Albatron KN800 Manuel utilisateur
KN800
Copyright
All rights are reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a
retrieval system or translated into any language or computer language, in any form or by any means,
electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written
permission of the company. Brands and product names are trademarks or registered trademarks of their
respective companies.
The vendor makes no representations or warranties with respect to the contents herein and especially
disclaim any implied warranties of merchantability or fitness for any purpose. Further the vendor reserves
the right to revise this publication and to make changes to the contents herein without obligation to notify
any party beforehand. Duplication of this publication, in part or in whole, is not allowed without first
obtaining the vendor’s approval in writing.
Trademark
All the trademarks or brands in this document are registered by their respective owner.
Disclaimer
We make no warranty of any kind with regard to the content of this user’s manual. The content is subject
to change without notice and we will not be responsible for any mistakes found in this user’s manual. All
the brand and product names are trademarks of their respective companies.
FCC Compliance Statement
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
However, there is no guarantee that interference will not occur in a particular installation.
CE Mark
The device is in accordance with 89/336 ECC-ENC Directive.
V
er: EG100
Mainboard KN800
KN800
AMD®GeodeTM LX800 & CS5536
Support AMD®
GeodeTM LX800
Embedded Processor
User Manual
Dimensions (Nano-ITX form-factor):
102 mm x 146 mm ( W x L )
Operating System:
Windows®XP/ Linux
Mainboard KN800
Things You Have To Know
0The images and pictures in this manual are for reference only and may vary from the
product you received depending on specific hardware models, third party components
and software versions.
0This mainboard contains very delicate IC chips. Always use a grounded wrist strap
when working with the system.
0Do not touch any IC chip, lead, connector or other components.
0Always unplug the AC power when you install or remove any device on the mainboard
or when confuguring pins and switches.
Packing List
KN800 Mainboard
Mainboard Setup Driver & User Manual CD
Mainboard Quick Installation Guide
Symbols
Attention- Im
p
ortant Information
Follow the procedures below…
Refer to other sections in this manual…
Troubleshooting Tips
Mainboard KN800
Table of Contents
CHAPTER 1. GETTING STARTED ..................................................................1
INTRODUCTION....................................................................................................... 1
SPECIFICATION ....................................................................................................... 2
CONFIGURATION .................................................................................................... 5
Layout of KN800 Series (Right Side) ............................................................. 5
Layout of KN800 Series (Back Side) .............................................................. 6
Layout of KN800 Series (Right Side) ............................................................. 7
Layout of KN800 Series (Back Side) .............................................................. 8
HARDWARE INSTALLATION ................................................................................... 9
FAN Headers: FAN1 (Optional) ...................................................................... 9
Memory Installation: DIMM1 ......................................................................... 9
Back Panel Configuration.............................................................................. 10
Front Panel Headers: FPSWLED, SPK1 ....................................................... 12
Connectors ..................................................................................................... 13
Headers & Jumpers........................................................................................ 13
Slot................................................................................................................. 15
Power Supply Attachments............................................................................ 16
CHAPTER 2. BIOS SETUP............................................................................ 17
INTRODUCTION..................................................................................................... 17
MAIN MENU ......................................................................................................... 18
CHAPTER 3: SOFTWARE SETUP ............................................................... 20
SOFTWARE LIST ................................................................................................... 20
SOFTWARE INSTALLATION ................................................................................... 20
CHAPTER 4: TROUBLESHOOTING ............................................................ 23
APPENDIX I: RAID SETUP .................................................................................... 26
Mainboard KN800
1
Chapter 1. Getting Started
Introduction
Thanks for choosing KN800 Mainboard. It is based on AMD®GeodeTM LX800 Northbridge
chipset and AMD®GeodeTM CS5536 Southbridge chipset. In addition, it also supports
integrated AMD®GeodeTM LX800 Graphics Engine for onboard graphics feature. It supports
AMD®GeodeTM LX800 embedded processor with FSB (Front Side Bus) frequencies of 500
MHz.
The KN800 provides one DDR SO-DIMM socket which allows you to install 200-pin DDR 400
SO-DIMM. It supports a total memory capacity of 1 GB.
This mainboard provides one IDE connector for IDE hard drives, and one Mini IDE connector
for Mini IDE hard drives supporting Ultra ATA 133/100/66/33. In addition, one standard Mini
PCI slot for use with standard Mini PCI expansion cards is also allowed.
