Avery Dennison Monarch 9855 RFID Manuel de service

Monarch®

9855®RFID

Printer

Each product and program carries a respective written warranty, the only warranty on

which the customer can rely. Paxar reserves the right to make changes in the product,

the programs, and their availability at any time and without notice. Although Paxar has

made every effort to provide complete and accurate information in this manual, Paxar

shall not be liable for any omissions or inaccuracies. Any update will be incorporated in

a later edition of this manual.

No part of this publication may be reproduced, transmitted, stored in a retrieval system,

or translated into any language in any form by any means, without the prior written

permission of Paxar Americas, Inc.

WARNING

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in a

commercial environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instruction manual,

may cause harmful interference to radio communications. Operation of this equipment in

a residential area is likely to cause harmful interference in which case the user will be

required to correct the interference at his own expense.

CANADIAN D.O.C. WARNING

This digital apparatus does not exceed the Class A limits for radio noise emissions from

digital apparatus set out in the Radio Interference Regulations of the Canadian

Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les

limites applicables aux appareils numériques de la classe A prescrites dans le Réglement

sur le brouillage radioélectrique édicte par le ministère des Communications du Canada.

Trademarks

Monarch® and 9855 are trademarks of Paxar Americas, Inc.

Paxar® is a trademark of Paxar Corporation.

Avery Dennison® is a trademark of Avery Dennison Corporation.

EPCglobal, Inc.™and Electronic Product Code™(EPC) are trademarks of Uniform Code Council, Inc.

Uniform Code Council, Inc.®is a trademark of Uniform Code Council, Inc.

I CODE® is a registered trademark of Philips Electronics N.V.

Avery Dennison Printer Systems Division

170 Monarch Lane

Miamisburg, OH 45342

TABLE OF CONTENTS

GETTING STARTED ..................................................................................... 1-1

Audience................................................................................................ 1-2

Using this Manual ................................................................................... 1-2

Unpacking the Printer.............................................................................. 1-3

Shipping the Printer ............................................................................. 1-3

9445™ Printer Online Emulation............................................................... 1-4

Ordering Programmer's Manuals............................................................... 1-4

About Monarch® MPCL™ Toolbox Utilities................................................. 1-4

Connecting the Power Cable .................................................................... 1-4

Establishing Communications................................................................... 1-5

Connecting the Communication Cable.................................................... 1-5

Using the Control Panel........................................................................... 1-6

Printer Status Lights ............................................................................ 1-6

Button Functions ................................................................................. 1-6

Display ............................................................................................... 1-7

Selecting a Function................................................................................ 1-7

Exiting an Option .................................................................................... 1-8

LOADING SUPPLIES.................................................................................... 2-1

Loading Labels or Tags ........................................................................... 2-2

Loading Labels for the Optional Peel Mode ............................................ 2-6

Adjusting the Wide/Narrow Knobs ............................................................. 2-8

LOADING RIBBON ....................................................................................... 3-1

Loading Ribbon....................................................................................... 3-2

SETTING SUPPLY OPTIONS......................................................................... 4-1

Supply Type ........................................................................................... 4-3

Ribbon................................................................................................... 4-4

Speed.................................................................................................... 4-5

Feed Mode ............................................................................................. 4-6

Backfeed................................................................................................ 4-7

Positioning ............................................................................................. 4-8

Print Position ...................................................................................... 4-8

Supply Position ................................................................................. 4-10

Margin Position ................................................................................. 4-11

Cut Position ...................................................................................... 4-12

Dispense Position.............................................................................. 4-12

Backfeed Distance ............................................................................. 4-13

Batch Separators .................................................................................. 4-14

Skip Index............................................................................................ 4-15

Knife Control ........................................................................................ 4-16

Error Action.......................................................................................... 4-17

Setting Contrast.................................................................................... 4-20

Verifier ................................................................................................ 4-21

Verifier ................................................................................................ 4-22

SETTING COMMUNICATIONS ....................................................................... 5-1

Baud Rate.............................................................................................. 5-2

Word Length........................................................................................... 5-2

Stop Bits................................................................................................ 5-3

Parity..................................................................................................... 5-3

Flow Control........................................................................................... 5-4

Reset to Default Values ........................................................................... 5-4

Parallel Communications ......................................................................... 5-5

Port.................................................................................................... 5-5

Mode.................................................................................................. 5-6

iii

SETTING DEFAULTS.................................................................................... 6-1

Monetary Sign ........................................................................................ 6-3

Secondary Sign ...................................................................................... 6-4

Decimal Places....................................................................................... 6-5

Slashed Zero.......................................................................................... 6-5

Power-Up Mode ...................................................................................... 6-6

