Advantech MIC-3401 Manuel utilisateur
MIC-3401/MIC-3401H
3U-sized, 8-slot Backplane
for CompactPCI ®
MIC-3401/MIC-3401H User's Manual
Copyright Notice
This document is copyrighted, 1999. All rights are reserved. The original
manufacturer reserves the right to make improvements to the products
described in this manual at any time without notice.
No part of this manual may be reproduced, copied, translated or transmitted
in any form or by any means without the prior written permission of the
original manufacturer. Information provided in this manual is intended to be
accurate and reliable. However, the original manufacturer assumes no
responsibility for its use, nor for any infringements upon the rights of third
parties which may result from its use.
Acknowledgements
PICMGTM, CompactPCI TM and the PICMG TM, CompactPCI TM logos are
trademarks of the PCI Industrial Computers Manufacturers Group
PXI is a trademark of National Instruments Corporation.
All other product names or trademarks are properties of their respective
owners.
Part Number: 2003340100 1st Edition
Printed in Taiwan May 1999
Preface and Table of Contents
Product warranty
Advantech warrants to you, the original purchaser, that each of its products
will be free from defects in materials and workmanship for one year from the
date of purchase.
This warranty does not apply to any products which have been repaired or
altered by persons other than repair personnel authorized by Advantech, or
which have been subject to misuse, abuse, accident or improper installation.
Advantech assumes no liability under the terms of this warranty as a conse-
quence of such events.
Because of Advantech’s high quality-control standards and rigorous testing,
most of our customers never need to use our repair service. If an Advantech
product is defective, it will be repaired or replaced at no charge during the
warranty period. For out-of-warranty repairs, you will be billed according to
the cost of replacement materials, service time and freight. Please consult
your dealer for more details.
If you think you have a defective product, follow these steps:
1. Collect all the information about the problem encountered. (For example,
CPU speed, Advantech products used, other hardware and software used,
etc.) Note anything abnormal and list any on-screen messages you get
when the problem occurs.
2. Call your dealer and describe the problem. Please have your manual,
product, and any helpful information readily available.
3. If your product is diagnosed as defective, obtain an RMA (return mer-
chandize authorization) number from your dealer. This allows us to
process your return more quickly.
4. Carefully pack the defective product, a fully-completed Repair and
Replacement Order Card and a photocopy proof of purchase date (such as
your sales receipt) in a shippable container. A product returned without
proof of the purchase date is not eligible for warranty service.
5. Write the RMA number visibly on the outside of the package and ship it
prepaid to your dealer.
MIC-3401/MIC-3401H User's Manual
Packing List
Before installation, ensure that the following materials have been
received:
* The MIC-3401/MIC-3401H backplane
* This user manual
If any of these items are missing or damaged, contact your distributor
or sales representative immediately.
Technical Support and Sales Assistance
If you have any technical questions about the MIC-3401/MIC-3401H
or any other Advantech products, please visit our support website at:
•http://support.advantech.com.tw
For more information aboutAdvantech's products and sales informa-
tion, please visit:
•http://www.advantech.com
Preface and Table of Contents
Contents
Chapter 1: Introduction .......................................................... 1
1.1 GeneralInformation...........................................................................2
1.2 Features.............................................................................................2
1.3 Specification......................................................................................3
Chapter 2:Hardware Configuration....................................... 5
2.1 Connector Locations.........................................................................6
2.2 Slot Assignments .............................................................................9
2.3 AlarmBoardInterface(CN2) ..........................................................13
2.4 FanModuleConnector(CN1)..........................................................14
2.5 PowerConnectors ...........................................................................14
2.6 GroundConfiguration ....................................................................19
2.7 ClockRoutingConfiguration .........................................................20
MIC-3401/MIC-3401H User's Manual
Figures
Figure 2-1. The connector locations on the front side ...................6
Figure 2-2. The connector locations on the rear side....................7
Figure 2-3. External Power Supply Terminal ...............................17
Figure 2-4. Mounting Holes Illustration .........................................19
Figure 2-5. ConfigurationResistors Locations .............................21
Tables
Table 2-1. ConnectorAssignments .................................................8
Table 2-2. System to Peripheral Slot Signal Assignment...........10
Table 2-3. Connector Pin Assignments of P1 and P2 (System
Slot) ............................................................................... 11
Table 2-4. Connector Pin Assignments of P1 and P2 (Peripheral
Slot) ...............................................................................12
Table 2-5. CN2Connector Pin Assignments.................................13
Table 2-6. CN1Connector Pin Assignments.................................14
Table 2-7. Power Module Connector ............................................15
Table 2-8. External Power Supply Terminal................................18
1
Introduction
CHAPTER
2MIC-3401/MIC-3401H User's Manual
1.1 General Information
The MIC-3401/MIC-3401H is a 3U-sized general-purpose backplane
that provides eight 32-bit or 64-bit (optional) CompactPCI slots. It
accepts a 2-slot (8TE) or 3-slot (12TE) wide processor module and
seven peripheral modules.
