Alderon Industries™ - Leading Edge Control Products | 3
Mini Power Post™ - USER GUIDE
Introduction
Use the Mini Power Post™ to make a professional and safe connection for power and oat switch wiring connections to your
on-site septic system. The Mini Power Post™ eliminates a 4" x 4" wood post and the exposed wires for a safe, clean, and quick
installation. The Mini Power Post™ serves as a junction box which is connected to a remote alarm panel. This system can be
used for a wide variety of applications, including but not limited to: septic tanks, holding tanks, pump chambers, and water tanks.
Visit our website alderonind.com to view the different options and accessories. In addition, there are a variety of oat switches
that can be used with the Mini Power Post™.
Safety Guidelines
Before proceeding with the installation or operation of this product, read all instructions thoroughly, as well as complying with
all federal, state and local codes, regulations, and practices. This product must be installed by qualied personnel familiar with
all applicable local electrical and mechanical codes. Refer to the National Electrical Code (NFPA 70). Failure to properly install
and test this product can result in personal injury or equipment malfunction.
WARNING
1. DISCONNECT POWER when installing or servicing the product. Failure to disconnect all power sources could result in
serious injury or death.
2. NEVER enter a ooded space without proper Personal Protective Equipment (PPE). Always wear dielectric rubber boots
and other applicable protective equipment when water is on the oor and you must service an energized pump, alarm
system, or product.
3. DO NOT enter the water if the water level is higher than that of the protection your PPE offers or if your PPE is not
watertight.
4. DO NOT use this product with or near ammable liquids.
5. DO NOT install this product in locations classied as hazardous or in explosive atmospheres as dened by any applicable
electrical safety code.
