billion

Billion BiGuard 50G Manuel d'installation et d'exploitation

Billion

Billion BiGuard 30 Manuel utilisateur

Billion

Billion BiGuard 10 Manuel utilisateur

Billion

Billion BiGuard 50G Manuel utilisateur

Billion

Billion BiGuard S5 Manuel utilisateur

Billion

Billion BiGuard S100N Manuel utilisateur

Billion

Billion BiGuard 10 Manuel utilisateur

Billion

Billion BiGuard S10 Manuel utilisateur

Billion

Billion BiGuard 10 Manuel utilisateur

Billion

Billion BiGuard 2 Manuel utilisateur

Billion

Billion BiGuard 30 Manuel utilisateur

Manuels Porte populaires d'autres marques

LST

LST M500RFE-AS Manuel utilisateur

Kinnex

Kinnex Media Gateway Manuel utilisateur

2N Telekomunikace

2N Telekomunikace 2N StarGate Manuel utilisateur

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Manuel utilisateur

Telsey

Telsey CPVA 500 - SIP Manuel utilisateur

RTA

RTA 460A-NNA4 Fiche technique

Shaw

Shaw Gateway HDPVR Manuel utilisateur

ABB

ABB VSN900 Guide de démarrage rapide

Commander

Commander Pulse Manuel utilisateur

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Manuel utilisateur

NETGEAR

NETGEAR C6300BD Manuel utilisateur

Amit

Amit CDW531AM Manuel utilisateur

HMS

HMS Netbiter EasyConnect EC150 Manuel utilisateur

Huawei

Huawei EchoLife HG620 Manuel utilisateur

AT&T

AT&T U-verse 3801 Manuel d'utilisation et d'entretien

Logic IO

Logic IO RTCU MX2 turbo Manuel utilisateur

Suttle

Suttle MediaMAX MXM-521 Manuel utilisateur