ZyXEL Communications ONU-6100B-21 Manuel utilisateur

ONU-6100B-2x Series

GEPON Optical Network Unit

User’s Guide

Version 1.00

9/2008

Edition 1

ONU-6100B-2x Series User’s Guide

Introduction

The ONU-6100B-2x is an optical network unit (ONU) that

allows you to enjoy high-speed Internet access over optical

networks. The ONU-6100B-2x comes with one fiber, and one

10/100/1000 Mbps RJ-45 (LAN) port. No configuration is

required. On the ONU-6100B-2x, all device configuration is

done remotely by the OLT (Optical Line Terminal). Once you

have connected the hardware, you are ready to enjoy Internet

access.

Two ONU-6100B-2x models are discussed in this guide:

ONU-6100B-21 (with a 10km transceiver) and ONU-6100B-22

(with a 20km transceiver).

1 Hardware Connections

ONU-6100B-2x Series User’s Guide

1PON:Connect an SC-type, single-mode optical cable to

the PON port for Internet access.

"To avoid possible eye injury, do NOT look into

an operating fiber-optic module’s connector.

2LAN:Use the included Ethernet cable to connect the LAN

port to a computer.

3 EMI Suppressor Clip (except Japan): Take the following

steps to install the included Electro-Magnetic Interference

(EMI) suppressor clip.

"Attach the EMI Suppressor clip before using the

ONU-6100B-2x (except Japan).

• Open the suppressor clip. The clip

should be installed on the end of

the power cable that connects to

the ONU-6100B-2x, close to the

power jack.

ONU-6100B-2x Series User’s Guide

• Lay the included power

cable in the clip’s internal

cable channel.

• Pass the cable

through the clip’s

cable channel a

second time, mak-

ing a cable loop.

• Close the clip.

4POWER: Use the included power adaptor to connect this

power socket to an appropriate power source. Push the

power switch to the on position.

ONU-6100B-2x Series User’s Guide

1.1 Check the LEDs (Lights)

•ThePOWER LED turns steady on when you connect the

ONU-6100B-2x to the power supply.

•ThePON LED turns on when the fiber connection is avail-

able.

•TheLAN LED turns on when the LAN port is properly con-

nected.

The following table describes the LEDs in detail.

Label Color Status Description

POWER Green On The ONU-6100B-2x is receiving

power and is ready.

Off The ONU-6100B-2x is not receiving

power.

PON Green On Connection to the optical network is

up.

Off Connection to the optical network is

down.

Blinking The ONU-6100B-2x is trying to

ONU-6100B-2x Series User’s Guide

2 Test Your Internet Connection

After you have connected the hardware and turned on the

ONU-6100B-2x, open a web browser on your computer and

go to any web site (for example, www.zyxel.com) to test your

Internet connection.

3 Hardware Installation

The ONU-6100B-2x can be placed on a desktop or mounted

on a wall.

LOS Red Blinking The ONU-6100B-2x is receiving error

signals or no optical signals from the

OLT.

Off The ONU-6100B-2x is receiving good

optical signals from the OLT

successfully and no error signals.

LAN Green On The LAN port is connected to an

Ethernet device at 10/100/1000 Mbps.

Blinking The ONU-6100B-2x is sending or

receiving data at 10/100/1000 Mbps.

Off No Ethernet device is connected to

the LAN port.

Label Color Status Description

ONU-6100B-2x Series User’s Guide

3.1 Desktop Instructions

Place the ONU-6100B-2x on a flat, level surface that is strong

enough to support the weight of the ONU-6100B-2x with

connection cables. Make sure there is a power outlet nearby.

3.2 Wall-mounting Instructions

Complete the following steps to hang your ONU-6100B-2x on

a wall.

1Select a position free of obstructions on a sturdy wall.

2Drill two holes large enough for the M4 tap screws. Make

sure the distance between the centers of the holes is

108mm.

"Be careful to avoid damaging pipes or cables

located inside the wall when drilling holes for the

screws.

ONU-6100B-2x Series User’s Guide

3Do not insert the screws all the way into the wall. Leave a

small gap of about 0.5 cm between the heads of the

screws and the wall.

4Make sure the screws are snugly fastened to the wall.

They need to hold the weight of the ONU-6100B-2x with

the connection cables.

5Align the holes on the back of the ONU-6100B-2x with the

screws on the wall. Hang the ONU-6100B-2x on the

screws.

The following are dimensions of an M4 tap screw and

masonry plug used for wall mounting. All measurements are

in millimeters (mm).

ONU-6100B-2x Series User’s Guide

Troubleshooting

1The POWER light is not on when I connect power to the

ONU-6100B-2x.

• Check that the power source is turned on.

• You might be using the wrong power adaptor. Use the

included power adaptor only.

