NOTICE: THE WRITTEN INSTRUCTIONS CONTAINED HEREIN ARE COPYRIGHTED.
A
A
A
A
9
B=10 G=02E=01
(300E)
F=01
(300D)
D=06
2x B
B
B
4 x 30
mm
Screw
ASSEMBLE THE DRAWER
3.5 x 14
mm
Screw
Left
Drawer
Runner
Right
Drawer
Runner
Knob
B
B
B
B
G
F
D
D
D
DED
D
STEP 14 - E
With the drawer upside down,
•Align the left drawer runner (300E) (part E) with the wheel on the outside
toward the drawer back (part 13). Make sure the opposite end is all
the way forward touching the drawer front (part 09), as shown.
•Secure the left drawer runner (300E) (part E) to the left drawer side (part
11) using 3 screws (part D).
•The first screw (part D) goes through the 3rd hole back from the drawer
front (part 09) and into the left drawer side (part 11).
•The second screw (part D) goes through the center hole of the runner
(300E) (part E) into the left drawer side (part 11).
•The third screw (part D) goes through the last hole in the runner (300E)
(part E) closest to the drawer back (part 13) on the outside by the wheel
as shown.
•Repeat these steps to attach the (300D) right drawer runner (part F) to
the right drawer side (part 12).
67(34'
•Attach the knobs (part G) to the drawer
front (part 09) by inserting the screw
(part B) through the back of the drawer
front (part 09) and into the back of the
knob (part G). (2 extra part G knobs
supplied.)
$OOVFUHZVSDUWV%'VKRXOGEHWLJKWEXWGR
QRWIRUFHRUWU\WRRYHUWLJKWHQDVWKLVPD\FDXVH
GDPDJHWRWKHXQLW
7XUQ
'UDZHU
2YHU
B
G
B
09
10
11
12
13
14 14
09
11
09
09
11
11
12
12
14
13
STEP 14 - A
•Using the dowels (part A) inserted into parts 11 and 12 in step 1, align the
drawer sides (parts 11 & 12) with the drawer front (part 09).
•Make sure the groove for the drawer bottom (part 14) is precisely aligned
on all 3 parts (09, 11 & 12) then push together until flush.
•Secure the drawer sides (parts 11 & 12) to the drawer front (part 09) using
2 screws (part B) on each side as shown in the illustration.
•Screws (part B) should be tight, but do not force or over-tighten as this
could cause the wood to split.
STEP 14 - B
•Slide the drawer bottom (part 14) into
the grooves on parts 09, 11 and 12 as
shown
STEP 14 - C
•Align the groove in the drawer back (part
13) with the drawer bottom (part 14) and in
between the drawer sides (parts 11 & 12).
•Secure the drawer back (part 13) to the
drawer using 2 screws (part B) on each
side, as shown.
(300E)
