Advantec ASMB-587 Manuel d'installation et d'exploitation
ASMB-587 Startup Manual 1
Before you begin installing your card, please make sure that
the following items have been shipped:
• 1 Startup manual
• 2 Serial ATA HDD data cables
• 2 Serial ATA HDD power cables
• 1 COM cable (for connection to real panel)
• 1 I/O port bracket
• 1 Warranty card
• 1 JFP1 cable
If any of these items are missing or damaged, please con-
tact your distributor or sales representative immediately.
Note: Acrobat Reader is required to view any PDF
le.AcrobatReadercanbedownloadedat:
http://www.adobe.com/downloads/ (Acrobat is a
trademark of Adobe)
ASMB-587 LGA 1200 Intel®Xeon®W & 10th Gen. Core™
MicroATX Server Board with 4 x DDR4, 3 x PCIe,
6 x USB 3.2, 5 x SATA3, Quad/Dual LANs, and IPMI
Startup Manual
Standard Functions
• CPU: LGA 1200 Intel®Xeon®W and 10th Gen. Core™ i9/
i7/i5/i3 processor
• BIOS: AMI 256 Mb SPI BIOS
• Chipset: Intel W480E
• System memory: Dual Channel DDR4 ECC/Non-ECC
2933/2666/2400MHzunbueredDIMM,Max.128GB
Note: Due to the inherent limitations of PC architecture,
the system may not fully detect 128 GB RAM
when 128 GB RAM is installed.
• SATA3 interface: 5xSATA36Gb/sportstosupportIntel
Rapid Storage Technology with software RAID 0, 1, 10 &
5 (for Windows only)
• Serial ports: Two serial ports onboard, only support RS-
232 (one can be in rear IO via COM cable connection)
• Keyboard/mouse connector: Supports standard PS/2
keyboard and mouse via KMBS1 pin header
• Watchdog timer: 255 level timer intervals (sec/min)
• USB 3.2: SupportsuptosixUSB3.2ports,fourGen2
ports in rear I/O and two Gen1 ports from on-board pin
header
• USB 2.0: SupportsuptosevenUSB2.0ports(1*Type-A)
Display Interface
• Chipset: CPUintegratedIntelHDgraphicscontroller
• Display memory: 1GBmaximumsharedmemorywith
2 GB and above system memory installed (BIOS default
is 256 MB)
• Resolution:
-SupportsVGAupto1920x1200resolution@60Hz
refresh rate
-SupportsDVIupto1920x1200resolution@60Hz
refresh rate
-SupportsHDMI2.0upto2K/4Kresolution@60Hz
Ethernet Interface
• Interface: 10/100/1000 Mbps
• Controller: LAN1: Intel
®
I219LM; LAN2 ~ LAN4: Intel
®
I210AT
(LAN2isBMCsharedNIC;LAN3/4isforG4SKUonly)
Mechanical and Environmental
• Dimensions (L x W): 244x244mm(9.6”x9.6”)
• Power supply voltage: +3.3 V, +5 V, ±12 V, 5 Vsb
• Power consumption: Max.load:+3.3V@0.75A,+5V@
1.43A,+12V@0.66A,+12V(8P)@7.08A,+5Vsb@
0.13 A
• Operating temperature: 0~60°C(dependsonCPUspeed
and cooler solution)
• Weight: 0.5 kg (weight of board)
For more information on this and other Advantech prod-
ucts, please visit our website at:
http://www.advantech.com
For technical support and service, please visit our sup-
port website for ASMB-587 at:
https://advt.ch/asmb587
Register your products on our website and get 2 months
extrawarrantyforFREEat:
http://www.register.advantech.com
This manual is for the ASMB-587 series Rev. A1.