Prompt Set ............................................................................................. 6-6

Flash Storage......................................................................................... 6-7

No Image Errors ..................................................................................... 6-8

Ignore Configuration................................................................................ 6-9

Using Flash Memory.............................................................................. 6-10

Formatting Flash Memory ................................................................... 6-10

Checking Available Flash Memory ....................................................... 6-11

Packing Flash Memory ....................................................................... 6-12

Memory Guidelines ............................................................................... 6-13

Setting Batch Options............................................................................ 6-14

Setting Up the Network Printer ............................................................... 6-14

Setting Up the RFID Printer ................................................................... 6-14

USING SCRIPTS .......................................................................................... 7-1

Initial Script Startup Procedures ............................................................... 7-1

Viewing Script Information ....................................................................... 7-2

Downloading a Script .............................................................................. 7-3

Enabling a Script .................................................................................... 7-4

Deleting a Script ..................................................................................... 7-5

Enabling Status Polling............................................................................ 7-6

Using Immediate Commands .................................................................... 7-7

PRINTING ................................................................................................... 8-1

Printing.................................................................................................. 8-1

On-Demand Mode Printing ....................................................................... 8-2

Printing an Error Label ......................................................................... 8-2

Pausing a Batch...................................................................................... 8-3

Restarting a Batch .................................................................................. 8-3

Canceling a Paused Batch ....................................................................... 8-4

Repeating a Batch................................................................................... 8-6

Offline Printing ....................................................................................... 8-6

Special Printing Considerations................................................................ 8-7

Printing TrueType® Fonts ........................................................................ 8-8

Licensing Your Fonts............................................................................... 8-8

CARE AND MAINTENANCE .......................................................................... 9-1

Label Jams............................................................................................. 9-1

Cleaning ................................................................................................ 9-1

Replacing the Printhead .......................................................................... 9-5

DIAGNOSTICS AND TROUBLESHOOTING ................................................... 10-1

Factory Set Password............................................................................ 10-1

Checking the Software Version............................................................... 10-1

Printing a Test Label ............................................................................. 10-2

Checking Supply Quality........................................................................ 10-3

Using Password Protection .................................................................... 10-4

Enabling the Password (System Administrators only)............................. 10-4

Service Diagnostics............................................................................... 10-5

Troubleshooting.................................................................................... 10-6

Error Messages .................................................................................... 10-8

Common Errors..................................................................................... 10-8

SPECIFICATIONS ........................................................................................A-1

Printer ...................................................................................................A-1

RF Specifications....................................................................................A-2

RFID Supply Specifications......................................................................A-2

Tag Cut Dimensions ................................................................................A-3

Ribbon Specification ...............................................................................A-3

About Ribbons.....................................................................................A-3

Cable Pinouts.........................................................................................A-4

ACCESSORIES AND OPTIONS .....................................................................B-1

Accessories............................................................................................B-1

Packaging Materials.............................................................................B-2

Factory-Installed Options.........................................................................B-2

Ethernet Information ............................................................................B-3

RF Information ....................................................................................B-3

GLOSSARY ................................................................................................ G-1

Getting Started 1-1

GETTING STARTED

Your Monarch9855RFIDMP (Radio Frequency Identification

Multi-Protocol) printer has been engineered to program (encode) an RFID

label (commonly called “RFID tags”) before the label’s format is printed.

RFID tags contain an embedded RFID inlay (chip and antenna).

You can also print text, graphics, and bar codes on thermal transfer (ribbon)

and thermal direct labels or tags. The printer prints labels continuously (in

one strip) or on-demand (one label at a time). Linerless supplies are not

currently supported. The RFID printer is also capable of printing standard

(non-RFID) supplies.

The HF (High Frequency) RFID printer supports multi-protocol encoding,

including ISO15693 and I•CODE® UID products.

Note: Information in this document supercedes information in previous

versions. Check our Web site (www.paxar.com) for the latest

documentation and release information.

Review the terms in the Glossary before you continue.

This chapter includes information about

♦ unpacking the printer

♦ connecting the power cord

♦ connecting the communication cable

♦ using the printer's control panel.

Several chapters of this manual have one or more charts showing the

printer's menu structure. For example:

Main Menu

The black boxes show where you are; the bordered boxes show how you got

there.

Cancel

Mode

Repeat

Batch

Supply

Contrast

Setup

Defaults Port

Settin

Flash

Memor

Scripts Diag.

Batch

Entr

Batch

tions

Verifier

Network RFID

1-2 Operator’s Handbook

Refer to the MonarchNet2™Operating Instructions for information about the

Network menu. Refer to the Multi-Protocol Application Notes or the HF

Application Notes for information about the RFID menu.

