- 6 -- 7 -
Safety and warning notes
• The device mu be connected to reverse osmosis. The company will not be
responsible for limescale damage if the device is not connected to reverse
osmosis.
• The inallation of the device mu be performed by a qualied technician
with the appropriate training
• The device is intended for residential use only
• The device mu be connected to a andard earthed single phase electrical
outlet, 230V
• The inlet water pressure mu not exceed 2.5 bar
• The indicator is lit only when the water is boiling
• If the syem does not produce water, check the syem's power source
• Do not clean the faucet with detergents and do not rub or scratch the
faucet.
• Cleaning the faucet
• Clean the faucet only with a damp cloth.
• During an extended absence of 24H or more, the device mu be
disconnected from the power supply
• Keep out of the reach of children
• The use of hot water mu be under the responsibility and supervision of an
adult only
• Warning: The heating unit is connected to the drainage syem in order to
remove excess water. Never touch and/or cancel this connection.
• The use of the device is under the sole responsibility of the user.
• Warranty of 12 months
To create the perfect solution, add
Aquachill and enjoy hot and cold water
with an extremely easy pouring!
Inallation Inructions
1. Read the inallation inructions
carefully and follow them
Ensure that all the accessories
are supplied:
• Steam device
• Pouring pipe
• Inlet pipe
• Drain pipe
• Inallation screws (3)
• Drain pipe clamp
• Power supply cable
• 3mm drill bit
2. Inall the faucet on the countertop
or the sink
Inalling Steam
3. Place the attached drawing in the
desired location.
• It is recommended to inall the
device in a raight line with the
faucet.
• The length of the pipe between
the device and the faucet shall not
exceed 40 cm.
4. Drill in the marked location using the
3 mm drill (supplied).
5. Fix the device with the supplied
screws.
6. Connect the pouring pipe to the
faucet.
7. Connect the drain pipe to the drain
Using the drain pipe clamp.
Warning: The drain hose clamp mu
be inalled above the syphon only!
8. Connect the inlet pipe to the water
supply (RO syem).
9. Fill the device with water.
10. Pour 3 liters of tap water to flush
the syem.
11. Warning: The device mu be
connected to the power supply
only after lling it with water and
flushing the syem!
12. Connect the device to the power
supply.
13. The device will art heating
automatically.
Inspection after initial inallation
1. Pour 3 cups of hot water and
ensure normal operation of the
syem
2. Ensure the indicator light is on
during the heating process
Recommended Inalation Diagram
Inlet pipe
Drain pipe
Straight pouring pipe
Max. pipe length -
40 cm
Heating
indication LED
