AEG 220 D Manuel utilisateur

220 D

Dunstabzugshaube

Fume Extractor Hood

Hotte aspirante

Afzuigkap

Cappa aspirante

Montage- und Gebrauchsanweisung

Installation and Operating Instructions

Instructions de montage et mode d'emploi

Montage- en gebruiksaanwijzing

Istruzioni di montaggio ed istruzioni per l'uso

Printed on recycled paper.

AEG – putting words into action.

Contents

Introduction 20

Extractor version 20

Filter version 21

Electrical connections 22

Safety warnings for electrician 22

Technical details 23

Installation 24

Safety warnings for kitchen unit installer 24

Wall unit mounting 26

Wall mounting 27

Hood operation 28

Safety warnings for user 29

Maintenance and care 30

Opening the grid 30

Grease filter 30

Carbon filter 31

Changing the light bulb 32

Cleaning 32

Special Accessories 33

Technical Assistance Service 33

Introduction

Extractor version

●The hood is supplied as an extractor unit and can also be

used with a filtering function by fitting activated carbon

filters (special accessory).

●The unit features two outlet holes, one of which Ais

located on the top of the unit while the other Bis located

on the rear.

●To connect up the hose, you should first fit the bayonet-

mounting flange C(Ø120 mm) on the outlet required (if

using the top outlet, fix the flange in place using the screw

supplied as shown in Fig. 1).

Close off the unused hole using the bayonet fitting caps D.

●Important! To use the back hole B, remove switch Ffrom

the top hole. — Fig 2.

●Move the lever Lto position A— Fig. 3.

●When connecting up the hood using a telescopic

wall pipe, you should preferably using an

uninflammable outlet hose ABS 120 (120 mm Ø)

E-Nr. 942 118 611 from our range of special

accessories.

Filter version

●The air is filtered and recirculated through the front grid.

●Move the lever Lto position F — Fig. 3.

You will need an original KFF activated carbon filter for

filtering function. (See special accessories).

Summer/Winter Hood Conversion

●To avoid excessive heat loss during the winter months, we

recommend that the hood be converted from outdoor

ventilation to ventless operation (air recycling).

●In order to convert the hood, a charcoal filter (special

accessory) is required. Follow the instructions for

operating the hood to recycle air.

●When the temperature outdoors becomes more mild

(spring), the filter can be removed and the hood

converted once again for outdoor ventilation. Please

consult the assembly instructions for operating the hood

with outdoor ventilation.

EXHAUSTING

ABLUFT

EVACUATION

ASPIRANTE

RECIRCULATION

UMLUFT

RECICLAGE

FILTRANTE

EXHAUSTING

ABLUFT

EVACUATION

ASPIRANTE

RECIRCULATION

UMLUFT

RECICLAGE

FILTRANTE

Electrical connections

Safety warnings for electrician

Check that the power supply voltage shown on the

rating plate corresponds to the mains supply before

proceeding to make any electrical connections. If the unit

is supplied ready-fitted with a plug, it can be connected

to any easily accessible socket installed in compliance

with the regulations in force.

If a fixed connection is required, the hood must be

installed exclusively by an electrician registered with the

local electrical company. The hood should be installed

using an omnipolar switch with contacts that open to at

least 3 mm.

Fused switches can be used for this purpose (with

cartridge fuses that can be extracted from the fuse

holder), as can automatic circuit breakers and contactors

which open to more than 3 mm.

We decline all responsibility for any problems or faults

caused by a failure to observe the above instructions.

Installing the socket directly above the hood or above

the wall unit mounted above the hood offers the

following advantages:

1. The socket cannot be seen.

2. The unit can be disconnected whenever required by

simply taking out the plug.

Electrical connections

220-230 V - using fixed power supply line with plug.

(The unit should only be connected up by an authorized

electrician).

Technical details

Dimensions:

Height x Width x Depth (in cm) 13 x 59,9 x 51

Weight:

Net: 6,9 kg

Gross: 7,8 kg

Maximum absorbed power: 205 W

Motor absorption 1 x 125 W

Lighting: 2 x 40 W

Length of the cable: 110 cm

Fan powers (speed), speed in compliance with DIN 44971

Extractor version:

1 115 m3/h

2 145 m3/h

3 180 m3/h

i 210 m3/h

Filter version:

1 110 m3/h

2 117 m3/h

3 125 m3/h

i 145 m3/h

Flange:120 mm Ø

Installation

●When used as an extractor unit, the hood must be fitted

with a 120mm diameter hose.

