▸ Display selected programmer on toolbar 56
▸ Display the status bar in the lower part of
the window 56
▸ Display icons on toolbar buttons 56
▸ Display descriptions on toolbar buttons 57
▸ Show mass production counter in status
bar 57
Options ➙ Program settings ➙ Files 57
▸ File save style 57
▸ Automatically check for newer versions of
actual file 57
▸ Check device type when loading .hex file 57
▸ Save device type into .hex file 57
▸ Warn when loaded HEX does not contain
CFG memory data 57
▸ Warn when loaded HEX is not aligned to
word size. 58
▸ Binary file loading and saving style 58
▸ Save unused locations to .hex file 58
▸ Clear code/main / data memory / ID
positions before file reading 58
▸ Erase configuration memory before file
reading 58
▸ Read data memory not from the file but
from the device 58
▸ Read ID positions not from the file but
from the device 58
▸ Save fuses in UP instead of data file 59
▸ Project storing style 59
▸ Load last project on start-up 59
Options ➙ Program settings ➙ Colors 59
Options ➙ Program settings ➙ Editors 59
▸ Code/main memory editor: show words as
bytes 59
▸ Code/main memory editor 8 words wide 59
▸ Data memory editor 8 words wide 59
▸ Boot memory editor 8 words wide 59
▸ Show only the lowest byte of word in ASCII 59
▸ Mask ID positions while reading from
device, from file, etc. 59
▸ Mask ID positions during direct user input 59
▸ Configuration memory editor: show cfg
word instead of fuses 60
Options ➙ Program settings ➙ Serial numbers 60
▸ Serial numbers 60
▸ Prepare S/N before programming 60
▸ Find successor after programming 60
▸ Prepare S/N after programming 60
▸ Serial number interval 60
▸ Log to file 60
▸ After project load set actual SN according
to the last in the log 60
▸ Serial number length (the number of
characters) 60
▸ Number base 60
▸ Code as ASCII 61
▸ Initial serial number 61
▸ Next S/N 61
▸ Destination 61
▸ Hexadecimal address of first word 61
▸ Fill with RETLW instruction 61
▸ Characters per word 61
▸ Sequence 61
Options ➙ Program settings ➙ Checksum 61
▸ Show checksum in status bar 61
▸ Write checksum to log file 61
▸ Checksum algorithm 62
Options ➙ Program settings ➙ Others 62
▸ Update check settings 62
▸ Allow internal and external supply
voltages collision 62
▸ Do not show warning if internal 5V is
switched on with 3.3V device 62
▸ Allow to change supply voltage level when
it is on 62
▸ Allow external supply voltage for devices
requiring VPP before VCC. 62
▸ When using Windows Messages disable
other warnings 63
▸ Pin T during programming 63
▸ Pin T after programming 63
