Beghelli MEZZO Manuel utilisateur

MEZZO

AUTOTEST

Page 1 of 2

Beghelli U.S.A., 3810 Executive Way, Miramar, Florida, Tel: (954) 442-6600

07/01/2 2

When using electrical equipment, basic safety precautions should always be followed including:

1. Disconnect power before performing work on electrical equipment.

2. Do not mount near gas or electric heaters.

3. Equipment should be mounted in locations and at heights where it will not be subjected to

tampering.

4. The use of accessory equipment not recommended by Beghelli Inc., may cause an unsafe

condition, and will void the unit’s warranty.

5. Do not use this equipment for other than its intended purpose.

6. Servicing of this equipment should be performed by a qualified service personnel.

7. Allow battery to charge for 24 hours before first use.

8. Important: To weather-proof your fixture, be sure to seal all holes in housing (mounting, con-

duit, plugs, etc.) with silicone sealant. Apply sealant across the top edge to prevent water from

reaching the back of the housing.

9. DO NOT install in unstable, loose or breakable surfaces.

10. DO NOT let objects impact or exert force on the surface of the fixture.

SAVE THESE INSTRUCTIONS!

IMPORTANT SAFEGUARDS

Read & Follow All Safety Instructions

INSTALLATION INSTRUCTIONS

MEZZO

AUTOTEST

Page 2 of 2

Beghelli U.S.A., 3810 Executive Way, Miramar, Florida, Tel: (954) 442-6600

07/01/2 2

INSTRUCTIONS

INSTRUCTIONS FOR AUTOTEST:

Once the unit is properly installed according to the installation instruction sheet and AC power supplied, the dual color LED indicator will come

ON and the Autotest function will automatically initiate. The LED indicates the unit’s status. A STEADY GREEN LED indicates normal service;

FLASHING GREEN indicates the unit is testing; GREEN/RED FLASHING indicates the battery is charging; RED (in different combinations) would

indicate a service alert. Refer to the Service Indication chart below for more details. The LED would be OFF with the unit is in emergency mode.

AUTOTEST SERVICE

The Autotest function is factory preset and performs the following:

a. Monitoring of battery, battery charger and lamps.

b. Self-testing and a 30-second or longer discharge once every 30 days, after the AC power has been supplied for a minimun of 24 hours.

c. Self-testing and a 30-second or longer discharge once every 180 days, after the AC power has been supplied for a minimun of 24 hours.

d. Self-testing and a 90-second discharge once every 365 days, after the AC power has been supplied for a minimun of 24 hours.

LED Indicator Status

One Flash Red Replace Electronics

Two Flash Red Replace Battery

Four Flash Red Replace Lamp Head Board

Steady Red Battery Disconnected

Sold Green Trickle Charge

Flashing Green In Test

Red/Green Flashing High Charge

SERVICE INDICATION

Action Reaction & LED Indication

Press test button once (within 2 seconds) 30-second test: FLASHING GREEN

Press test button twice (within 2 seconds) 30-minute test: GREEN FLASHING TWICE

Press test button 3 times (within 2 seconds) 90-minute test: GREEN FLASHING THREE TIMES

Press test button and

hold for 3 seconds. (in test mode) Cancels test. If Autotest is cancelled, it is recommended that a manual test of the same

duration be performed at a more convenient time to ensure compliance.

Press test button and

hold for 6 seconds. (in test mode) System reset.

MANUAL TESTING

The unit also provides for manual testing by pushing the test button in a specific pattern.

WARNING:

a) Make sure that power is OFF before making any electrical connections.

b) Unused wires must be capped using enclosed wire nuts.

Table des matières

Autres manuels Beghelli Équipement d'éclairage

Beghelli

Beghelli Nova Eco Manuel utilisateur

Beghelli

Beghelli LUMINI Manuel utilisateur

Beghelli

Beghelli PACO-T20 Manuel utilisateur

Beghelli

Beghelli Sicura Unit Manuel utilisateur

Beghelli

Beghelli STELLA EXIT Manuel utilisateur

Beghelli

Beghelli Bravado Unit Manuel utilisateur

Beghelli

Beghelli Protegga Manuel utilisateur

Beghelli

Beghelli STELLA B6L COMBO Manuel utilisateur

Beghelli

Beghelli Tempesta Manuel utilisateur

Beghelli

Beghelli MPL Series Manuel utilisateur

Beghelli

Beghelli Formula 65 LED Manuel utilisateur

Beghelli

Beghelli METRica LED L LG 230 Manuel utilisateur

Beghelli

Beghelli IP42 Manuel utilisateur

Beghelli

Beghelli Sicura Manuel utilisateur

Beghelli

Beghelli Pluraluce Mini Manuel utilisateur

Beghelli

Beghelli Esco Unit Manuel utilisateur

Beghelli

Beghelli BBX-SE Manuel utilisateur

Beghelli

Beghelli WLX Manuel utilisateur

Beghelli

Beghelli Cyclone Manuel utilisateur

Beghelli

Beghelli Tempesta TA-RMT-LED Manuel utilisateur

Beghelli

Beghelli SR Manuel utilisateur

Beghelli

Beghelli Salvalavista LED Manuel utilisateur

Beghelli

Beghelli Tempesta Manuel utilisateur

Beghelli

Beghelli LOGICA LED LG FM Manuel utilisateur

Manuels Équipement d'éclairage populaires d'autres marques

Brizo

Brizo 8SP-MU-4 Manuel utilisateur

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuel utilisateur

IKEA

IKEA BJÖRKSPIREA Manuel utilisateur

Laserworld

Laserworld Evolution Series ES-400RGB Manuel utilisateur

Alien

Alien RG STAR Manuel utilisateur

EuroLite

EuroLite LED B-40 Manuel utilisateur

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuel utilisateur

Commercial Electric

Commercial Electric 54568141 Manuel utilisateur

CREE LIGHTING

CREE LIGHTING 304 Series Manuel utilisateur

Goobay

Goobay 49867 Manuel utilisateur

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuel utilisateur

Alkalite

Alkalite Krypton KT-81 Manuel utilisateur

Clas Ohlson

Clas Ohlson GU10 Manuel utilisateur

DTS

DTS DELTA 10 F Manuel utilisateur

ring

ring Solar Steplight Manuel utilisateur

One Stop Gardens

One Stop Gardens 57696 Instructions de montage

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuel utilisateur

SIREM

SIREM Swimeo A2 Manuel utilisateur