ADC HiGain HTC-439 List 2 Test Card Manuel utilisateur

HiGain

USER MANUAL

HTC-439 List 2 HiGain Test Card

Product Catalog: 150-439-102-02

CLEI: T1DQACBJ

150-439-102-02, Issue 2

ii November 12, 1999 HTC-439 List 2

Revision History of This Manual

To order copies of this document, use document catalog number

150-439-102-02.

November 12, 1999

Trademark Information

ADC is a registered trademark of ADC Telecommunications, Inc. HiGain is a

registered trademark of ADC DSL Systems, Inc. No right, license, or interest to such

trademarksis granted hereunder,andyou agree that no suchright, license,or interest

shall be asserted by you with respect to such trademark.

Other product names mentioned in this practice are used for identification purposes

only and may be trademarks or registered trademarks of their respective companies.

Disclaimer of Liability

Information contained in this documentis company private to ADCDSL Systems,Inc.,

and shall not be modified, used, copied, reproduced or disclosed in whole or in part

without the written consent of ADC.

Contents herein are current as of the date of publication. ADC reserves the right to

change the contents without prior notice. In no event shall ADC be liable for any

damages resulting from loss of data, loss of use, or loss of profits, and ADC further

disclaims any and all liability for indirect, incidental, special, consequential or other

similar damages. This disclaimer of liability applies to all products, publications and

services during and after the warranty period.

Issue Release Date Revisions Made

1November 12, 1999 Initial Release

2April 16, 2002 ADC Rebranding

150-439-102-02, Issue 2 Using This Manual

HTC-439 List 2 November 12, 1999 iii

USING THIS MANUAL

Three types of messages, identified by icons, appear in text.

UNPACK AND INSPECT YOUR SHIPMENT

Upon receipt of the equipment:

•Unpack each container and inspect the contents for signs of damage. If

theequipmenthasbeendamagedintransit,immediatelyreporttheextent

of damage to the transportation company and to ADC DSL Systems, Inc.

Order replacement equipment, if necessary.

•Check the packing list to ensure complete and accurate shipment of each

listed item. If the shipment is short or irregular, contact ADC DSL

Systems, Inc. as described in Product Support on page 12. If you must

store the equipment for a prolonged period, store the equipment in its

original container.

Notes contain information about special circumstances.

Cautions indicate the possibility of personal injury or

equipment damage.

The Electrostatic Discharge (ESD) symbol indicates that a

deviceorassemblyissusceptibletodamagefromelectrostatic

discharge.

Table of Contents 150-439-102-02, Issue 2

iv November 12, 1999 HTC-439 List 2

TABLE OF CONTENTS

Overview________________________________________________1

Features ....................................................................................1

Test Card ..................................................................................2

Installation ______________________________________________3

Testing a Circuit__________________________________________3

Appendix A - Specifications ________________________________6

Appendix B - Product Support______________________________7

Appendix C - Glossary ____________________________________8

Certification andWarranty _________________Inside Back Cover

150-439-102-02, Issue 2 Overview

HTC-439 List 2 November 12, 1999 1

OVERVIEW

The ADCHiGainTest Card HTC-439 List 2 provides a convenient

method of testing Central Office (CO) and Field Tip and Ring transmit and

receive pairs from any standard T1-239 repeater slot.

The width of theHTC-439 List 2 has been reduced from the List1 unit so that

the List 2 fits a four-slot HRE-504 enclosure without interfering with plugs

above or below it.

FEATURES

•Four-position slider switch (S1) that allows you to select tests on the

transmit (XMT) and receive (RCV) Tip and Ring pairs on CO and field

circuits:

–Open

–Short

–Loop Thru

–Loop Back (metallic)

•Test points that provide access to Tip and Ring circuits (CO and field)

and to frame ground.

•Miniature210 jacks located withinthe J1block that provideaccessto CO

and field Tip and Ring circuit sides.

