Uplift Desk STR018 Manuel utilisateur

Step 3

Mark the center of each hole with a pencil, and place the Hous-

ing to the side.

If you own a drill, you can make pilot holes to make installation

easier. Use it with a 1/8” diameter drill bit and, ensuring that you

DRILL NO DEEPER THAN 1/2”, drill pilot holes where you’ve

made your pencil marks.

Step 1

Slide the Drawer out from its Housing.

Step 2

Determine the placement of the drawer before mounting it by

holding the Housing under your desk, just about ush with the

front edge of the desktop.

Note:

Some thicker UPLIFT desktops are built with metal support

bars embedded in the bottom side for support. They are clearly

visible when looking under the desk. Be mindful of where your

drawer will be going. When choosing its placement, do not place

the holes directly over the support bars. If you must place it near

a support bar, straddle the holes on the Housing on either side of

the support bar. (see g 1)

(g 1)

Housing Drawer Stop bar

Package Contents

Bamboo Desk Drawer

SKU: STR018

Short wood screw

(qty 3)

Long wood screw

(qty 4)

Step 4

Install the Housing to your desk using the four Long wood

screws.

CAUTION: Read all instructions before assembly. Failure to assemble or operate properly may

result in damage or personal injury.

CAUTION: Maximum weight capacity is 17 lbs (7.7 kg), do not overload.

CAUTIONS & WARNINGS

AI-STR018-1.0

Copyright Notice: These instructions are a component of this accessory. These instructions are part of the scope of delivery, even if the item is resold. These instructions are also available on the UPLIFT Desk website: uplift-

desk.com. Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.

Step 5

Slide the Drawer back into its Housing.

Step 6

To prevent the drawer from being removed completely, screw