The KN800 provides one VGA (=D-Sub) connector (optional) and two USB 2.0/ 1.1 ports on
the back panel for use. Moreover, several headers are also available on the mainboard for two
COM Port headers (optional), one VGA external display (CN8) header (optional), and eight
GPIO (CN3 & CN2) headers (optional), and two USB 2.0 / 1.1 headers that can be connected
with cables for compliant devices. There are maximal four USB2.0/ 1.1 ports which can be set
up on this mainboard.
This mainboard also comes with two onboard 10/100/1000 Mbps Ethernet LAN chips
(RTL8110SC) (one is optional). There are two LAN ports on the back panel of your case that
you can directly plug into Internet cables.
The onboard AC’ 97 Audio CODEC (ALC655) supports high quality performance 2-channel
audio play.
The KN800 comes with the Silicon®Image chip supporting four SATA connectors (optional)
which provide up to 1.5 Gbps data transfer rates and also support RAID 0/ 1/ 0+1 mode <See
Appendix I>.
All the information (including hardware installation and software installation) in this manual are
for reference only. The contents in this manual may be updated without notice. The company
will not assume any responsibility for any errors or mistakes within.
Mainboard KN800
2
Specification
CPU:
Support AMD®GeodeTM LX800 embedded processor
Support 500 MHz FSB (Front Side Bus) Frequencies
Chipset:
Northbridge Chipset – AMD®GeodeTM LX800
Southbridge Chipset – AMD®GeodeTM CS5536
I/O Controller – Winbond®W83627HG-AW
AC’97 Audio Codec – Realtek®ALC655
Gbit LAN Controller – Realtek®RTL 8110SC
SATA Controller – Silicon®Image Sil3114CTU
Memory:
One DDR SO-DIMM socket
Supports 200-pin DDR 400 SO-DIMM
Supports a total memory capacity of up to 1 GB
Onboard AC’ 97 Audio CODEC:
High performance CODEC with high S/N ratio (>90 db)
Compliant with AC’ 97 2.3 specification
Support 2-channel audio play
Support 3D stereo enhancement
Slot:
One standard 32-bit Mini PCI slot for Mini PCI standard expansion card
Supporting one-way bandwidth up to 33 MB/s
IDE Connectors:
One Mini IDE Connector for two Mini IDE hard disk drives
Supports Ultra ATA 33/66/100/133
Supports high capacity hard disk drives
Mainboard KN800
3
Serial ATA Connectors (Optional):
Four SATA connectors
Supports SATA 1.0 specification and with 1.5 Gbps data transfer rates
One SATA connector can only support one SATA HDD
Supports RAID 0/ 1/ 0+1 mode
Onboard LAN Chip:
10/ 100/ 1000 Mbps Ethernet LAN supported
I/O facility Connectors
Supports one Mini-DIN PS/2 connector
Supports one VGA port (=D-Sub) (optional)
Supports one VGA external display (CN8) header (optional), eight GPIO (CN3 & CN2)
headers (optional), and two serial port (COM1 & COM2) headers (optional)
Universal Serial Bus:
Two onboard USB 2.0/ 1.1 ports
Two front USB headers come with this mainboard for additional two USB ports
Support a maximum of four USB ports to connect USB compliant devices
BIOS:
Phoenix-Award™ BIOS
Support APM1.2
Support ACPI 2.0 power management
Green Function:
Supports Phoenix-Award™ BIOS power management function
Supports system-wake-from-power-saving-mode by keyboard or mouse touching
Shadow RAM:
Integrated memory controller provides shadow RAM functionality and supports ROM
BIOS
Mainboard KN800
4
Flash Memory:
Supports flash memory functionality
Supports ESCD functionality
Hardware Monitor Function:
Monitors Chassis Fan Speed
Monitors CPU temperature
Monitors system voltages
Mainboard KN800
5
Configuration
Layout of KN800 Series (Right Side)
Mainboard KN800
6
Layout of KN800 Series (Back Side)
Table des matières
Autres manuels Albatron Matériel informatique
Manuels Matériel informatique populaires d'autres marques
EMC2
EMC2 VNX Series Manuel du propriétaire
Panasonic
Panasonic DV0PM20105 Manuel utilisateur
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur
Gigabyte
Gigabyte B660M DS3H AX DDR4 Manuel utilisateur
Raidon
Raidon iT2300 Manuel utilisateur
National Instruments
National Instruments PXI-8186 Manuel utilisateur
