Advantech FPM-2150G Series Manuel utilisateur
FPM-2150G Series
Flat Panel Monitor with
15" Color TFT/LCD Display
User's Manual
iiFPM-2150GUser's Manual
Copyright Notice
This document is copyrighted by Advantech Co., Ltd. All rights are
reserved. Advantech Co., Ltd. reserves the right to make
improvements to the products described in this manual at any time.
Specifications are thus subject to change without notice.
No part of this manual may be reproduced, copied, translated, or
transmitted in any form or by any means without the prior written
permission of Advantech Co., Ltd. Information provided in this manual
is intended to be accurate and reliable. However, Advantech Co., Ltd.,
assumes no responsibility for its use, nor for any
infringements upon the rights of third parties which may result from its
use.
All brand and product names mentioned herein are trademarks or
registered trademarks of their respective holders.
iii
FCC Class B
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a residential
environment. This equipment generates, uses and can radiate radio
frequency energy. If not installed and used in accordance with this
user's manual, it may cause harmful interference to radio communica-
tions. Note that even when this equipment is installed and used in
accordance with this user’s manual, there is still no guarantee that
interference will not occur. If this equipment is believed to be causeing
harmful interference to radio or television reception, this can be
determined by turning the equipment on and off. If the interference is
occurring, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment to a power outlet on a circuit different from
that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
ivFPM-2150G User's Manual
Packing List
Before installing your equipment, make sure that the following
materials have been received:
•FPM-2150G Series flat panel monitor
• Accessory pack, including:
- AC/DC adapter
- Power Chord
- Video signal cable, 1.8m
- Keyboard/mouse Y cable
- AC/DC power adapter bracket
-Hook wall-mounted bracket (in FPM-2150G)
- Four fixed panel-mounted bracket
-Mounting bracket (in FPM-2150G)
-RS-232 cable, 1.8m (FPM-2150G-R only)
-Keyboard/mouse 1.8m cable
- Driver/manual CD-ROM
If any of these items are missing or damaged, contact your
distributor or sales representative immediately.
Additional Information and Assistance
1. Visit the Advantech web site at www.advantech.com where you can
find the latest information about the product.
2. Contact your distributor, sales representative, or Advantech's
customer service center for technical support if you need
additional assistance. Please have the following information ready
before you call:
• Product name and serial number
• Description of your peripheral attachments
• Description of your software (operating system, version,
application software, etc.)
• A complete description of the problem
• The exact wording of any error messages
v
Safety Instructions
1. Read these safety instructions carefully.
2. Keep this User's Manual for later reference.
3. Disconnect this equipment from any AC outlet before cleaning. Use a damp
cloth. Do not use liquid or spray detergents for cleaning.
4. For plug-in equipment, the power outlet socket must be located near the
equipment and must be easily accessible.
5. Keep this equipment away from humidity.
6. Put this equipment on a reliable surface during installation. Dropping it or letting
it fall may cause damage.
7. The openings on the enclosure are for air convection. Protect the equipment
from overheating. DO NOT COVER THE OPENINGS.
8. Make sure the voltage of the power source is correct before connecting the
equipment to the power outlet.
9. Position the power cord so that people cannot step on it. Do not place anything
over the power cord.
10. All cautions and warnings on the equipment should be noted.
11. If the equipment is not used for a long time, disconnect it from the power source
to avoid damage by transient overvoltage.
12. Never pour any liquid into an opening. This may cause fire or electrical shock.
13. Never open the equipment. For safety reasons, the equipment should be opened
only by qualified service personnel.
14. If one of the following situations arises, get the equipment checked by service
personnel:
a. The power cord or plug is damaged.
b. Liquid has penetrated into the equipment.
c. The equipment has been exposed to moisture.
d. The equipment does not work well, or you cannot get it to work according to
the user's manual.
e. The equipment has been dropped and damaged.
f. The equipment has obvious signs of breakage.
15. DO NOT LEAVE THIS EQUIPMENT IN AN UNCONTROLLED
ENVIRONMENT WHERE THE STORAGE TEMPERATURE IS BELOW
-20° C (-4° F) OR ABOVE 60° C (140° F). THIS MAY DAMAGE THE
EQUIPMENT.
The sound pressure level at the operator's position according to IEC 704-1:1982
is no more than 70dB(A).
DISCLAIMER: This set of instructions is given according to IEC 704-1. Advantech
disclaims all responsibility for the accuracy of any statements contained herein.
viFPM-2150G User's Manual
Wichtige Sicherheishinweise
1. Bitte lesen sie Sich diese Hinweise sorgfältig durch.
2. Heben Sie diese Anleitung für den späteren Gebrauch auf.
3. Vor jedem Reinigen ist das Gerät vom Stromnetz zu trennen.
Verwenden Sie Keine Flüssig-oder Aerosolreiniger. Am besten dient
ein angefeuchtetes Tuch zur Reinigung.
4. Die NetzanschluBsteckdose soll nahe dem Gerät angebracht und leicht
zugänglich sein.
5. Das Gerät ist vor Feuchtigkeit zu schützen.
6. Bei der Aufstellung des Gerätes ist auf sicheren Stand zu achten. Ein
Kippen oder Fallen könnte Verletzungen hervorrufen.
7. Die Belüftungsöffnungen dienen zur Luftzirkulation die das Gerät vor
überhitzung schützt. Sorgen Sie dafür, daB diese Öffnungen nicht
abgedeckt werden.
