Barco R9840100 Manuel utilisateur

BARCO PROJECTION SYSTEMS

Date: 06.12.2000

INSTALLATION MANUAL

LENS QFD(4.5-6:1) FOR 6000 SERIES

R9840100

Art. No.: R5976095Rev : 2

QFD(4.5-6:1)

Kit

Lens with motorization mounted on the lens holder

Lens with motorization mounted on the lens support

BARCO  1  Projection Systems

QFD(4.5-6:1) Lens (Motorization excluded) R9840100

What has to be

done

The lens, without motorization on the body, has to be installed on a 6000 series projec-

tor with provided motorization unit on the lens support itself.

Necessary Tools no tool necessary

Motor unit

rotating

Torotate the motorization unit, follow the next procedure:

31&2

Take the lens out of its packing material.

Remove the lens cover on the projector by pulling it

upwards.

Loosen the wing nuts (A) on the motorization unit and put it

uprightly (secure the vertical position with one wing nut).

Step Action Image

Warning ! Risk of personal injury. Instructions for lens installation must be followed thoroughly.

To be continued on next page.

Illustration

Image 1

Image 2

BARCO  2  Projection Systems

QFD(4.5-6:1) Lens (Motorization excluded) R9840100

Installing the

Lens

To install the lens, follow the next procedure or look into the owners manual :

1&2

Flip the top of the lens locks (A) backwards over the lock

pin (B).

Rotate the lens locks towards you to open.

Place the lens unit in the projetor in a way the lens holder

fits the lens support.

Secure the position of the lens unit by closing both lens

locks (A) until the top of the lens locks flip over the lock pin

(B).

Loosen the wing nut (C) of the motorization unit and push

the unit against the lens ensuring a correct gear transmis-

sion.

Secure the posiotion of the motorization unit by tightning

both wing nuts.

Step Action Image

Warning ! Risk of personal injury. Instructions for lens installation must be followed thoroughly.

Illustrations

Image 1

Image 2

BARCO  3  Projection Systems

QFD(4.5-6:1) Lens (Motorization included) R9840100

What has to be

done

Installation of the lens on the lens support of the 6000 series projector. For older

projectors with motorization onto the lens support, the motorization unit has to be

removed.

Necessary Tools Flat screwdriver of 8mm

To be continued on next page.

Removing the

motorization unit

Toremove the motorization unit, follow the next procedure:

Disconnect the motorization cable connector (B) from

connector unit on lens support.

Remove on both sides of the motorization unit the fixation

screws (A).

Remove the motorization unit.

Step

Action

Image

Image 1

Image 2

Illustrations

BARCO  4  Projection Systems

QFD(4.5-6:1) Lens (Motorization included) R9840100

Installing the

Lens

To install the lens, follow the next procedure or look into the owners manual :

1&2

Flip the top of the lens locks (A) backwards over the lock

pin (B).

Rotate the lens locks towards you to open.

Place the lens unit in the projetor in a way the lens holder

fits the lens support.

Secure the position of the lens unit by closing both lens

locks (A) until the top of the lens locks flip over the lock pin

(B).

Step Action Image

Warning ! Risk of personal injury. Instructions for lens installation must be followed thoroughly.

Illustrations

Image 1

Image 2

BARCO  5  Projection Systems

QFD(4.5-6:1) Lens R9840100 (Continued)

Press the selection key on the RCU to display the zoom/focus menu on the screen.

To focus or zoom the image :

1 Push the cursor keys éor êto zoom and çor èto focus the image.

2 When finished, press exit key.

See also owners manual of the projector, chapter Controlling, item The selection key.

