Azden WMT-PRO Manuel utilisateur

PRO VHF WIRELESS MICROPHONE SYSTEM

INSTRUCTION MANUAL

WR-PRO - WM-PRO - WM/T-PRO - EX-503 - EX-413

POWER/FREQUENCY

SELECTOR SWITCH

SHOE MOUNT

BATTERY

COMPARTMENT

EARPHONE JACK

SIGNAL INDICATOR

POWER INDICATOR

POWER/FREQUENCY

SELECTOR SWITCH

WR-PRO RECEIVER

WM-PRO TRANSMITTER

EX-503 LAVALIER MIC

MICROPHONE JACK

OUTPUT PLUG

NOTES

 Do not store or use the unit in high heat or humidity.

 Do not use near a broadcast staon, airport or plane . You must change the frequencies if you are

interfering with other transmiers.

 The system will work connuously for 10 hours on one set of baeries. If sound quality is poor,

change baeries.

 Remove baeries when the system is not in use.

Thank you for purchasing the AZDEN PRO VHF Wireless Microphone System. The following

will show you the contents of the system you ordered:

WHX-PRO

1 x WR-PRO VHF Receiver

1 x WM/T-PRO VHF Transmier/Handheld Microphone

WLX-PRO

1 x WR-PRO VHF Receiver

1 x WM-PRO VHF Belt-Pack Transmier

1 x EX-503 Lavalier Microphone

WMS-PRO

1 x WR-PRO VHF Receiver

1 x WM-PRO VHF Belt-Pack Transmier

1 x EX-413 Wired Handheld Microphone

The PRO systems operate in the low-interference VHF band and have 2 switchable frequen-

cies, 169.445 (F1) and 170.245 (F2). You should select the quieter frequency for use.

The systems conforms to Part 90 of the FCC rules. You should contact the FCC oce for l-

ing forms.

WR-PRO RECEIVER

1. Loading Baery

Open the baery compartment lid by sliding it down and raising the lid. Insert a 9-

volt baery into the baery compartment with the correct polarity. Direcons are

on the inside of the baery compartment. Do not force the baery compartment l

id to close. If it does not close easily, turn The baery around and try again.

2. Power/Frequency Selector Switch

This slide switch is used to turn the unit on and o as well as to select a frequency.

When not using the WR-PRO, make sure that the switch is turned to OFF.

3. Signal Indicator

This LED has 2 funcons: When you rst turn the Power/Frequency Selector Switch

of the Receiver on, but if the Transmier is not on, the LED will go on and o indi-

cang that the baery is good. If both the Transmier and the Receiver are on and

they are on the same frequency, the Signal Indicator will remain on.

4. Shoe Mount

The Receiver comes with a shoe mount and loop-and-hook fastener to mount it to a

video camera. Select the one works best for your setup. To install the shoe mount,

align the three pegs to corresponding holes and slide the whole assembly upward

unl it clicks. To remove the shoe mount, slide the assembly downward.

5. Output Plug

Connect the plug from the Receiver into the camera’s “EXT. MIC’ jack.

6. Telescopic Antenna

Fully extend the antenna for the best recepon.

7. Earphone Jack

Plug the supplied earphone into the jack to monitor the sound you are recording.

WM/T-PRO TRANSMITTER/MICROPHONE

1. Loading baery

Turn the boom half of the microphone body counterclockwise unl it is completely

o. Insert 1 “AA” baery into the compartment. Make sure the polarity is correct or

the unit will not operate. Replace the boom half and turn it clockwise unl it is

snug. DO NOT OVERTIGHTEN.

2. Frequency Selecon

The unit is factory pre-set to F1. Make sure that the Receiver is also set to F1. To

change to F2, remove the boom half of the microphone body as you did when

loading baery. On the top of the baery compartment, there is a small 2-posion

switch. Slide the switch to posion F2. Change the Receiver frequency to F2.

3. 3-Posion Power Switch

The boom posion is “OFF”, the top is “ON”, and the middle is ”STANDBY”. In the

“STANDBY” posion, the unit is on but the microphone is muted. This allows the

microphone to be passed around noiselessly. Remember to set the mic to its “ON”

posion before speaking. When the switch in “ON” or “STANDBY”, the red LED will

stay lit if the Receiver is also operang on the same frequency.

WM-PRO TRANSMITTER

1. Loading Baery

Insert 1 9-volt baery into the baery compartment. Be careful not to force the

baery compartment lid closed.

2. Microphone

Plug the EX-503 (lavalier mic) or EX-413 (handheld mic) into the mic jack. Extend

the cord as much as possible since it doubles as the transmier’s antenna.

