
GB Switching module RC-SM-4
22.09.2020 BEIER-Electronic 3
Introduction
With the switching module RC-SM-4, lights and other loads (e.g. motors, pumps,
relays) can e switched directly via a channel of an RC remote control.
There are 4 outputs availa le on the switch module, which can e loaded with a
current of up to 4 A. However, the total current of all outputs must not exceed 10 A.
The states of the 4 outputs are indicated y colored LEDs. It is easy to see which of
the 4 outputs are currently switched on.
Output 1 green
Output 2 red
Output 3 lue
Output 4 yellow
The RC-SM-4 has 15 different switching modes that can e selected via setup:
Mode Function Control element
1 4-way memory short / long Switch
2 2-way memory short / 2-way momentary long Switch
3 4-way memory via areas A, B, C, D proportional
4 4-way momentary via areas A, B, C, D proportional
5 4-way memory via counting (EKMFA - A) Switch
6 4-way memory via counting (EKMFA - D) Switch
7 Pulse when moving proportional
8 4-way light switch single (step switch) Switch
9 4-way light switch com ined Switch
10 Indicator (steering), hazard warning lights, light
1+2
proportional (steering)
11 Indicator (memory), hazard warning lights, light
1+2
Switch
12 Indicator (automatic shutdown), hazard
warning lights, light 1+2
Switch
13 Indicator (memory), light 1, light 2 Switch
14 Brake light, light, reversing light proportional (throttle)
15 Flasher running light Switch
When the RC-SM-4 is delivered, mode 1 is set.
For modes no. 3, 4, 7, 10 and 14, a proportional control (stick, slide control, rotary
control) is required at the radio, since the RC-SM-4 has to evaluate proportional
(stepless) signals here.
In all other modes, a 3-position switch on the radio is sufficient to control the outputs.
However, proportional controller can also e used here.