Industrial Electronic Devices
ADFweb.com Srl – IT31010 – Mareno – Treviso INFO: www.adfweb.com hone +39.0438.30.91.31
Document code: MN67412_ENG Revision 1. Page 8 of 25
CHARACT RISTICS:
The “CAN from/to Modbus Slave” Gateway has the following characteristics:
Two-directional information between networks CAN and Modbus;
Metal Enclosure with four fixing lugs;
Triple isolation between CAN - Power supply and between CAN – RS485 and between RS485 – Power supply;
Varnished and optionally resined;
Temperature range -4 °C to 1 5°C.
The Gateway can be configured up to a maximum 5 CAN bus frame in reading and 5 CAN bus frame in writing.
Note:
The HD67412-E7x-xxx is furnished with 1 cm cable length.
CONFIGURATION:
The “CAN from/to Modbus Slave” Gateway allows a CAN network to communicate with a Modbus network.
You need Compositor SW67412 software on your PC in order to perform the following:
Define the parameters of two buses;
Define which Modbus Registers are reading from CAN frame;
Define which Modbus Registers are writing from CAN frame;
Update the device.
US OF COMPOSITOR SW67412:
To configure the “CAN from/to Modbus Master” Gateway, use the
available software that runs with Windows, called SW67412. It is
downloadable on the site www.adfweb.com and its operation is
described in this document. (This manual is referenced to the last
version of the software present on our web site). The software works
with MSWindows (MS 2 , XP, Vista, Seven). When launching the
SW67412 the right window appears (Fig. 2).
Figure 2: Main window for SW67412