• If you are using the correct power adaptor, disconnect

and re-connect the power adaptor to turn on the ONU-

6100B-2x again.

•IfthePOWER light is still not on, use a different power

outlet.

• If the problem continues, contact your local vendor.

2The PON light is off.

• Check the connector on the optical cable and the PON

port. Make sure they are clean and dust-free. Use an

air duster to clean the connectors. Do NOT use a wet

cloth to clean the connectors.

• Check the optical cable. Make sure it is not broken. If

the cable is broken, contact your service provider to

have the cable/connector replaced. Do NOT attempt to

replace the optical cable/connector yourself.

3I cannot connect to the Internet.

• Check the port connections and the lights.

• There might be problems with the optical network set-

ting. Contact your service provider.

ONU-6100B-2x Series User’s Guide

Specifications

Specifications are accurate at the time of writing.

Feature Specification

Dimensions (mm) 168 (Wide) x 111.5 (Deep) x 17.8 (High)

Weight < 1 kg

Interface PON:

One PON port

Compliant with IEEE 802.3ah

PX-10 (ONU-6100B-21)

PX-20 (ONU-6100B-22)

SC optical connectors with shutters

Transmission distance:

10 km (ONU-6100B-21)

20 km (ONU-6100B-22)

Ethernet:

One 10/100/1000 Mbps RJ-45 port (LAN)

Auto-negotiation

Auto-MDIX

Power Supply 12 VDC @ 1.5 A

Operation Temperature 0º C ~ 45º C

Storage Temperature -30º ~ 60º C

Operation Humidity < 95% RH

Storage Humidity < 95% RH

Safety UL60950-1, CSA60950-1, EN60950 -1,

IEC60950-1

EMI FCC Part 15 Class B, CE-EMC Class B

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels ZyXEL Communications Routeur réseau

ZyXEL Communications

ZyXEL Communications 650 Series Manuel utilisateur

ZyXEL Communications

ZyXEL Communications GS-4012F Manuel utilisateur

ZyXEL Communications

ZyXEL Communications P-2802HW-I Manuel utilisateur

ZyXEL Communications

ZyXEL Communications IES-1000 - ANNEXE 7 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications XGS3700-24HP Manuel du propriétaire

ZyXEL Communications

ZyXEL Communications Prestige 623 series Manuel utilisateur

ZyXEL Communications

ZyXEL Communications Multy Plus Manuel utilisateur

ZyXEL Communications

ZyXEL Communications Prestige 650HW Manuel utilisateur

ZyXEL Communications

ZyXEL Communications LTE3302-M432 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications ETHERNET SWITCHES ES-1016 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications ZyXEL Prestige 310 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications PRESTIGE 1400 - Manuel utilisateur

ZyXEL Communications

ZyXEL Communications Prestige 652 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications Dimension GS-4024 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications Dimension ES-124P Guide de référence

ZyXEL Communications

ZyXEL Communications XMG Series Manuel utilisateur

ZyXEL Communications

ZyXEL Communications ES-2024A Manuel

ZyXEL Communications

ZyXEL Communications P8701T Manuel utilisateur

ZyXEL Communications

ZyXEL Communications NBG318S Series Manuel utilisateur

ZyXEL Communications

ZyXEL Communications Prestige 650HW Manuel

ZyXEL Communications

ZyXEL Communications Dimension ES-108S Manuel utilisateur

ZyXEL Communications

ZyXEL Communications Prestige 650R-31/33 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications P-334 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications GS1100-16 - EDITION 1 Manuel utilisateur

Manuels Routeur réseau populaires d'autres marques

Allnet

Allnet ALL0333AU Manuel utilisateur

HomeSeer

HomeSeer HT-SEL Manuel utilisateur

Sercomm

Sercomm Genesis OC3505D Manuel utilisateur

Billion

Billion BIPAC 5102 Series Manuel utilisateur

TP-Link

TP-Link TD-8817 Manuel utilisateur

Motorola

Motorola MR1900 Manuel utilisateur

Digi

Digi IX14 Manuel utilisateur

Cisco

Cisco NCS 540 Manuel

XAVi

XAVi X8821e Manuel utilisateur

BEC

BEC 6200WZL Manuel utilisateur

MikroTik

MikroTik hAP ac3 Series Manuel utilisateur

Korenix

Korenix JetNet 5428G Series Manuel utilisateur

NETGEAR

NETGEAR FS526T - Switch Manuel utilisateur

Korenix

Korenix JetNet 5710G Series Manuel utilisateur

Automated Logic

Automated Logic ZN551 Manuel du propriétaire

Cisco

Cisco ASR 1000 Series Manuel de l'opérateur

EnGenius

EnGenius ESR-9710 Manuel utilisateur

Cisco

Cisco 805 Series Instructions d'utilisation et de sécurité