ABB FDNA-01 Manuel d'installation

Safety instructions

WARNING! Obey the safety instructions of the drive. If you ignore them, injury or death, or

damage to the equipment can occur.

Mechanical installation

Electrical installation

Layout of the module

1. Pull out the lock.

2. Install the module carefully to an option

module slot of the drive. See the drive

hardware manual.

3. Push in the lock.

4. Tighten the screw to torque 0.8 N·m

using a Torx TX10 screwdriver.

WARNING! Do not use excessive force, or leave the screw too loose. Over-tightening can

damage the screw or module. A loose screw decreases the EMC performance, and can

cause an operation failure.

No. Description

1Lock

2 Mounting and grounding screw

3 Bus connector [X1]

4 Diagnostic LEDs



—

OPTIONS FOR ABB DRIVES

FDNA-01 DeviceNet adapter module

Quick installation and start-up guide

Start-up

To control the drive with the adapter module, set at least the basic parameters listed in the table

below. For full parameter descriptions, refer to the adapter module’s user manual or to the drive’s

firmware manual.

Basic parameter settings

To take the settings into use, validate and refresh the parameters with parameter 51.27 FBA par

refresh.

Further information

Pin allocation for [X1] Bus termination

The module does not provide bus termination. The DeviceNet

network should be terminated at both ends of the trunk cable with a

121 ohm, ¼ W, 1% metal film resistor.

Connect the resistor between the two signal wires (CAN_H, CAN_L)

on the DeviceNet cable, as shown in this figure.

Pin Description

1 V- Network power supply

ground (0V DC)

2 CAN_L CAN_L bus line

3 SHLD Network cable shield

4CAN_H CAN_Hbusline

5 V+ Network power supply

source (24V DC)

Index Name Value

20.01 Ext1 commands Fieldbus A

22.11 Speed ref1 source FBA A ref 1

28.11 Frequency ref1 source FBA A ref 1

50.01 FBA A enable Enable (or select the option slot in which the module is installed).

This activates the communication module. The HOST LED becomes green.

50.02 FBA A comm loss func Fault

51.02 MAC ID Set the MAC ID number for the drive.

See the latest version of FDNA-01 DeviceNet adapter module

user's manual (3AFE68573360 [English]) in ABB library

(www.abb.com/drives/documents).

For more information on ABB fieldbus options and protocols,

see the fieldbus communications web page

(new.abb.com/drives/connectivity/fieldbus-connectivity).

12345

Node 1 Node n

121



CAN_H

CAN_L

Scanner

121



Metal Film

1/4 W

Metal Film

1/4 W

…

FDNA-01 manual

Fieldbus communications web

page

Specifications subject to change without notice.

3AXD50000158515 Rev B (EN) 2023-01-25

abb.com/drives

Autres manuels pour FDNA-01

Table des matières

Autres manuels ABB Unité de contrôle

ABB

ABB ACS880-04 drive modules Manuel utilisateur

ABB

ABB RER 133 Manuel de la liste des pièces

ABB

ABB REC650 ANSI Guide de démarrage rapide

ABB

ABB COM600 series Manuel utilisateur

ABB

ABB ACS 600 MultiDrive Manuel utilisateur

ABB

ABB RPBA-01 Manuel utilisateur

ABB

ABB IMASI13 Manuel utilisateur

ABB

ABB Symphony Harmony Series Manuel utilisateur

ABB

ABB ABB-free@home flex Manuel utilisateur

ABB

ABB TruONE Ekip Manuel utilisateur

ABB

ABB SACE PR212/D-M Manuel utilisateur

ABB

ABB M10 Series Manuel utilisateur

ABB

ABB REC650 ANSI Instructions d'utilisation

ABB

ABB FMBA-01 Manuel utilisateur

ABB

ABB 616016-T2 Manuel d'utilisation et d'entretien

ABB

ABB Relion 670 series Guide de démarrage rapide

ABB

ABB Relion 670 series Manuel utilisateur

ABB

ABB M4M Mode d’emploi

ABB

ABB FCB400 Series Manuel utilisateur

ABB

ABB OMD200 Guide de l'utilisateur

ABB

ABB LW 110 Manuel utilisateur

ABB

ABB ACS880-04F Manuel utilisateur

ABB

ABB Welcome M2306 Manuel utilisateur

ABB

ABB CMS-700 Manuel utilisateur

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur