Artila M-X6ULL-B Instructions d'installation

M-X6ULL-B

Linux-Ready Cortex-A7

System on Module

Hardware Guide

Version: 1.01

2021 Sep.

M-X6ULL-B Hardware Guide

ARTILA

Trademarks

The Artila logo is a registered trademark of Artila I c. All other trademarks or

registered marks i this ma ual belo g to their respective ma ufacturers.

Disclaimer

I formatio i this docume t is subject to cha ge without otice a d does ot

represe t a commitme t o the part of Artila.

Artila provides this docume t as is, without warra ty of a y ki d, either expressed

or implied, i cludi g, but ot limited to, its particular purpose. Artila reserves the

right to make improveme ts a d/or cha ges to this ma ual, or to the products

a d/or the programs described i this ma ual, at a y time.

I formatio provided i this ma ual is i te ded to be accurate a d reliable.

However, Artila assumes o respo sibility for its use, or for a y i fri geme ts o

the rights of third parties that may result from its use.

This product might i clude u i te tio al tech ical or typographical errors.

Cha ges are periodically made to the i formatio herei to correct such errors,

a d these cha ges are i corporated i to ew editio s of the publicatio .

M-X6ULL-B Hardware Guide

ARTILA

Document Amendment History

Revision Date Remark

V 1.0 2021 Ja I itial

V1.01 2021 Sep. CN18 defi itio

M-X6ULL-B Hardware Guide

ARTILA

Ta le of Contents

Introduction .................................................................................................. 6

1.1

Features .............................................................................................. 6

1.2

Specificatio s (Hardware) .................................................................... 6

1.3

Specificatio s (Software) ..................................................................... 8

1.4

Packi g List ......................................................................................... 10

1.5

Optio al ............................................................................................... 10

i.MX-6ULL: Arm Cortex-A7 MPU.................................................................. 11

2.1

NXP i.MX 6ULL Block Diagram ........................................................... 11

2.2

NXP i.MX-6ULL Features .................................................................... 12

Layout & Dimensions................................................................................... 13

3.1

Outlook ................................................................................................ 13

3.2

Dime sio s .......................................................................................... 14

Block Diagram .............................................................................................. 15

Pin Assignment and Definitions.................................................................. 16

5.1

Co ector I formatio ......................................................................... 16

5.2

Matchi g Co ector I formatio (M-X6ULL-B starter kit) ..................... 16

5.3

Co ector a d PIN defi itio ............................................................... 17

5.3.1

Co ector (CN1) ................................................................................. 17

5.3.2

Co ector (CN2) ................................................................................. 18

5.3.3

Co ector (CN3) ................................................................................. 19

5.3.4

Co ector (J1): Co sole port ............................................................... 20

5.3.5

Co ector (J2): Exter al Battery Co ectio ....................................... 20

5.3.6

Co ector (JP1): Boot Selectio .......................................................... 21

Starter Kit (M-X6ULL-B) ............................................................................... 22

6.1

Features .............................................................................................. 22

6.2

Layout ................................................................................................. 23

6.3

Co ector a d Pi Defi itio ............................................................... 24

6.3.1

Co ector (CN1 ~ CN3) ...................................................................... 24

6.3.2

Co ector (CN4): GPIO ....................................................................... 25

6.3.3

Co ector (CN6): LCD / TTL ............................................................... 26

6.3.4

Co ector (CN7): LCD / TTL & Touch ................................................. 27

6.3.5

Co ector (CN8): LCD backlight +12Vdc ............................................ 28

6.3.6

Co ector (CN9): LCD backlight +5Vdc .............................................. 28

6.3.7

Co ector (CN10): Touch Se sor........................................................ 29

6.3.8

Co ector (CN11): LCD / LVDS .......................................................... 30

6.3.9

Co ector (CN16): RS-232.................................................................. 31

6.3.10

Co ector (CN17: RS-232) & (CN18: UART) ...................................... 31

M-X6ULL-B Hardware Guide

ARTILA

6.3.11

Co ector (J5): RS-485 ....................................................................... 32

6.3.12

Co ector (Co sole)............................................................................ 32

6.4

Jumper Setti g .................................................................................... 33

6.4.1

Jumper (JP1): LCD PWM Voltage Selectio ........................................ 33

6.4.2

Jumper (JP2): LCD Backlight Voltage Selectio .................................. 33

6.4.3

Jumper (JP3&JP4): Audio out Selectio .............................................. 34

Initial Operation ............................................................................................ 35

7.1

Usi g Default Li ux file system ............................................................ 35

7.2

I stall Software Package ..................................................................... 35

M-X6ULL-B Hardware Guide

ARTILA

1. Introduction

M-X6ULL-B is highly i tegrated, compact, low power co sumptio , the Li ux-Ready

arm Cortex-A7 System-o -Module.

