Avent Security M700 Manuel utilisateur

M700

FINGERPRINT DOOR LOCK

Brief Introduction

Product Guide

1There are 13 password users and 993 ﬁngerprint users and RF card users available

in the lock.

2The password can be set with 6 to 10 digits.

3There are single unlocking mode and double unlocking mode in the lock.

Single unlocking mode is default.

Fingerprint Sensor

Touch Screen Keypad Battery

Lock Knob

1 2 3

4 5 6

*0#

87 9

4There is voice introduction to help you understand the operations in the lock.

5The lock will be locked for 3 minute after inputting wrong password in 5 times.

6When the battery voltage is low than 4.8V, the low battery alarm will be activated

every time when unlock the lock.

7The cylinder and the Micro USB port are at the bottom of outside panel.

8 The Security bolt has to be unlocked from inside.

Cylinder

Micro-USB Port

Installation

Fo ld

Si de

Fr on t

1.Place the template on the door.

According to the template,mark

the holes on the door with a

pencil.

35mm

20mm

-245

-235

-225

handle

2.Take out the mortise before

drilling the holes. Drill the

door hole with a driller of

20mm and 35mm for mortise.

Fix the mortise with screws.

3.Adjust upper screw sleeve

according to actual door hole

position. Insert square bar into

handle hole, make sure arrow

points to handle direction.

5.Take out battery cover,

connect cables of front and

back faceplates,and makesure

knob is fixed in correct direction.

4.Install front faceplate,

making sure different parts

go into correct holes.

6.Use one hand to press front

faceplate against the door,

fix back faceplate with 2 screws.

Installation

set

7.Adjust face plate position to

make sure it is straightly

and correctly installed.

8.Install the battery box and

batteries, test the deadbolt.

9.Install the striking box

and striker.

10.Test the installation by inner

handle, knob, mechanical key,

fingerprint, password and

reading card.

Some Suggestions to Help Capturing the Fingerprint

When placing the ﬁnger on the sensor, please make sure the “core” of ﬁngerprint is staying in the

main area of sensor directly with a little be pressure. Like the pictures show as following:

Insert Image

The sensor may not capture the correct ﬁngerprint image if you take the following operations.

Insert Image

it is suggested to register the thumb, first finger, and middle finger for better

fingerprint images.

Operation

Place the ﬁnger on the sensor, the lock will be activated automatically and started to capture the

ﬁngerprint image for identiﬁcation. Once the identiﬁcation is passed, the keypad shows “Blue”

light with sounds, then you can press down the handle for unlocking.

Touch the keypad to activate the lock, and then input the password (6-10 digits) with pressing “#”

to ﬁnish. If the password is correct, the keypad shows “Blue” light with sounds, then you can press

down the handle for unlocking.

***

(6-10 digits)

When inputting a wrong password for 3 times, the lock will be locked for

5 minutes. During the 5 minutes, the lock cannot be activated and all

operations are not available. After that, the lock returns to normal state.

2Fingerprint Unlocking

3Password Unlocking

“BLUE” +

1 2 3

4 5 6

*0#

87 9

“BLUE” +

1 2 3

4 5 6

*0#

87 9

Random Password Protection

For a better security protection to the password user, the lock is designed with a random

password protection. You can add any digits before and after the real password.

When there is problem with electronic part, and the batteries run out of power, using mechanical key

is the way to unlock the lock.

For example, the password is “1234-5678”, you can unlock the lock by inputting the password

as following:

1 2 3456 7 8 X X X X

X X X X 1 2 3 4 567 8

X X

5Mechanical Key Unlocking

1 2 3456 7 8 X#

XX#

X X

X X X X

4RF Card Unlocking

Place the card close to the card reader to verify, if the card is correct, the keypad shows “Blue” light

with sounds, then you can press down the handle for unlocking.

“BLUE” +

1 2 3

4 5 6

*0#

87 9

1 2 3

4 5 6

*0#

87 9

1 2 3

4 5 6

*0#

87 9

Operation

Press “SET” key in the battery case;

aFor Fingerprint User: place the ﬁnger

on the sensor twice, then ﬁnish registration;

SET

For Password User: input the password twice,

ﬁnish by pressing “#” to conﬁrm,

and then ﬁnish registration;

*** #

1. There are maximum 3 master users are available in the lock;

2. Please try to use the master user to unlocking to make sure

the operations are successful.

3. The password can be set 6 to 10 digits;

For RF Card User: place the card

on the reader once, then ﬁnish registration.

Activate the lock, and then press “*”

and then press “#” to start the

registration mode;

aInput the master user for authorization;

Press number “1” for registration;

cInput the group number (group 0 to 9)

Master

***

For Fingerprint User:

place the ﬁnger on the sensor twice;

eFor Password User:

input the password twice,

ﬁnish by pressing “#” key；

***

(0~9)

x2 *** #

For Card User: place the card

on the reader twice

Each group there are 99 users for Fingerprints

and RF cards, and 1 user for Password.

Please try to use the registered user to unlock

and make sure the operations are successful.

Delete Normal User

Activate the lock, and then press “*”

and then press “#” to start the

registration mode;

aInput the master user for authorization;

Press number “2” to delete users;

cDelete all users in the same group,

press “1” and then press “#” to conﬁrm;

Master

***

Delete single user,

press “2”, and then input

the user ID, press “#” to conﬁrm;

dDelete all normal users, press “3”,

and then press “#” to conﬁrm;

1. If delete all normal users, the lock keeps the master users only;

2. Please try to use the deleted user to unlock and make sure the

operations are successful.

Table des matières

Autres manuels Avent Security Serrure de porte

Avent Security

Avent Security M600 Manuel utilisateur

Avent Security

Avent Security M901S Manuel utilisateur

Avent Security

Avent Security M500 Manuel utilisateur

Avent Security

Avent Security VN168 Manuel utilisateur

Avent Security

Avent Security M800 Manuel utilisateur

Manuels Serrure de porte populaires d'autres marques

Assa Abloy

Assa Abloy effeff 827A-IP Manuel utilisateur

We.lock

We.lock SECBNEBL51 Manuel utilisateur

Iseo

Iseo MA1A Manuel utilisateur

ID Lock

ID Lock 150 Manuel utilisateur

Lockly

Lockly ACCESS TOUCH PRO Manuel utilisateur

iLoq

iLoq G50S Manuel utilisateur

SDC

SDC Z7835 Manuel utilisateur

ilco

ilco 452 Manuel utilisateur

Samsung

Samsung shs-h705 Manuel utilisateur

TRU-BOLT

TRU-BOLT 08102017 Manuel utilisateur

CDVI

CDVI 500-LADJ Manuel utilisateur

Igloohome

Igloohome Deadbolt 2S Metal Grey Instructions d'installation et d'entretien

eSSL

eSSL FL-300 Manuel utilisateur

JAKO

JAKO JKBTNX4 Manuel utilisateur

Dorma

Dorma MUNDUS PREMIUM GK 50 Guide de l'utilisateur

SCOOP

SCOOP Pullbloc 4.1 FS Panik Manuel utilisateur

Yale

Yale MORTISE 8800 SERIES Manuel utilisateur

Siegenia

Siegenia KFV AS3500 Manuel utilisateur