•Designed to extend beyond the front plane of the shelf or enclosure into

which the HTC-439 List 2 is inserted to permit easy access to its test

points.

•Compatible with all ADC enclosures that support T1-239 mechanics.

Overview 150-439-102-02, Issue 2

2 November 12, 1999 HTC-439 List 2

TEST CARD

Test points on the HTC-439 (Figure 1) provide access to each active

card-edge connector pin including Frame Ground. These test points are

identified by the pin number to which they connect.

•The four-position test slider switch (S1) selects which test (Open, Short,

Loop Thru, or Loop Back) is to be performed on CO and field circuits.

•The Open switch position effectively provides a splitting-type access to

one pair of the CO and field sides and the 210 jacks.

•The Loop Back or Loop Thru switch positions allow you to use the two

miniature 210 jacks located within the J1 block.

All tests are run on both Side 1 and Side 2. Refer to “Testing a Circuit” on

page 3 for further information.

Figure 1. HTC-439 List 2 Test Card

SIDE 1

TP6

TP5

TP8

TP9

TP4

TP3

TP11

TP12

TP1

FIELD

OPEN

SHORT

LOOP THRU

LOOP BACK

FIELD

SIDE 2

S1 switch

positions Circuit schematic

Connector pins

Miniature

210 jacks

Test points

150-439-102-02, Issue 2 Installation

HTC-439 List 2 November 12, 1999 3

INSTALLATION

1Insert the HTC-439 into the shelf slot for the channel you want to test.

2Push the card into the slot until it is firmly seated.

TESTING ACIRCUIT

Use the HTC-439 to test circuits, as follows:

1Set the S1 slider switch to the test you want to perform (Open, Short,

Loop Thru, or Loop Back).

2Connect to test points as applicable. The connections of Tip and Ring

pairs of CO and field circuits for each setting of the switch are listed in

Table 1 on page 4 and illustrated in Figure 2 on page 5. (Pin numbers

correspond to the edge connector pins for each circuit.)

3Perform the selected test.

4Monitor the circuits at the corresponding test points on the card.

5Repeat steps 1 through 4 as required.

Allwiring externalto theproductshould follow the provisions

of the current edition of the National Electrical Code.

Testing a Circuit 150-439-102-02, Issue 2

4 November 12, 1999 HTC-439 List 2

Table 1. Test Connections

Connect Pin Number To Pin Number

Loopback - This switch position connects the following circuits

CO Tip 6CO Tip 9

CO Ring 5CO Ring 8

Field Tip 4Field Tip 12

Field Ring 3Field Ring 11

Loopthru - This switch position connects the following circuits

CO Tip 6Field Tip 4

CO Ring 5Field Ring 3

CO Tip 9Field Tip 12

CO Ring 8Field Ring 11

Short - This switch position connects the following circuits

CO Tip 6CO Ring 5

CO Tip 9CO Ring 8

Field Tip 4Field Ring 3

Field Tip 12 Field Ring 11

Open - This switch position removes all connections between the circuits

150-439-102-02, Issue 2 Testing a Circuit

HTC-439 List 2 November 12, 1999 5

Figure 2. HTC-439 List 2 Test Connections

SIDE 1

FIELD

SIDE 2

To/From

CO Equipment

TP1

Test point 6

(TP6)

LOOP THRU TIP

TIP

RING

SIDE 1

SIDE 2

TIP

RING

SHORT TIP

TIP

RING

SIDE 1

SIDE 2

TIP

RING

OPEN TIP

TIP

RING

SIDE 1

SIDE 2

TIP

RING

To/From

Field

Equipment

FRAME GND

LOOP BACK TIP

TIP

RING

SIDE 1

SIDE 2

TIP

RING

TP6 TP4

TP5 TP3

TP9 TP12

TP8 TP11

SIDE 1

TP6

TP5

TP8

TP9

TP4

TP3

TP11

TP12

TP1

FIELD

OPEN

SHORT

LOOP THRU

LOOP BACK

SIDE 2

Appendix A - Specifications 150-439-102-02, Issue 2

6 November 12, 1999 HTC-439 List 2

APPENDIX A - SPECIFICATIONS

Mounting Any T1-239 repeater mechanics slot

Environmental

Operating Temperature: 40 °F to + 149 °F (-40 °C to + 65 °C)