3. Power/Frequency Selector Switch

This switch is used to turn the unit on and o as well as to select a frequency.

4. Mounng

The Transmier can be aached to a belt using the clip provided or placed in a

pocket.

SPECIFICATIONS

WM-PRO & WM/T-PRO TRANSMITTERS

TRANSMISSION FREQUENCY: F1—169.445MHz

F2—170.245MHz

MODULATION SYSTEM: FM modulaon

BATTERY: 9V x 1 (WM) / 1.5V (AA) x 1 (WM/T)

POWER CONSUMPTION: 30mA (WM)

100mA (WM/T)

DIMENTIONS: 86(h) x 60(w) x 21.5(d)mm (WM)

ɸ 62 x 221mm (WM/T)

WEIGHT (including baery):

98g (WM) / 170g (WM/T)

MICROPHONE:

WR-PRO RECEIVER

RECEPTION FREQUENCY: F1—169.445MHz

F2—170.245MHz

Double Superheterrodyne System

RECEPTION SENSITIVITY: 2µV at S/N40dB

BATTERY: 9V x 1 (not included)

POWER CONSUMPTION: 25mA

MONITOR OUTPUT: Voltage: 1V

(Load: 30Ω, Modfreq: 1KHz, Dev: ±7KHz)

MICROPHONE OUTPUT: Voltage: 8mV

(Load: 10KΩ, Modfreq: 1KHz, Dev: ±7KHz,

Impedance: 300Ω)

DIMENSIONS: 86(h) X 60(w) X 21.5(d)mm

CORPORATION

147 NEW HYDE PARK ROAD, FRANKLIN SQUARE, NY 11010

PHONE: 516-328-7500 EMAIL: sales@azdencorp.com WEB: www.azdencorp.com

Autres manuels pour WMT-PRO

Ce manuel convient aux modèles suivants

Autres manuels Azden Système de microphone

Azden

Azden 500UDR Manuel utilisateur

Azden

Azden Body-pack Transmitter 35BT Manuel utilisateur

Azden

Azden 200R Manuel utilisateur

Azden

Azden 105UPR Manuel utilisateur

Azden

Azden 330UPR Manuel utilisateur

Azden

Azden 30BT Manuel utilisateur

Azden

Azden 310UDR Manuel utilisateur

Azden

Azden 100UPR Manuel utilisateur

Azden

Azden Body-pack Transmitter 35BT Manuel utilisateur

Azden

Azden SMX-100 Manuel utilisateur

Azden

Azden i-coustics pro-xd Manuel utilisateur

Azden

Azden EX-503 Manuel utilisateur

Azden

Azden WLX-PRO Manuel utilisateur

Azden

Azden 330UPR Manuel utilisateur

Azden

Azden IRR-30 Manuel utilisateur

Azden

Azden 10BT Manuel utilisateur

Azden

Azden 310UDR Manuel utilisateur

Azden

Azden WMS-PRO Manuel utilisateur

Azden

Azden WLX-PRO Manuel utilisateur

Azden

Azden 1200URX/Si Manuel utilisateur

Azden

Azden 411UDR Manuel utilisateur

Azden

Azden UHF Performance Series Manuel utilisateur

Azden

Azden 330UPR Manuel utilisateur

Azden

Azden 105UPR Manuel utilisateur

Manuels Système de microphone populaires d'autres marques

Paso

Paso R824 Manuel utilisateur

Naxa

Naxa NAM-982 Manuel utilisateur

Motorola

Motorola PMNN4461 Manuel utilisateur

Xvive

Xvive U3 Manuel utilisateur

Tekon

Tekon DUOS Manuel utilisateur

Heyuan Intelligence

Heyuan Intelligence IOT-G2S-01 Manuel utilisateur

Devine

Devine WMD-IE Manuel utilisateur

LG LF-D7150 Manuel utilisateur

GE S768DAV Manuel utilisateur

LD U305 HBH 2 Manuel utilisateur

Chainway

Chainway URA8 Manuel utilisateur

ORATOR

ORATOR D860TD Manuel utilisateur

Sennheiser

Sennheiser Evolution Wireless Digital EW-DX EM 2 Manuel utilisateur

Alpha Technologies

Alpha Technologies RBMS Manuel utilisateur

SWIT Electronics Co.,LTD.

SWIT Electronics Co.,LTD. CW-S150 Manuel utilisateur

Shure

Shure UA844 Manuel utilisateur

Panasonic

Panasonic SHFX70 - DVD HOME THEATER WIRELESS SYSTEM Manuel utilisateur

Pyle

Pyle PDWM5000 Manuel utilisateur