AWS SR-1 Manuel utilisateur

American Weigh Scales, Inc.

SR-1 (1000x1g)

SR-5 (11x0.01lb)

SR-20 (44x0.02lb)

User Manual

Digital Hanging Scale

SR-Series

HOLD

SR-Series Manual

Thank you for purchasing the American Weigh SR-

Series digital pocket scale. Please read all operating

instructions carefully before use. Scales are precision

instruments and should always be handled with proper

care. To ensure years of reliable service, keep these

simple tips in mind:

• Do not exceed the scales maximum capacity.

Overloading your scale can permanently damage it!

• Avoid exposure to extreme heat or cold. Scales

perform best at normal room temperature. If

temperatures have changed dramatically, recalibration

may be necessary.

• Allow your scale to warm up for 30-60 seconds

before performing calibration (if available).

• Store your scale in a clean, dry location. Dust, dirt,

and moisture can accumulate on the weighing sensors

and electronics causing innacuracy or malfunction.

• Avoid using your scale in close proximity to strong

radio wave emitting devices such as computers, cash

registers, and cordless phones.

• Hold the hanging scale steady when obtaining weight

measurements.

• Gently apply all items to be weighed. Do not drop

items onto the weighing hook.

• Avoid dropping your scale. The warranty does not

cover damage due to rough treatment or overload.

I. SCALE OPERATION

Hold the scale steady when weighing.

1. Press the [ ] key.

2. If you would like to change the weighing unit,

continue to tap the [ ] key while the display starts up

(while 8888 is still displayed). Skip this step otherwise.

2. Wait until “0.00” or “0” is displayed.

3. Place the object(s) on the weighing hook.

4. When the weight is stable, the red light will turn on,

and HOLD will be displayed below the weight.

5. Remove the object(s) from the hook and tap the

[ ] key to re-zero the scale.

6. To turn the scale off, press and hold the [ ] key.

II. TARE WEIGHING

1. Turn on the scale as described above.

2. Place a container on the scale hook and wait for it

to stabilize (HOLD will be displayed).

3. Tap the [ ] button. “0.00” or “0” will be displayed.

4. You can now add items to the container or tray to

obtain just the weight of the contents.

5. When the container is removed, a negative number

will be displayed. Press [ ] again to zero the scale.

III. CALIBRATION

This scale has come pre-calibrated at the factory. Only

re-calibrate if you are experiencing trouble weighing.

SR-1 uses a 1000g calibration weight

SR-5 uses a 1000g calibration weight

SR-20 uses a 5000g calibration weight

1. Turn the scale OFF.

2. Remove the battery cover and locate the calibration

switch to the left of the battery compartment.

3. Switch it to the up position.

4. Press the [ ] button to turn the scale on. A

random number will be displayed.

5. Tap the [ ] button once more and the display will

ash “CAL” folowed by the required cal. weight.

6. Hang a the required weight on the scale’s hook,

keeping the scale as steady as possible.

7. The display will show “PASS” and then return to

normal weighing mode.

8. Flip the calibration switch to the down position and

replace the battery cover.

9. Press and hold the [ ] key to turn the scale off.

IV. TROUBLESHOOTING

The primary reasons for inaccuracy or malfunction

are low batteries, incorrect calibration, overload or

operating on an unstable surface. Please keep this in

mind and maintain and operate your scale properly.

This scale is a precise instrument and must be

handled with the utmost care and caution.

[Display] Elimination of errors

[Lo] Change the batteries.

[OUE2] Recalibrate the scale as shown above.

[EEEE] You are overloading the scale. Remove the

excessive load immediately!

Model SR-1 SR-5 SR-20

Capacity 1000g / 35.30oz 5kg / 11lb 20kg / 44lb

Resolution 1g / 0.05oz 0.005kg / 0.01lb 0.01kg / 0.02lb

Weighing Units g, oz kg, lb kg, lb

Calibration Weight (not Included) 1000g (1kg) 1000g (1kg) 5000g (5kg)

Scale Dimensions (inches) 4.0 x 2.3 x 0.7”

Power 2 x AAA Batteries (included)

Warranty 10 Year Warranty

Specications

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels AWS Échelle

AWS

AWS AMW-Card400 Manuel utilisateur

AWS

AWS Blade-v2-50 Manuel utilisateur

AWS

AWS ONYX-5K Manuel utilisateur

AWS

AWS 2K-BOWL Manuel utilisateur

AWS

AWS SR-1KG Manuel utilisateur

AWS

AWS AMW-55 Manuel utilisateur

AWS

AWS MERCURY PRO MPR-180 Manuel utilisateur

AWS

AWS CP2-300 Manuel utilisateur

AWS

AWS HB-6 Manuel utilisateur

AWS

AWS NutriBalance-5000 Manuel utilisateur

AWS

AWS 330LPW Instructions de montage

AWS

AWS VANILLA-5K Manuel utilisateur

AWS

AWS CP2-100 Manuel utilisateur

AWS

AWS SC-501 Manuel utilisateur

AWS

AWS CP5-100 Manuel utilisateur

AWS

AWS 330ECO Manuel utilisateur

AWS

AWS AT-500 Manuel utilisateur

AWS

AWS EXTEND-5K Manuel utilisateur

AWS

AWS LB-1000 Manuel utilisateur

AWS

AWS AMWSHIP-150 Manuel utilisateur

AWS

AWS ScaleMate SM-200 Manuel utilisateur

AWS

AWS PB-13 Manuel utilisateur

AWS

AWS SC-501 Manuel utilisateur

AWS

AWS MERCURY MRC-200 Manuel utilisateur

Manuels Échelle populaires d'autres marques

Gima

Gima Glass Body Fat Analyzer Manuel de la liste des pièces

Seca

Seca 374 Manuel utilisateur

TEC

TEC TEC SL59 SERIES Manuel utilisateur

Axis

Axis B/E Series Manuel utilisateur

Alecto

Alecto ACW-40 Manuel utilisateur

Rice Lake

Rice Lake MSI-4260 IS Manuel utilisateur

IKA

IKA RCT basic safety control Manuel utilisateur

ADE

ADE M20011 Manuel utilisateur

Duronic

Duronic KS3000 Manuel utilisateur

Digi

Digi SM-720 Manuel utilisateur

Cardinal

Cardinal CS Series Manuel utilisateur

Korona

Korona Kastella Manuel utilisateur

A&D

A&D FC-50Ki Manuel utilisateur

BDA

BDA CAMARGUE Manuel utilisateur

Tanita

Tanita HD-357 Manuel utilisateur

Leifheit

Leifheit 03173 Manuel utilisateur

Lumme

Lumme LU-1340 Manuel utilisateur

Fidelity Electronics

Fidelity Electronics G2e Manuel utilisateur