It provides a ideal buildi g block that easily i tegrates with a wide ra ge of target

markets, such as i dustrial co trol, automatio gateway a d other applicatio s.

Li ux Ker el 5.4.x with Boot Loader & File system is pre-i stalled i the flash disk of

M-X6ULL-B a d ma y powerful utility programs are also i cluded. M-X6ULL-B is

ready to drop i your desig to save your time i software porti g a d hardware

debug.

1.1 Features

 NXP i.MX6ULL, a si gle arm Cortex-A7 core, 800MHz I dustrial grade Processor,

 512MB DDR3/LvDDR3 SDRAM

 16GB eMMC Flash

 Li ux Ker el 5.4.x with Boot Loader & File system

 24bits RGB display i terface, 4-wired resistive touch i terface

 1 x 10/100Mbps Ether et i terface with MAC/PHY a d tra sformer

 O e USB 2.0 Hi-speed (480Mbps) Host Ports a d O e USB Clie t port

 Four UARTs

 I

C / I

 15 Programmable Digital I/O Port (GPIO)

 O e Serial Peripheral I terface (SPI) Ports

 Compact size: 50 x 80mm

 Si gle +3.3VDC Power-i

1.2 Specifications (Hardware)

 CPU / Memory

 CPU: NXP i.MX6ULL

 Featuri g NXP’s adva ced si gle ARM Cortex®-A7 core

 Operates at speeds: 800MHz

 SDRAM: 512MB DDR3/LvDDR3 SDRAM

 Flash: 16G eMMC

 Network

 1x 10/100Mbps Ether et with PHY

 Sig al: EXT+, EXT-, ERX+, ERX-

 Protectio : 1.5 KV Mag etic isolated

M-X6ULL-B Hardware Guide

ARTILA

 USB Port

 1x USB 2.0 Hi speed (480Mbps) Host

Sig al: USB Host Data+, USB Host Data-

 1 x USB 2.0 Clie t

Device: DDP (data+), DDM (data-), UDIO (I/O)

 UART

 4x U iversal Asy chro ous Receiver a d Tra smitter (UART)

 UART 1~4: TXD, RXD, RTS, CTS (Software co figurable RS-232/485 mode)

 Sig al level: 3.3VDC

 Baud Rate: Up to 921.6 Kbps

 Parity: No e, Eve , Odd, Mark, Space

 Data Bits: 5, 6, 7, 8

 Stop Bits: 1, 1.5, 2

 Flow Co trol: RTS/CTS, XON/XOFF, No e

 RS-485 Bi-Directio Co trol Sig al: RTS for UART1~4

 Programma le DIO (GPIO)

 15Pi s Ge eral Purpose I/O ca be programmable as digital i put or output

 Sig al Level: TTL Compatible

 Digital I put:

- Low level: 0V mi / +0.99V max

- High level: +2.31V mi / +3.3V max

 Digital Output:

- Low level: +0.15V max @ 1mA

- High level: +3.15V mi @ 1mA

 SPI (Serial Peripheral Interface)

 O e SPI port

 Three wires sig als: MISO, MOSI a d CLK

 Sig al: MISO, MOSI, CLK, SD data 0~3

 De ug Port

 Sig al: Co ector: J1 (4-pi s Wafer)

 Power

 I put: +3.3VDC

 Co sumptio : 0.75W

M-X6ULL-B Hardware Guide

ARTILA

 Predefine Pins

 H/W Reset Butto (CN1, pi #11) , i put

 System Reset (CN1, pi #13), i put

 Buzzer (CN1, pi #22), output

 System Ready LED (CN1, pi #1), output

 LAN Activity LED (CN1, pi #3), output

 GPIO 15pi s (CN1, pi #10/12/14~21/23 & CN3, pi #31/33/35/37)