8. Beachten Sie beim. AnschluB an das Stromnetz die AnschluBwerte.
9. Verlegen Sie die NetzanschluBleitung so, daB niemand darüber fallen
kann. Es sollte auch nichts auf der Leitung abgestellt werden.
10. Alle Hinweise und Warnungen die sich am Geräten befinden sind zu
beachten.
11. Wird das Gerät über einen längeren Zeitraum nicht benutzt, sollten
Sie es vom Stromnetz trennen. Somit wird im Falle einer Überspan-
nung eine Beschädigung vermieden.
12. Durch die Lüftungsöffnungen dürfen niemals Gegenstände oder
Flüssigkeiten in das Gerät gelangen. Dies könnte einen Brand bzw.
elektrischen Schlag auslösen.
13. Öffnen Sie niemals das Gerät. Das Gerät darf aus Gründen der
elektrischen Sicherheit nur von authorisiertem Servicepersonal
geöffnet werden.
14. Wenn folgende Situationen auftreten ist das Gerät vom Stromnetz zu
trennen und von einer qualifizierten Servicestelle zu überprüfen:
a - Netzkabel oder Netzstecker sind beschädigt.
b - Flüssigkeit ist in das Gerät eingedrungen.
c - Das Gerät war Feuchtigkeit ausgesetzt.
d - Wenn das Gerät nicht der Bedienungsanleitung entsprechend
funktioniert oder Sie mit Hilfe dieser Anleitung keine Verbesserung
erzielen.
e - Das Gerät ist gefallen und/oder das Gehäuse ist beschädigt.
f - Wenn das Gerät deutliche Anzeichen eines Defektes aufweist.
Der arbeitsplatzbezogene Schalldruckpegel nach DIN 45 635 Teil 1000 beträgt
70dB(A) oder weiger.
DISCLAIMER: This set of instructions is given according to IEC704-1. Advantech
disclaims all responsibility for the accuracy of any statements contained herein.
vii
Contents
Copyright Notice ................................................................................... ii
Packing List ......................................................................................... iv
Additional Information and Assistance ............................................... iv
Safety Instructions ................................................................................ v
Wichtige Sicherheishinweise ............................................................. vi
CHAPER 1 Introduction ................................... 1
1.1 Introduction .......................................................................... 2
1.2 Specifications........................................................................ 2
1.3 LCD Specification ................................................................ 3
1.4 Power Consumption ............................................................ 3
1.5 Connectors ........................................................................... 4
1.5.1 PS/2 connectors .......................................................................... 5
1.6 Dimensions ........................................................................... 6
CHAPER 2 System Setup ................................ 7
2.1 Mounting the Monitor ........................................................ 8
2.1.1 Wall Mounting .............................................................................. 8
2.1.2 Panel Mounting ........................................................................... 9
2.1.3 Rack Mounting ............................................................................ 9
2.2 Desktop, Swing-ARM for VOP-1150TV ........................ 10
2.2.1 Desktop Stand .......................................................................... 10
2.2.2 Swing-ARM ................................................................................ 11
2.2.3 Power adapter ........................................................................... 12
APPENDIX A Display Timing Mode and OSD .
.......................................................................... 14
A.1 Supported Input Timing Modes ..................................... 15
A.2 Keypad Interface .............................................................. 16
A.3 OSD Function .................................................................... 17
viii FPM-2150G User's Manual
Figures
Figure 1-1: Dimensions ................................................................................. 6
Figure 2-1: Wall Mounting .............................................................................. 8
Figure 2-2: Panel Mounting ........................................................................... 9
Figure 2-3: Rack mounting ............................................................................ 9
Figure 2-4: Desktop Stand for the VOP-1150 series ................................. 10
Figure 2-5: Swing-ARM for the VOP-1150 series ...................................... 11
ix
Tables
Table A.1 Supported Input Formats ............................................................ 15
Introduction
This chapter includes:
•Introduction
•Specifications
•LCD Specification
•Power Consumption
•Connectors
•Dimensions
CHAPTER
1
Table des matières
Autres manuels Advantech Moniteur
Advantech
Advantech FPM-3170 Series Manuel utilisateur
Advantech
Advantech IDK-1112P-50XGA1 Manuel utilisateur
Advantech
Advantech IDK-2108 Series Manuel utilisateur
Advantech
Advantech FPM-5152G Series Manuel utilisateur
Advantech
Advantech LEO-D Series Manuel utilisateur
Advantech
Advantech IDK-1107WR-50WVB1 Manuel utilisateur
Advantech
Advantech FPM-40T Manuel utilisateur
Advantech
Advantech FPM-3150 Series Manuel utilisateur
Advantech
Advantech IDK-1108R-45SVA1E Manuel utilisateur
Advantech
Advantech IDS-3117 Series Manuel utilisateur
Advantech
Advantech FPM-2150G-XCE Manuel utilisateur
Advantech
Advantech IDS-3121W Series Manuel utilisateur
Advantech
Advantech IDK-2115N-K2XGB2 Manuel utilisateur
Advantech
Advantech PAX-332 Series Manuel utilisateur
Advantech
Advantech IDK-1121WR-30FHA1E Manuel utilisateur
Advantech
Advantech IDS-3206 Series Manuel utilisateur
Advantech
Advantech PAX-327 Series Manuel utilisateur
Advantech
Advantech IDS-3115 Series Manuel utilisateur
Advantech
Advantech POC-W181 Manuel d'instructions
Advantech
Advantech POC-WP242 Manuel utilisateur
