Beghelli Protegga Manuel utilisateur

INSTRUCTIONS

INSTALLATION

SINGLE FACE:

1. Remove all screws on the front cover / faceplate and then remove the cover.

2. Mount the exit securely in place using the appropriate end ceiling or wall mounting diagram.

3. Use a rated watertight conduit hub(s) to connect the conduit to the enclosure.

4. Pass power wires through the connector.

5. Connect supply per diagram provided. Insulate unused wire!

CAUTION! Failure to insulate unused wire may result in a shock hazard or unsafe condition as well as equipment

failure.

6. Route wires and secure them in place.

7. Replace the cover and tighten the screws.

8. Turn on the AC voltage supply.

DOUBLE FACE:

1. Double face exits are shipped with a weatherproof ceiling or end mount canopy already installed (in either the top or

end configuration), as specified when ordered.

2. Loosen the screws on the front cover / faceplate and then remove the faceplate. The other faceplate is attached from

the inside with screws recessed behind the front ones.

3. Unscrew the remaining metal screws holding the rear faceplate to the housing.

4. Route wires and secure them in place.

5. Connect supply per diagram provided. Insulate unused wire!

CAUTION! Failure to insulate unused wire may result in a shock hazard or unsafe condition as well as equipment

failure.

6. Secure the weatherproof canopy (and connected exit frame) in place – supplied mounting holes fit most standard

electrical boxes. Make sure that the canopy gasket is aligned in place between the canopy and the surface you are

mounting to.

7. Re-install the exit faceplates starting with the rear faceplate by following steps 2 and 3 in reverse.

8. Turn on the AC line voltage supply and the exit should light up.

SELF-POWERED:

1. For models PTG-SP, plug the battery into the circuit board per (Figure 3) self-powered sign.

Protegga (PTG)

926000122

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed including the following:

1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS

2. Disconnect power before performing work on electrical equipment.

3. Use caution when servicing batteries.

4. Equipment should be mounted in locations and at heights where unauthorized personnel will not readily subject it to

tampering.

5. The use of accessory equipment not recommended by Beluce Canada Inc., may cause an unsafe condition, and

will void the unit’s warranty.

6. Do not use this equipment for other than its intended purpose.

7. Servicing of this equipment should be performed by qualified service personnel.

8. SAVE THESE INSTRUCTIONS!

Beluce Canada Inc., 3900 14th Avenue, Markham, ON L3R 4R3 Tel: (905) 948-9500 Fax: (905) 948-8673

06/09/2019

MAINTENANCE

1. The equipment is to be repaired whenever the equipment fails to operate as intended during the duration test.

Written records of test results and any repairs made must be maintained. Beluce Canada Inc. strongly recommends

compliance with all Code requirements.

2. The lamps listed herein when used according to the instructions with this unit are in accordance with the

requirements of CSA Standard C22.2, No. 141 – Unit Equipment for Emergency Lighting.

3. Clean exit face(s) on a regular basis.

NOTE: The servicing of any parts should be performed by qualified service personnel only. The use of replacement

parts not furnished by Beluce Canada Inc., may cause equipment failure and will void the warranty.

TROUBLESHOOTING

LEDS DO NOT COME ON AT ALL

1. Check AC supply be sure unit has 24 hour AC supply (unswitched).

The AC supply must be at least 80% of nominal (96V on a 120V line) for equipment to function normally.

At lower voltages the LED lamps will begin to glow dimly until the source voltage drops below the full “turn on” point.

NOTE: This condition may also be caused by incorrectly connecting an AC Volt supply line to the lead.

2. Check all AC connections

3. AC supply is OK, replace LED Board Assembly.

SAVE THESE INSTRUCTIONS

Chassis GND LED Board

AC ONLY SIGN

Chassis GND

GREEN Ground

BLACK 120VAC

RED 347VAC or ORANGE 200-277VAC

WHITE Neutral

LED Board

AC & UNIVERSAL DC SIGN

YELLOW Positive 6 to 24VDC

PURPLE Negative

Emergency Supply

FROM Battery Pack

SELF-POWERED SIGN

Chassis GND

24 hours

Unswitched Supply

GREEN Ground

BLACK 105 to 360VAC

WHITE Neutral

LED Board

DUAL UNIVERSAL AC SIGN

From Generator OR

Emergency Supply

BROWN 105 to 360VAC

BLUE Neutral

NOTE: Cap unused AC Wire!