Adjusting the

Lens

Lens Formula To calculate the distance (range) between the projector frontside and the screen (PD)

for a given screen width (SW), use the following formula for

BarcoGraphics 6300 & BarcoGraphics 6400 :

Metric system (PD and SW in meter) :

PDmin = 4.29 x SW - 0.02 + 0.0009/SW

PDmax = 5.86 x SW + 0.15 + 0.0121/SW

Inch system (PD and SW in inch) :

PDmin = 4.29 x SW - 0.79 + 1.395/SW

PDmax = 5.86 x SW + 5.91 + 18.755/SW

BarcoReality 6300 & BarcoReality 6400 :

Metric system (PD and SW in meter) :

PDmin = 4.39 x SW - 0.02 + 0.0008/SW

PDmax = 6.00 x SW + 0.15 + 0.0029/SW

Inch system (PD and SW in inch) :

PDmin = 4.39 x SW - 0.79 + 1.24/SW

PDmax = 6.00 x SW +5.91 + 4.495/SW

Lens Cleaning

Procedure

To minimize the possibility of damaging the optical coating or scratching exposed lens

surface, we have developed recommendations for cleaning the lens.

FIRST, we recommend you try to remove any material from the lens by blowing it off

with clean, dry deionized air. DO NOT use any liquid to clean the lenses.

A TorayseeTM cloth is included with the lens kit.

Proceed as follows :

Always wipe lenses with a CLEAN TorayseeTM cloth.

Always wipe lenses in a single direction. Do not wipe back and for-

wards across the lens surface as this tends to grind dirt into the coating.

Do not leave cleaning cloth in either an open room or lab coat pocket,

as doing so can contaminate the cloth.

If smears occur when cleaning lenses, replace the cloth. Smears are

the first indication of a dirty cloth.

Do not use fabric softener when washing the cleaning cloth or softener

sheets when drying the cloth.

Do not use liquid cleaners on the cloth as doing so will contaminate the

cloth.

Step Action

Order number for a new TorayseeTM cloth : R379058.

Toraysee Cloth

Order Number

Table des matières

Autres manuels Barco Projecteur

Barco

Barco BarcoVision R9000740 Manuel utilisateur

Barco

Barco HDX 4K Manuel utilisateur

Barco

Barco DP2K SLP Series Manuel d'utilisation

Barco

Barco F10 AS3D Manuel utilisateur

Barco

Barco SIM 5H Manuel utilisateur

Barco

Barco CINE 6 Manuel utilisateur

Barco

Barco Galaxy 12 HB+ Manuel utilisateur

Barco

Barco iD H250 Manuel utilisateur

Barco

Barco Galaxy 4 Long Life+ R9040355 Manuel utilisateur

Barco

Barco iQ Pro G300 Instructions d'installation

Barco

Barco SLM R12 Manuel utilisateur

Barco

Barco Helios Manuel utilisateur

Barco

Barco CLM HD8 Manuel utilisateur

Barco

Barco DP K-19B Series Manuel d'utilisation

Barco

Barco FLM HD18 Manuel utilisateur

Barco

Barco F50 Manuel utilisateur

Barco

Barco RLS W12 Manuel utilisateur

Barco

Barco R9010100 Manuel utilisateur

Barco

Barco HDX--W14 Manuel utilisateur

Barco

Barco HDF W series Manuel utilisateur

Barco

Barco CNWU-61B Manuel utilisateur

Barco

Barco UDX 4K22 Manuel utilisateur

Barco

Barco OV-D2 Manuel utilisateur

Barco

Barco BarcoRLM G5 Manuel utilisateur

Manuels Projecteur populaires d'autres marques

iEmmet

iEmmet MP-312 Manuel utilisateur

Epson

Epson VS400 Manuel utilisateur

Sony

Sony VPL-HS10 Marketing Specifications & Features Manuel utilisateur

Sony

Sony VPL-HW65ES Manuel de service

Toshiba

Toshiba TLP-791U Manuel utilisateur

Philips

Philips LC1341 Guide de référence

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Manuel utilisateur

NEC

NEC NP600S EDU Manuel utilisateur

BenQ

BenQ SH753P Manuel utilisateur

Eiki

Eiki EK-623U series Manuel utilisateur

Epson

Epson PowerLite Pro Cinema 6020UB Manuel utilisateur

Epson

Epson PowerLite Home Cinema 705HD Manuel utilisateur

Christie

Christie LHD700 Manuel utilisateur

Navitar

Navitar FX Manuel utilisateur

InFocus

InFocus LitePro 560 Manuel utilisateur

Sony

Sony SRX-R815P Manuel utilisateur

Vivitar

Vivitar DP1500 X Manuel utilisateur

Acer

Acer C20 Series Manuel utilisateur