In order to provide users with a flexible system configuration, the
MIC-3401/MIC-3401H includes one standard ATX power connector
and an optional two IEC 603-2 (DIN 41612) connectors to accept one
ATX power supply or two 3U size plug-in power modules.
The MIC-3401/MIC-3401H provides a 6-pin connector for connect-
ing to up to 4 cooling fans. A 20-pin connector can be used for
connecting an external alarm module (MIC-3920/MIC-3921) to
detect system internal conditions, such as bus voltages and fan speed.
The MIC-3401H complies with PICMG 2.1 Hot-Swap Specification
providing full hot-swapping capability. Users can build a hot-swap
system using hot-swap plug-in boards and software.
1.2 Features
- Eight 32-bit CompactPCI slots (64-bit upon request)
- Supports hot-swappable modules (MIC-3401H)
- Accepts one ATX power supply or two plug-in power modules
(optional, upon request)
- Alarm board interface
- Fan interface
Chapter 1 Introduction 3
1.3 Specification
l8 CompactPCI slots (one system slot and 7 peripheral slots)
lBus width: 32-bit (64-bit upon request)
l8-layer PCB, 3.0 mm thick
lSeparate power and ground planes
lPower connectors:
ØOneATX power connector for connecting standard ATX power
supply
ØScrew terminals (on rear side) for external power inputs
ØTwo IEC 603-2(DIN 41612) power connectors for two 2-slot wide
plug-in power modules. (the connectors are upon reguest)
l20-pin connector for MIC-3920/MIC-3921 alarm board signals
lComplies with CompactPCI Specification PICMG 2.0, Ver.2.1
lComplies with CompactPCI Hot Swap Specification PICMG 2.1,
Ver.1.0 (MIC-3451H)
lV I/OVoltage: 3.3V or 5V, jumper selectable
lSupports PXI star trigger signals (optional)
lLogic Ground and Chassis Ground can be isolated or common
lDimensions: 262.8 x 128.6 mm
lOperating temperature: -40 ~ 80°C (-40 ~ 176°F)
4MIC-3401/MIC-3401H User's Manual
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Advantech Carte PCI
Advantech
Advantech DSPC-8661-PCXE Manuel utilisateur
Advantech
Advantech MIO-5393 Manuel utilisateur
Advantech
Advantech PCA-684 Manuel utilisateur
Advantech
Advantech ECU-P1706 Manuel d'installation et d'exploitation
Advantech
Advantech PCIE-1761H Manuel utilisateur
Advantech
Advantech PCI-1742U Manuel d'installation et d'exploitation
Advantech
Advantech PCI-1602UP Manuel utilisateur
Advantech
Advantech PCI-1733 Manuel d'installation et d'exploitation
Advantech
Advantech MIC-3612/3-BE Manuel utilisateur
Advantech
Advantech PCIE-1763AH Manuel utilisateur
Advantech
Advantech MOS-1110Y-0101E Manuel utilisateur
Advantech
Advantech PCIE-1752 Manuel utilisateur
Advantech
Advantech PCA-5630 Manuel d'installation et d'exploitation
Advantech
Advantech PCIE-1760 Manuel utilisateur
Advantech
Advantech PCI-1761 Manuel utilisateur
Advantech
Advantech PCI-1240 Manuel utilisateur
Advantech
Advantech PCI-1710U Manuel d'installation et d'exploitation
Advantech
Advantech PCI-1713 Manuel utilisateur
Advantech
Advantech PCIE-1753 Manuel utilisateur
Advantech
Advantech PCI-1710U-DE Manuel utilisateur
Manuels Carte PCI populaires d'autres marques
Belkin
Belkin F5D7000F Manuel utilisateur
Pericom
Pericom PI7C7100 Manuel utilisateur
ADLINK Technology
ADLINK Technology cPCI-3548 Manuel utilisateur
Digium
Digium TE200 Series Manuel utilisateur
Allo.com
Allo.com 2nd Gen E1/T1/J1 Manuel utilisateur
Western Digital
Western Digital FireWire PCI Adapter Manuel utilisateur