24 hours

Unswitched Supply

GREEN Ground

BLACK 120VAC

RED 347VAC or ORANGE 200-277VAC

WHITE Neutral

24 hours

Unswitched Supply

Chassis GND LED Board

NOTE: Cap unused AC Wire!

GREEN Ground

BLACK 120VAC

RED 347VAC or ORANGE 200-277VAC

WHITE Neutral

24 hours

Unswitched Supply

Ni-Cd

Battery

Ceiling/End Mount Wall Mount

926000122

Figure 1

Figure 3

Figure 2

Beluce Canada Inc., 3900 14th Avenue, Markham, ON L3R 4R3 Tel: (905) 948-9500 Fax: (905) 948-8673

06/09/2019

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Beghelli Équipement d'éclairage

Beghelli

Beghelli GDE-SP Manuel utilisateur

Beghelli

Beghelli TEMPESTA PLUS HT Manuel utilisateur

Beghelli

Beghelli OTTICA B6L Manuel utilisateur

Beghelli

Beghelli PACO-T20 Manuel utilisateur

Beghelli

Beghelli Lyra W LED Manuel utilisateur

Beghelli

Beghelli PRATICA MODULA AT Manuel utilisateur

Beghelli

Beghelli Tempesta Manuel utilisateur

Beghelli

Beghelli DECO LED Manuel utilisateur

Beghelli

Beghelli Cyclone Manuel utilisateur

Beghelli

Beghelli Cyclone Manuel utilisateur

Beghelli

Beghelli ATX-RE Manuel utilisateur

Beghelli

Beghelli Maxima Manuel utilisateur

Beghelli

Beghelli Salvalavista LED Manuel utilisateur

Beghelli

Beghelli Tempesta LED ECO Manuel utilisateur

Beghelli

Beghelli Tempesta Manuel utilisateur

Beghelli

Beghelli MEZZO Manuel utilisateur

Beghelli

Beghelli MPL Series Manuel utilisateur

Beghelli

Beghelli Pluraluce Mini Manuel utilisateur

Beghelli

Beghelli METRica LED L LG 230 Manuel utilisateur

Beghelli

Beghelli IP65 Manuel utilisateur

Beghelli

Beghelli IP42 Manuel utilisateur

Beghelli

Beghelli Sicura Unit Manuel utilisateur

Beghelli

Beghelli SR Manuel utilisateur

Beghelli

Beghelli Stella Exit Manuel utilisateur

Manuels Équipement d'éclairage populaires d'autres marques

Brizo

Brizo 8SP-MU-4 Manuel utilisateur

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuel utilisateur

IKEA

IKEA BJÖRKSPIREA Manuel utilisateur

Laserworld

Laserworld Evolution Series ES-400RGB Manuel utilisateur

Alien

Alien RG STAR Manuel utilisateur

EuroLite

EuroLite LED B-40 Manuel utilisateur

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuel utilisateur

Commercial Electric

Commercial Electric 54568141 Manuel utilisateur

CREE LIGHTING

CREE LIGHTING 304 Series Manuel utilisateur

Goobay

Goobay 49867 Manuel utilisateur

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuel utilisateur

Alkalite

Alkalite Krypton KT-81 Manuel utilisateur

Clas Ohlson

Clas Ohlson GU10 Manuel utilisateur

DTS

DTS DELTA 10 F Manuel utilisateur

ring

ring Solar Steplight Manuel utilisateur

One Stop Gardens

One Stop Gardens 57696 Instructions de montage

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuel utilisateur

SIREM

SIREM Swimeo A2 Manuel utilisateur