Part No. 2041058700
Printed in China
1st Edition
October 2020
Packing List Specications
2 ASMB-587 Startup Manual
Connector list
SATA0~4 SATA III (6 Gb/s)
SMBUS1 SMBus from PCH
SYS_LED1 System Information LED Con-
nector
SYSFAN0,SYSFAN1,
SYSFAN2,SYSFAN3 System FAN connector
SPI_CN1 SPIashcardpinheader
SPDIF_OUT1 SPDIF Audio output pin header
USB5_6 USB3.2gen1Port(Header)
USB7_8,USB9_10,
USB11_12 USB2.0port(Header)
USB13 USB2.0port(USBTypeA)
Jumper list
Label Function
HDMI_I2C1 For RD debugging
JCMOS1 CMOS clear
JME1 Intel ME Disable Jumper for
ME/BIOS update
JWDT1 Watchdog reset
JUSB_1
RearwindowUSB3.2Gen2
port power source switch
between +5 VSB and +5 V
JUSB_2
OnboardUSB2.0/3.2Gen1port
power source switch between
+5 VSB and +5 V
JCASE1 Case open
JPEG1, JPEG2 x16orx8x8orx8x4x4forslot-6
JPEG3 Default (1-2)/reserve for RD
debug (2-3)
JPSMB1, JPSMB2 PCIESLOTSMBUSconnector:
to PCH (1-2)/ to BMC (2-3)
JSMB1 For RD debugging
JTHR_SEL1 Selectsonboardorexternal
thermistor
PSON1 AT(1-2)/ATX(2-3)
The board has a number of jumpers that allow you to con-
gureyoursystemtosuityourapplication.Thetablebelow
lists the function of each jumper and connector.
Connector list
Label Function
ATXPWR1 ATX 24-pin main power connec-
tor (for System)
ATX12V1 8-pinpowerconnector(forCPU)
AUDIO1~2 Audio connector
BAT1 For RTC battery
BAT2 For optional battery kit
BIOS_SKT1 BIOS SPI ROM
BMC2
BMC connector to support
IPMI-1000 module (P/N: IPMI-
1000-00A2E)
COM1, COM2 Serial port: RS-232
CPUFAN0 CPUFANconnector
DIMMA0, DIMMA1,
DIMMB0, DIMMB1 DDR4 288-pin slot
DVI1 DVI connector
EX_THR1 Forexternalthermistorcablekit
FPAUD1 Front Panel Audio Header
GPIO1 8-bit GPIO header
HDMI1_VGA1 HDMI + VGA connector
JFP1
Power Switch/Power Reset/
LANLED1/LANLED2/
HDD LED/Power LED
Power LED Behavior:
• Suspend:Fastash(ATX/AT)
• System On: ON (ATX/AT)
• SystemO:OFF(ATX/AT)
KBMS1 Externalkeyboardandmouse
connector (6-pin)
LAN1_USB1_2,
LAN2_USB3_4
LAN1/USB3.2Gen2port1,2
stack connector
LAN2/USB3.2Gen2port3,4
stack connector
LAN3_LAN4 LAN3 & LAN4 connector
LPC1, LPC2
Low pin count connector
for Advantech TPM and
RS232/422/485 module
M2_2280_1 M.2 22110/2280 (PCIe/SATA)
PCIEX4_SLOT4,
PCIEX4_SLOT7 PCIex4slot(Gen3x4link)
PCIEX16_SLOT6 PCIex16slot(Gen3x16link)
PMBUS1 PMBUSconnectortocommuni-
cate with power supply
Jumpers and Connectors
Jumpers and Connectors (Cont.)
