B-K lighting ORION Manuel utilisateur

Hot SurfaceHigh VoltageWarning

Standard Installation

ORION

YOKE MOUNT

Flammable

IMPORTANT SAFETY INFORMATION - READ, FOLLOW, AND SAVE ALL

SAFETY AND INSTALLATION INSTRUCTIONS

• Product must be installed by a qualified person in a manner

consistent with its intended use and in compliance with the

National Electrical Code, Canadian Electrical Code, and all Local and

Provincial Codes.

• Follow product label information and instructions.

• Qualified Personnel with appropriate personal protective

equipment must perform all servicing of this product.

• Before wiring to power supply and during servicing, turn off and

lock out power at fuse or circuit breaker before service.

• The use of accessory equipment not recommended by the

manufacturer or installed contrary to instructions may cause an

unsafe condition. The use of damaged components may cause an

unsafe condition and void product warranty.

• Do not block light emanating from product in whole or part, as

this may cause an unsafe condition.

• Never operate the fixture with missing or damaged lens.

Lens must be cleaned on regular basis.

• Entire fixture may become extremely hot. Do not touch hot

lens or fixture body.

• Replace LED assembly only with correct wattage and type of

power supply appropriate for LED assembly.

• All gaskets, o-rings and sealing surfaces must be kept clean

during installation and service; failure to do this may cause an

unsafe condition and void product warranty.

INSTRUCTIONS PERTAINING TO

A RISK OF FIRE, OR INJURY

TO PERSONS IMPORTANT SAFETY

INSTRUCTIONS

Lighted fixture is HOT!

WARNING - To reduce the risk of

FIRE OR INJURY TO PERSONS:

Turn off/unplug and allow to cool before

replacing lamp/LED. Fixture gets HOT quickly!

Contact only switch/plug when turning on.

Do not touch hot lens, guard, or enclosure.

Keep fixture away from materials that may burn.

Do not operate the luminaire fitting with a missing or

damaged shield. Do not touch the source at any time.

Use a soft cloth or gloves. Oil from skin may cause

damage.

SAVE THESE INSTRUCTIONS

· Suitable for wet locations

IMPORTANT LISTINGS AND CERTIFICATIONS

Waterproof Wire Connectors

Adjustable Crescent Wrench

Flat Head Screwdriver

TORX T27 Tamper Resistant 1/4” Bit

Mounting Hardware 3/4” Bolt w/ Lockwasher

Torque Wrench & 3/4” Socket

TOOLS

NEEDED:

IMPORTANT SAFETY INFORMATION - READ, FOLLOW, AND SAVE THESE INSTALLATION

INSTRUCTIONS

THIS DOCUMENT CONTAINS PROPRIETARY INFORMATION OF B-K LIGHTING, INC. AND ITS RECEIPT OR POSSESSION DOES NOT CONVEY ANY RIGHTS TO REPRODUCE, DISCLOSE ITS CONTENTS, OR TO MANUFACTURE, USE OR SELL

ANYTHING IT MAY DESCRIBE. REPRODUCTION, DISCLOSURE OR USE WITHOUT SPECIFIC WRITTEN AUTHORIZATION OF B-K LIGHTING, INC. IS STRICTLY FORBIDDEN.

RELEASE DATE

06/27/2023

40429 Brickyard Drive • Madera, CA 93636 • USA

559.438.5800 • FAX 559.438.5900

www.bklighting.com • [email protected]

B-K LIGHTING

REFERENCE NUMBER

INS-2506-00

ORION - YOKE MOUNT

Yoke

Optional: External Egg-Crate Louvers

(Not Field Removeable)

Cord with Built-in Watertight

Strain Relief

Heavy-Gauged, Die-Formed

Aluminum Housing

Tamper Resistant

Screws

LED Array

IMPORTANT SAFETY INFORMATION LISTED ON REVERSE

READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS

RELEASE DATE

06/27/2023

40429 Brickyard Drive • Madera, CA 93636 • USA

559.438.5800 • FAX 559.438.5900

www.bklighting.com • [email protected]

B-K LIGHTING

REFERENCE NUMBER

INS-2506-00

3. Adjust aim by slightly loosening two (2) 1/2-13”

bolts using an 3/4” socket. Aim fixture to desired

position and re-tighten bolts to secure in place.