●If the fumes must be forced out through the wall, you

must obtain a MKZ sizable wall exhaust pipe (with

external exhaust and air intake), E-Nr.- 610 899 004 (Ø 120

mm) which is one of our optional parts.

●When installing the hood, make sure you respect

the following minimum distance from the top edge

of the cooking hob/ring surfaces:

electric cookers 650 mm

gas cookers 650 mm

coal and oil cookers 700 mm min.

●The hood cannot be connected to flues of other

appliances that run on energy sources other than

electricity.

●The air outlet must not be connected to chimney flues or

combustion gas ducts. The air outlet must under no cir-

cumstances be connected to ventilation ducts for rooms in

which fuel-burning appliances are installed.

●It is advisable to apply for authorization from the relevant

controlling authority when connecting the outlet to an

unused chimney flue or combustion gas duct.

The air outlet installation must comply with the

regulations laid down by the relevant authorities.

●When the unit is used in its extractor version, a

sufficiently large ventilation hole must be provided, with

dimensions that are approximately the same as the outlet

hole.

●National and regional building regulations impose a

number of restrictions on using hoods and fuel-burning

appliances connected to a chimney, such as coal or oil

room-heaters and gas fires, in the same room.

Safety warnings for kitchen unit installer

●The national decree on fuel-burning systems specifies a

maximum depression of 0.04 bar in such rooms.

●Hoods can only be used safely with appliances connected

to a chimney if the room and/or flat (air/environment

combination) is ventilated from outside using a suitable

ventilation hole approximately 500-600 cm2 large to

avoid the possibility of a depression being created during

operation of the hood.

If you have any doubts, contact the relevant controlling

authority or building inspector’s office.

●Since the rule for rooms with fuel burning appliances is

“outlet hole of the same size as the ventilation hole”, a

hole of 500-600 cm2, which is to say a larger hole, could

reduce the performance of the extractor hood.

●If the hood is used in its filtering function, it will operate

simply and safely in the above conditions without the

need for any of the aforementioned measures.

●When the hood is used in its extractor function, the

following rules must be followed to obtain optimal

operation:

— short and straight outlet hose

— keep bends in outlet hose to a minimum

— never install the hoses with an acute angle, they must

always follow a gentle curve only

— keep the hose as large as possible (120 mm Ø min.).

●Failure to observe these basic rules will drastically reduce

the performance and increase the noise levels of the

extractor hood.

213

Wall unit mounting

●Make the holes on the bottom of the cupboard, using

the drilling template .

●From inside the cupboard, insert the 4 supplied screws

and tighten them in the appropriate holes on the

appliance. — Fig. 4.

Table des matières

Autres manuels AEG hotte de ventilation

Manuels hotte de ventilation populaires d'autres marques

emmeti

emmeti RECUPA MED A-140 Mode d’emploi

Nibe

Nibe F135 Manuel utilisateur

Kuppersberg

Kuppersberg INTRO 60 Instructions d'installation et d'entretien

Zephyr

Zephyr Spruce AK9834BS Guide d'installation

Hisense

Hisense MH6INBG Manuel utilisateur

Miele

Miele DA 1255 Manuel utilisateur

Broan

Broan 46000 Manuel utilisateur

GE Profile PV977 Instructions originales

FALMEC

FALMEC FFRIA24W5FS Manuel utilisateur

Whirlpool

Whirlpool RH2600XL-1 SERIES Manuel utilisateur

Küppersbusch

Küppersbusch DX ISLA Manuel utilisateur

ETNA

ETNA AV360RVS Manuel utilisateur

JUNO

JUNO JDF603E6 Manuel utilisateur

Miele

Miele DA 6708 D Manuel utilisateur

Tricity Bendix

Tricity Bendix LE 150 Manuel

Smeg

Smeg KSEV97X Manuel utilisateur

Nibe

Nibe S Series Guide de l'utilisateur

Caple

Caple CCH100 Manuel