Power input voltage of model VI model VII and model X:
48VDC, power input voltage of model I and model III: 48VDC
(12~48VDC).
AC power supply 220VAC
This series of model II and model IV
support AC single power supply and
provide 6 pins 5.08mm pitch input
terminal blocks, including 4 pins power supply terminal blocks
on the left side.
Power input voltage: 220VAC (85~264VAC).
PoE Power Supply Pin Connection
PoE port is powered by the following pins.
Relay Connection
The device provides 6-pin 5.08mm pitch input terminal blocks,
including 2-pin relay terminal blocks on the right side. Relay
terminals are a pair of normally open contacts in device alarm
relay. They are open circuit in normal non alarm state, closed
when any alarm information occurs. For example: it's closed
and sends out alarm when power off. The switch supports 1
relay alarm information and network abnormal alarm output, it
can be connected to alerting lamp, alarm buzzer, or other
switching value collecting devices for timely warning operating
staffs when alarm information occurs.
DIP Switch Settings
This series provide 4 pins DIP switch for
function settings, where "ON" is enable valid
terminal. DIP switch definition as follows:
1 Flow control Set the DIP switch to ON, and
the device will enable flow
2 Port with the
specified
Set the DIP switch to ON, and
the 100M copper port of the
device will be specified as 10M
3 Alarm Set the DIP switch to ON, and
the device will enable port alarm
Checking LED Indicator
The function of each LED is described in the table as below:
P1/P2/PWR
ON Power supply is connected
OFF
Power supply is
disconnected and running
ALM
RUN
ON The device is powered on or
OFF The device is powered off or
Link/ACT
(1-4/8, G1-G2)
ON Ethernet port connection is
OFF Ethernet port connection is
POE (1-4/8)
ON POE port supply electricity
for other devices normally
OFF POE is disabled or
Specification
100M POE copper port
10/100 Base-T(X) RJ45,
automatic flow control, full/half
duplex mode, MDI/MDI-X
autotunning, POE port, the
output power consumption is
POE pins V+, V+, V-, V- are
corresponding to 1, 2, 3, 6.
Gigabit Combo port 10/100/1000Base-T(X) or
Alarm interface
6-pin 5.08mm pitch terminal
blocks, including 2-pin alarm
terminal blocks. It supports 1
relay alarm information output,
current load capacity is
Indicator
Run indicator, interface
indicator power indicator, alarm
Input power supply
Power supply input voltage:
48VDC, 24VDC, 220VAC
Support DC dual power supply
redundancy, anti-reverse
Access terminal
6-pin 5.08mm pitch terminal
blocks, including 4-pin power
℃
℃
