Abocom HP1000 Manuel utilisateur

PCI 1M PhoneLine

Network Adapter

Quick installation Guide

M73-APO01-120

REGULATORY STATEMENTS

Part15, Class B

This device complies with Part 15 of FCC rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interface, and

2. This device must accept any interface received,

including interface that may cause undesired

operation. This equipment has been tested and

found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide

reasonable protection against harmful

interference in a residential installation. This

equipment generates, uses and can radiate radio

frequency energy, and if not installed and used in

accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference

will not occur in a particular installation. If this

equipment does cause harmful interference to

radio or television reception, which can be

determined by turning off and on, the user is

encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the distance between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit

different from that to which the receiver is

connected.

*Changes or modifications not expressly

approved by party responsible for compliance

could void the user the user authority to

operate the equipment.

FCC Part 68 Registration

This device complies with FCC Part 68 rules, and the use of

this device is subject to the following restrictions:

1. The FCC has established rules which permit this device

to be directly connected to the telephone network.

Standardized jacks are used for these connections. This

equipment should not be used on party lines or coin

phones.

2. If this device is malfunctioning, it may also be causing

harm to the telephone network; this device should be

disconnected until the source of the problem can be

determined and until repair has been made. If this is not

done, the telephone company may temporarily

disconnect service.

3. The telephone company may make changes in it's

facilities, equipment, operation and procedures; if such

changes affect the compatibility or use of this device,

the telephone company is required to give adequate

notice of the situation with the FCC.

4. If the telephone company requests information on what

equipment is connected to their lines, inform them of:

a. The telephone number to which this unit is connected.

b. The Ringer Equivalence Number (REN).

c. The USOC jack required.

d. The FCC Registration number.

Items (b) and (d) are indicated on the label. The Ringer

Equivalence Number (REN) is used to determine how many

devices can be connected to your telephone line. In most

areas, the sum of the REN's of all the devices on any one line

should not exceed 5.0. If too many devices are attached, they

may not ring properly.

INTRODUCTIONS

The PCI 1M PhoneLine Network Adapter

enables the instant connectivity to multiple PCs

over a home's existing telephone lines.

You can share network-enabled printers, transfer

files between computers, play network games,

and more- no switches, hubs, or even any

additional cables is needed. The network runs on

standard home-grade telephone wires just like

the ones you use everyday. Plus, it doesn’t

interfere with your normal phone use.

Features

• Connects to a network using your existing

telephone line -- No additional hubs or

network cables needed

• 1Mbps transfer rate over telephone lines

• HomePNA 1.0, 1.1 compliant

Specifications

Network Specification

• Media: Home-grade phone line up to 500

feet

• Nodes Supported: 25 nodes maximum

• Frequency Range: 5.5M to 9.5M Hz

• Topology: Daisy chain

Host Interface

• Host Interface: 32bit 33Mhz PCI 2.0, 2.1,

2.2 compliant.

• PC98, PC99, and NetPC Compliant

Driver Supported

• Windows NT 4.0

• Windows 95 all version

- 1 -

• Windows 98 all version

• Windows 2000 ready

HARDWARE INSTALLATION

Before you begin, make sure you turn off all

power to your computer.

1. Remove the chassis cover of your computer.

2. Align the contact edge of the PCI 1M

PhoneLine Network Adapter toward the

connector of any free PCI Bus Master

expansion slot. Push firmly and slowly until

it is fully seated in the connector.

3. Screw the PCI 1M PhoneLine Network

Adapter to the computer chassis with the

provided screws.

4. Replace the computer’s chassis cover.

5. Turn on your computer.

Connecting Telephone Cabling

1. Attach one end of the telephone wire to the

PCI 1M PhoneLine Network Adapter’s RJ-

11 telephone port.

2. Connect the other end of the wire into a

telephone jack in your wall.

- 2 -

SOFTWARE INSTALLATION

Once your PCI 1M PhoneLine Network Adapter

has been successfully installed into the computer,

turn on your computer and the system will

automatically detect the new hardware. Insert the

driver diskette for the PCI 1M PhoneLine

Network Adapter into the floppy disk drive.

To efficiently help you to setup the proper driver

for your PCI 1M PhoneLine Network Adapter,

an on-line documentation named

README.TXT was provided in the

folder/subdirectory corresponding to the

operating system you are working with. For

example, if your are working with Windows 98,

go to the WIN98 folder, click README.TXT.

- 3 -

Table des matières

Autres manuels Abocom Adaptateur

Abocom

Abocom UFE1000C Manuel utilisateur

Abocom

Abocom WU5508 Manuel utilisateur

Abocom

Abocom Wireless USB Adapter WUB1500 Manuel utilisateur

Abocom

Abocom WUG2400 Manuel utilisateur

Abocom

Abocom UFE1000B Manuel utilisateur

Abocom

Abocom BSM202 Manuel utilisateur

Abocom

Abocom UFT128S Manuel utilisateur

Abocom

Abocom WUE1500 Manuel utilisateur

Abocom

Abocom WBD512 Manuel utilisateur

Abocom

Abocom WU5200 Manuel utilisateur

Abocom

Abocom WUG2200 Manuel utilisateur

Abocom

Abocom WUG2700 Manuel utilisateur

Abocom

Abocom UHL1000C Manuel utilisateur

Abocom

Abocom WM5502S Manuel utilisateur

Abocom

Abocom 802.11 b/g/n Mini Wireless LAN USB 2.0 Adapter... Manuel utilisateur

Abocom

Abocom CompactFlash CA1040 Manuel utilisateur

Abocom

Abocom FE1000 Manuel utilisateur

Abocom

Abocom WU5502 Manuel utilisateur

Abocom

Abocom 10/100M Fast Ethernet M73-APO08-420 Manuel utilisateur

Abocom

Abocom FE1200 Manuel utilisateur

Abocom

Abocom Bluetooth Wireless USB Adapter UBT1000 Manuel utilisateur

Abocom

Abocom WCU5102 Manuel utilisateur

Abocom

Abocom WU5204 Manuel utilisateur

Abocom

Abocom PCMCIA Instructions de montage

Manuels Adaptateur populaires d'autres marques

PCB Piezotronics

PCB Piezotronics 090B274 Manuel utilisateur

Auvidea

Auvidea J20 Manuel du produit

Gossen MetraWatt

Gossen MetraWatt AT3-III E Manuel utilisateur

Akribis

Akribis ITF-21-BISS-MIT Manuel utilisateur

Tenda

Tenda W54U Manuel utilisateur

ROHO

ROHO AGILITY Manuel utilisateur

PROLiNK

PROLiNK WN2001 Manuel utilisateur

Hawking

Hawking HUF2 Manuel utilisateur

Airlink101

Airlink101 AWLC4030 Manuel utilisateur

NETGEAR

NETGEAR XAV101v1 - Powerline AV Ethernet Adapter Manuel utilisateur

Philips

Philips SWA4554S/10 Manuel utilisateur

JVC

JVC TS-C9D2B Manuel d'instructions

NETGEAR

NETGEAR A6100 Manuel utilisateur

D-Link

D-Link DWA-121 Manuel utilisateur

Philips

Philips SWA2037 Manuel utilisateur

Basalte

Basalte 0610-20 Manuel utilisateur

Yealink

Yealink EHS40 Manuel utilisateur

Balluff

Balluff BIC 1B0-IT1A7-Q40KFU-SM4A4A Manuel utilisateur