5
3.3 Operating instructions
• The electronic constant control maintains the speed nearly constant during idling and work under load and assures a
uniform result.
• The machine is equipped with an electronic control and integrated overload protection.
to run for a short time without load.
4.1 Preventive maintenance
frequent blowing out of the ventilation slots and protection by a fault current protection switch are advised.
4.1.1 Changing the sacricial adapter
should also be undamaged and retain its original length. The adapter spacer and/or adapter pin may get damaged
deeper in the spacer. This removes the spacer from the spindle (B).
• Remove the damaged spacer when it has become free. Unscrew the
shoulder. Use a rubber mallet if necessary.
the spindle.
• Retighten the hex screw on the side of the spacer.
4.2 Repair
If despite strict observance of the manufacturing and testing method
connecting line must be installed by the manufacturer or its agent if safety risks are to be eliminated.
4.3 Warranty
Beveltools machines have been manufactured to quality standards and carefully inspected before shipment. The
description of the problem. If inspection shows an original defect in material or workmanship Beveltools will repair or
replace the tool without charge during the warranty period.
for purposes for which it is not intended and/or if the service and maintenance instructions not being observed by
Beveltools reserves the right to make changes or improvements to its products. Beveltools is not obligated to make
any corresponding changes or improvements in products previously manufactured or sold.
i
!
i
EN
i
h
