Asus Blitz Formula Manuel utilisateur
Installing Fusion Block System accessory 1
Installing Fusion Block System accessory
Install your watercooling system to the motherboard using the bundled accessories
to obtain the best thermal solution.
Package contents
12
For watercooling system with 3/8” ID tubes
1. Firmlypressatubeclipandtthetubeintotheclip.
2. Press the clip and connect the tube to the waterblock. When done, release
the clip to tighten the two together.
3. Repeat Step 1 and 2 for another tube. Make sure that both tubes are well
connectedtopreventleak,andthenllthecoolantintothereservoir.
3/8” ID tubes x 2 1/2”to3/8”IDttingsx2 10mmto3/8”IDttingsx2
1/2” ID tube clips x 2tube clips x 2 3/8” ID tube clips x 6
2 Installing Fusion Block System accessory
56
5. Press the clip and connect the assembled tube to the waterblock. When
done, release the clip to tighten the two together.
6. Repeat Step 1 to 5 for another tube. Make sure that both tubes are well
connectedtopreventleak,andthenllthecoolantintothereservoir.The
picture shows a watercooling system installed to the motherboard.
3
2
14
For watercooling system with 1/2” or 10mm ID tubes
1. Insertatting(1/2”to3/8”IDor10mmto3/8”ID)intothetube.
Your watercooling system may come with tube clips. Use the clips to fasten the
ttingsandthetubestogether.
2. Connectasupplied3/8”IDtubetothetting.
3. Firmly press a tube clip and hitch it to the bottom end of the 3/8” ID tube.
4. Press another clip and hitch it to the top end of the 3/8” ID tube.
Autres manuels pour Blitz Formula
1
Table des matières
Autres manuels Asus Accessoires
Asus
Asus ABTU012 Manuel utilisateur
Asus
Asus ABTU016 Manuel utilisateur
Asus
Asus ZenPower PD 10000 Manuel utilisateur
Asus
Asus ZenPower PD 10000 Manuel utilisateur
Asus
Asus Pen 2.0 Manuel utilisateur
Asus
Asus Active Stylus SA200H Manuel utilisateur
Asus
Asus Xtion Manuel utilisateur
Asus
Asus ROG RYUO III ARGB Series Manuel utilisateur
Asus
Asus ZenPower Slim Manuel utilisateur
Asus
Asus ABTU001 Manuel utilisateur