ASMB-587 Startup Manual 3
PCIEX16_Slot6Conguration(JPEG1,JPEG2)
Function JPEG1 JPEG2
Slot6 PCIe
x16(default)
1-2 closed 1-2 closed
Slot6 PCIe
x8+x8
2-3 closed 1-2 closed
Slot6 PCIe
x8+x4+x4
1 2 3
2-3 closed
1 2 3
2-3 closed
JCMOS1/JME1: CMOS clear/ME update function
Closed pins Result
1-2
KeepCMOSdata/DisableMEupdate*
2-3 Clear CMOS data/Enable ME update
*:Default
Keep CMOS data/ Clear CMOS data/
Disable ME update Enable ME update
JWDT1: Watchdog timer output option
Closed Pins
Result
1-2 Systemreset*
2-3 NC
*:Default
PSON1:ATX,ATmodeselector
Closed Pins
Result
1-2 AT Mode
2-3 ATXMode*
*:Default
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
System Reset 1-2 Closed NC 2-3 Closed
1 2 3
1 2 3
AT Mode 1-2 closed ATX Mode 2-3 closed
1 2 3
1 2 3
Caution! The computer is supplied with a battery-powered
realtimeclockcircuit.Thereisadangerofexplo-
sion if battery is incorrectly replaced. Replace
only with same or equivalent type recommended
by the manufacturer. Discard used batteries ac-
cording to manufacturer’s instructions.
This device complies with the requirements in Part 15 of
the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired opera-
tion.
2.0 mm JFP connector on board
Description Pin Number Description
RST BTN
1PWD BTN
PWD GND
43PWD GND
LAN1_LED+
6
5
LAN2_LED+
LAN1_LED -
8
7
LAN2_LED-
CRPS Detect
10 9SYS_LED+
GND
12 11 SYS_LED-
PWR LED+
14
13
HDD_LED+
PWR LED-
16
15
HDD_LED-
▼
2
2.0 mm JFP connector to 2.54 mm Pitch Header
Description
Pin Number
Description
(Red) PWD BTN
▼12RST BTN (White)
(Black) PWD GND
3
4
PWD GND (Black)
(Blue) LAN1_LED+
56LAN2_LED+ (Brown)
(Red) LAN1_LED -
78LAN2_LED - (Black)
Key
(Orang) HDD_LED+
13
14
PWR LED+ (Red)
(Black) HDD_LED -
15
Key 16 PWR LED - (Black)
SATA storage mapping table
Connector Label BIOS Menu Intel Rapid Storage
Technology
SATA0 SATA0 Internal empty port 3
SATA1 SATA1 Internal empty port 4
SATA2 SATA2 Internal empty port 5
SATA3 SATA3 Internal empty port 6
SATA4 SATA4 Internal empty port 7
Jumpers and Connectors (Cont.)
Installation Note
Declaration of Conformity
4 ASMB-587 Startup Manual
Board Layout: Jumper and Connector Locations
HDMI1_VGA1
LAN3_LAN4
DVI1
LAN2_USB3_4
COM2
Intel LGA1200 Socket
USB9_10
KBMS1
USB13
USB5_6
Intel W480E PCH PMBUS1
BMC2
DIMM A0
LAN1_USB1_2
AUDIO1~2
PCIEX4_SLOT4
PCIEX16_SLOT6 PCIEX4_SLOT7
COM1_
DIMM A1
DIMM B0
DIMM B1
FDAUD1
USB11_12
USB7_8
JPEG1~3
SYS_LED1
JCMOS1
SYSFAN0
GPIO1
PSON1
JFP1
SMBUS1
LPC1~2
SPI_CN1
SATA0~4
JUSB_2
JCASE1
JME1
SPDIF_OUT1
SYSFAN3
CPUFAN0
JUSB_1
BAT1
M2_2280_1
EX_THR1
SYSFAN1~2
JPSMB1~2
JTHR_SEL1
JWDT1
BIOS_SKT1
BAT2
ATXPWR1
ATX12V1
JSMB1
HDMI_I2C1
Board Layout
Manuels Matériel informatique populaires d'autres marques
EMC2
EMC2 VNX Series Manuel du propriétaire
Panasonic
Panasonic DV0PM20105 Manuel utilisateur
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur
Gigabyte
Gigabyte B660M DS3H AX DDR4 Manuel utilisateur
Raidon
Raidon iT2300 Manuel utilisateur
National Instruments
National Instruments PXI-8186 Manuel utilisateur
