7
Red Right channel positive (R+)
White Right channel negative (R-)
Green Left channel negative (L-)
To achieve the best sound reproduction, the cartridge must be precisely aligned on the head
shell. Position the included paper alignment tool over the spindle. Carefully lift the tone arm
and place the tip of the stylus on the points marked 130mm and 250mm. When the tip of the
stylus is placed precisely on these points, the cartridge should be perfectly parallel with the
reference lines on the alignment tool. If necessary, gently rotate the cartridge on the head shell
until the cartridge is parallel with the reference lines at the two points. Once the new cartridge
is positioned correctly, tighten the cartridge mounting screws.
NOTE: If you are unfamiliar or uncomfortable with completing this procedure, we recommend
consulting with a professional to perform the installation.
Blue Left channel positive (L+)
Installing New Cartridges
All cartridges with half inch mounting holes can be installed on this turntable. To install a new
cartridge, start by removing the two screws on the head shell, then remove the factory
installed cartridge. Carefully remove the wire leads from the factory cartridge, taking care not
to damage the wire leads. Leaving the protective cover on, position the new cartridge under
the head shell, aligning the screw holes. Insert one screw in each hole and very lightly tighten
(you will need to rotate the cartridge for final adjustment before fully tightening). Connect the
wire leads to the new cartridge as listed below.