Using torque wrench, tighten each bolt to 25

ft-lbs.

WIRING DIAGRAM

4. Fixture internal wiring (primary and secondary)

are factory pre-wired. Fixture is provided with 2ft.

leads for installer to make appropriate connections.

Make watertight connections using waterproof

wire connectors to connect primary wiring per

NEC. Be sure to leave enough cord length for

aiming the fixture.

HOT LED

NEUTRAL

GROUND

HOT

NEUTRAL

GROUND

Integral

DRIVER

0-10V -

0-10V +

0-10V -

0-10V +

2. Line up fixture yoke to mounting location and

secure with 3/4”-10 bolt (not included) and locking

washer. Using torque wrench, tighten to 30 ft-lbs

(mounting hardware not included).

1. Prepare for installation for yoke location. Clearance

hole is 7/8” diameter.

7/8” Dia.

120V Through 277V (MT)

Standard Installation

ORION

YOKE MOUNT

Table des matières

Autres manuels B-K lighting Équipement d'éclairage

B-K lighting

B-K lighting TETON Manuel utilisateur

B-K lighting

B-K lighting MINI-MICRO DRIVESTAR Manuel utilisateur

B-K lighting

B-K lighting Nite Star Manuel utilisateur

B-K lighting

B-K lighting Precision2 HP2 Series Manuel utilisateur

B-K lighting

B-K lighting SS Manuel utilisateur

B-K lighting

B-K lighting ArtiStar Integral Manuel utilisateur

B-K lighting

B-K lighting Path Star Manuel utilisateur

B-K lighting

B-K lighting Precision2 HP2 Series Manuel utilisateur

B-K lighting

B-K lighting PS Manuel utilisateur

B-K lighting

B-K lighting HP2RM Manuel utilisateur

B-K lighting

B-K lighting DENALI Manuel utilisateur

B-K lighting

B-K lighting Union Bollard Manuel utilisateur

B-K lighting

B-K lighting Mini-Micro Series Manuel utilisateur

B-K lighting

B-K lighting ArtiStar Series Manuel utilisateur

B-K lighting

B-K lighting ArtiStar Remote Manuel utilisateur

B-K lighting

B-K lighting Altair Manuel utilisateur

B-K lighting

B-K lighting BKSSL Precision2 DR2 Series Manuel utilisateur

B-K lighting

B-K lighting MINI-MICRO RECESSED UPLIGHT Manuel utilisateur

B-K lighting

B-K lighting Denali Series Manuel utilisateur

B-K lighting

B-K lighting ORION Manuel utilisateur

B-K lighting

B-K lighting BACK BOX Manuel utilisateur

B-K lighting

B-K lighting SIGN STAR Series Manuel utilisateur

B-K lighting

B-K lighting LT Manuel utilisateur

B-K lighting

B-K lighting RE1 Manuel utilisateur

Manuels Équipement d'éclairage populaires d'autres marques

Brizo

Brizo 8SP-MU-4 Manuel utilisateur

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuel utilisateur

IKEA

IKEA BJÖRKSPIREA Manuel utilisateur

Laserworld

Laserworld Evolution Series ES-400RGB Manuel utilisateur

Alien

Alien RG STAR Manuel utilisateur

EuroLite

EuroLite LED B-40 Manuel utilisateur

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuel utilisateur

Commercial Electric

Commercial Electric 54568141 Manuel utilisateur

CREE LIGHTING

CREE LIGHTING 304 Series Manuel utilisateur

Goobay

Goobay 49867 Manuel utilisateur

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuel utilisateur

Alkalite

Alkalite Krypton KT-81 Manuel utilisateur

Clas Ohlson

Clas Ohlson GU10 Manuel utilisateur

DTS

DTS DELTA 10 F Manuel utilisateur

ring

ring Solar Steplight Manuel utilisateur

One Stop Gardens

One Stop Gardens 57696 Instructions de montage

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuel utilisateur

SIREM

SIREM Swimeo A2 Manuel utilisateur