Operating Humidity: 5% to 95% (non condensing)

Dimensions and Weight

Height: 2.5 in (6.33 cm)

Width: 0.6 in (1.52 cm)

Depth: 8.4 in (21.34 cm)

Weight: 0.30 lb (0.66 kg)

Table des matières

Autres manuels ADC Matériel réseau

ADC

ADC Carrier-Grade WiMAX Base Station WMX 5000 Manuel utilisateur

ADC

ADC PG-FlexPlus AMU-912 Manuel utilisateur

ADC

ADC PG-FLEXPLUS PMU-712 Manuel utilisateur

ADC

ADC TrueNet Intelligent Patching Manuel utilisateur

ADC

ADC H2TU-C-388 HiGain Instructions d'utilisation d'origine

ADC

ADC HiGain HLU-200 Manuel utilisateur

ADC

ADC HiGain HLU-200 Manuel utilisateur

ADC

ADC OmniReach NCX-1000s Manuel utilisateur

ADC

ADC HiGain HLU-231 List 8F Instructions d'utilisation d'origine

ADC

ADC The DSX Value Solution (Japanese) LDX154 Manuel utilisateur

ADC

ADC Cross-Connect Family FlexDSX Manuel utilisateur

ADC

ADC HiGain HDU-404 LIST 2 Instructions d'utilisation d'origine

ADC

ADC UniPatch Modular System RS-422 Manuel utilisateur

ADC

ADC HiGain HMS-317 List 2 Manuel utilisateur

ADC

ADC H2TU-C-388 HiGain Instructions d'utilisation d'origine

ADC

ADC HiGain H2TU-C-319 List 4E Manuel utilisateur

ADC

ADC Double Pair/Line Power G.SHDSL WorldDSL G.S Manuel utilisateur

ADC

ADC H2TU-C-388 HiGain Manuel utilisateur

ADC

ADC HiGain H2TU-C-319 List 4E Manuel utilisateur

ADC

ADC Double Pair/Line Power HDSL Manuel utilisateur

ADC

ADC RF Signal Management SignalOn Series Manuel utilisateur

ADC

ADC OmniReach NCX-1000 Manuel utilisateur

ADC

ADC PG-FLEXPLUS PLL-735 Manuel utilisateur

ADC

ADC HiGain H2TU-C-319 List 4E Instructions d'utilisation d'origine

Manuels Matériel réseau populaires d'autres marques

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manuel utilisateur

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manuel utilisateur

Yudor

Yudor YDS-16 Manuel utilisateur

D-Link

D-Link ShareCenter DNS-320L Manuel utilisateur

Samsung

Samsung ES1642dc Instructions d'utilisation

Honeywell Home

Honeywell Home LTEM-PV Instructions de montage

evertz

evertz 7700 Series Manuel utilisateur

D-Link

D-Link ShareCenter DNS-343 Manuel utilisateur

Asante

Asante AsanteBridge 1012 Manuel utilisateur

FireBrick

FireBrick FB2700 Manuel utilisateur

Audiovox Electronics

Audiovox Electronics ARWH2T Manuel utilisateur

NetComm

NetComm NF2 Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 5620 Manuel utilisateur

Dell EMC

Dell EMC XC6420 Series Manuel utilisateur

Lanner

Lanner NCA-1020A Manuel utilisateur

Allied Telesis

Allied Telesis AT-TN121-A Manuel utilisateur

Arista

Arista CCA-ETM-Q12 Manuel utilisateur

Lanner

Lanner NCA-1525 Manuel utilisateur