1.3 Specifications (Software)

 Operation System

 Li ux ker el 5.4.x

 Supports bootup from eMMC or SD card

 Boot Loader: Barebox

 File System: EXT4

 GUI E gi e: X11

 Software Development

 Toolchai : gcc 9.3.0 + glibc 2.31

 Supports i -place C/C++ code compilatio

 Package Management

 Package repository: Artila self-mai tai ed repository

 Comma d: Usi g sta dard apt-get comma d

 Popular Packages

 Web server: Apache/Ngi x/Lighttpd

 Database: MySQL/SQLite3/PostgreSQL

 Script La guage: PHP/Pytho /Perl/NodeJS

 Text editor: vim/ a o/sed

 Admi istratio : Webmi

 Utilities

 Bash: Shell Comma d

 Tel et: Tel et clie t program

 Busybox: Li ux utility collectio

 FTP: FTP clie t program

M-X6ULL-B Hardware Guide

ARTILA

 Protocol Stacks

 IPV4, ICMP, ARP, DHCP, NTP, TCP, UDP, FTP, HTTP, PPP, PPPoE, CHAP,

PAP, SNMP V1/V3, SSL, SSH 1/2

 Daemon

 pppd: Dial I /out over serial port a d PPPoE

 s mpd: SNMP age t program

 ftpd: FTP server program

 gi x: Web server program

 sshd: secured shell server

 iptables: Firewall service ma ager

 Standard Device Drivers

 ttymxc0: serial co sole port (CORTEX-A7 SERIES debug port)

 ttymxc1~ttymxc4: serial ports (CORTEX-A7 SERIES UART0~UART3)

 gpio: Ge eral Purpose I/O

 mmc: SD/MMC:

 rtc: Real Time Clock

 sda: USB flash memory disk

 ttyACM: USB Modem

 ttyUSB: USB RS-232 adaptor

 spi: spi bus

 I/O devices Control

Use sta dard I/O device co trol to access followi g devices:

 Ether et: eth1

 Serial Ports: ttymxc1, ttymxc2, ttymxc3, ttymxc4

 Serial Co sole Port: ttymxc0

 Real time clock: rtc0

 USB Flash Disk: sda, sda1, sdb, sdb1

 SD memory Card: mmc0

 USB Serial Cable: ttyUSB0, ttyUSB1

 SPI bus: spi0

M-X6ULL-B Hardware Guide

ARTILA

 Default Setting

 IP Default setti g:



eth1: 192.168.2.127 (Netmask: 255.255.255.0)

 ssh Logi : root

 Password: root

 Termi al type: VT100

1.4 Packing List

 M-X6ULL-B: Li ux-ready Cortex-A7 800MHz SoM (System o Module)

with 512MBSDRAM, 16GB eMMC Flash

1.5 Optional

 Starter Kit (detail i formatio refer to 6. Starter Kit (M-X6ULL-B))

 91-PHDF9-050: Co sole Cable (4Pi header to DB9 Female, 50cm)

Table des matières

Autres manuels Artila Matériel informatique

Artila

Artila Matrix-510 Manuel utilisateur

Manuels Matériel informatique populaires d'autres marques

EMC2

EMC2 VNX Series Manuel du propriétaire

Panasonic

Panasonic DV0PM20105 Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuel utilisateur

Raidon

Raidon iT2300 Manuel utilisateur

National Instruments

National Instruments PXI-8186 Manuel utilisateur

Hauppauge

Hauppauge WinTV-HVR-2250 Manuel utilisateur

Kontron

Kontron CP6002 Manuel utilisateur

Manhattan

Manhattan 702843 Manuel utilisateur

Aphex

Aphex 230 Manuel utilisateur

AMD

AMD Phenom II Manuel d'exploitation

Intel

Intel NUC 12 Pro Manuel utilisateur

dbx

dbx Zone Pro 1260 Manuel utilisateur

Galaxy

Galaxy GHDX2-2430S-24F4D Manuel utilisateur

Intel

Intel AXXRMFBU4 Manuel utilisateur

Kontron

Kontron DIMM-PC/MD Manuel utilisateur

ST X-NUCLEO-SAFEA1B Mode d'emploi

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuel utilisateur