Audience

The Operator's Handbook is for the person who prints and applies labels.

For information about creating RFID formats or programming the RFID

printer, refer to the Multi-Protocol Application Notes or the HF Application

Notes on our Web site.

Using this Manual

Following is a summary of the contents of this manual.

Chapter Contents

1 Getting Started

Contains information about connecting the power

cable and using the control panel.

2 Loading

Supplies

Describes how to load a roll of supply, fan-fold

supply, and tag supply.

3 Loading Ribbon

Describes how to load a roll of ribbon and lists high-

energy ribbon information.

4 Setting Supply

Options

Using the Supply menu to set the various supply

options (supply, ribbon, feed mode, etc.).

5 Setting

Communication

Values

Using the Port Settings menu to set the serial and

parallel communication values (baud rate, parity,

etc.).

6 Setting Defaults Using the Defaults menu to set the monetary sign,

number of decimal places, prompt set, etc.

7 Using Scripts Using the Scripts menu to load a script, enable a

script, delete a script, etc.

8 Printing Explains how to print labels and use the Pause menu.

9 Care &

Maintenance

Describes how to clear a label jam, clean the printer,

and replace the printhead.

10 Diagnostics &

Troubleshooting

Describes how to print a test label and lists common

problems and their solutions.

A Specifications Contains printer and supply specifications.

B Accessories &

Options

Contains printer accessories and optional equipment.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Avery Dennison Imprimante

Avery Dennison

Avery Dennison TTX 207 Manuel utilisateur

Avery Dennison

Avery Dennison Monarch 9460 Manuel utilisateur

Avery Dennison

Avery Dennison Monarch 9419 Manuel utilisateur

Avery Dennison

Avery Dennison Monarch 9906 Manuel utilisateur

Avery Dennison

Avery Dennison Stacker Monarch 932TM Manuel utilisateur

Avery Dennison

Avery Dennison Monarch Tabletop Printer 2 Manuel utilisateur

Avery Dennison

Avery Dennison Monarch 9854 Manuel utilisateur

Avery Dennison

Avery Dennison Monarch 9419 Manuel utilisateur

Avery Dennison

Avery Dennison SNAP 700 Manuel utilisateur

Avery Dennison

Avery Dennison APP 31x Manuel utilisateur

Avery Dennison

Avery Dennison TrafficJet Manuel utilisateur

Avery Dennison

Avery Dennison Monarch 9419 Manuel utilisateur

Avery Dennison

Avery Dennison Pathfinder 6059 Manuel de service

Avery Dennison

Avery Dennison Pathfinder 6140 Document technique

Avery Dennison

Avery Dennison AP 2.4 Manuel utilisateur

Avery Dennison

Avery Dennison Monarch 9825 Manuel utilisateur

Avery Dennison

Avery Dennison Monarch Pathfinder Ultra Silver 6032 Manuel de service

Avery Dennison

Avery Dennison M09416 XLI Manuel utilisateur

Avery Dennison

Avery Dennison SNAP 700 Manuel d'utilisation

Avery Dennison

Avery Dennison Monarch 9825 Instructions d'installation et d'utilisation

Avery Dennison

Avery Dennison SNAP 700 Manuel utilisateur

Avery Dennison

Avery Dennison AP4.4 Manuel utilisateur

Avery Dennison

Avery Dennison Monarch SIERRA SPORT4 9493 Manuel de service

Avery Dennison

Avery Dennison Pathfinder 6140 Manuel utilisateur

Manuels Imprimante populaires d'autres marques

Lexmark

Lexmark 1400 Series Manuel

Canon

Canon i70 Series Manuel utilisateur

Evolis

Evolis Elypso Manuel utilisateur

Kyocera

Kyocera FS-9530DN Manuel utilisateur

Canon

Canon LASER SHOT LBP-1210 Manuel utilisateur

Samsung

Samsung BIXOLON SRP-350plusF Manuel utilisateur

Canon

Canon PIXMA PRO-1 Series Manuel utilisateur

Canon

Canon PIXMA G3560 Guide de configuration

Dell

Dell Color Laser Printer 2130cn Manuel utilisateur

Tektronix

Tektronix Phaser 840 Manuel utilisateur

Epson

Epson ET-7750 Mode d'emploi

Canon

Canon CLBR 460ps Manuel utilisateur

Eltron

Eltron P210 Guide Manuel utilisateur

Ricoh

Ricoh MD-P1 Manuel utilisateur

Epson

Epson SC-F7100 series Manuel utilisateur

Epson

Epson Stylus C40UX Manuel utilisateur

Canon

Canon imagePASS-A2 Manuel utilisateur

Canon

Canon S820D Manuel utilisateur