ZyXEL Communications AG-225H Manuel utilisateur

ZyXEL AG-225H

802.11a/b/g Wi-Fi Finder & USB Adapter

Quick Start Guide

10/2005

Version 2.1

ZyXEL AG-225H Quick Start Guide

Important Note

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one of the

following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate this equipment.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance 20cm

between the radiator & your body.

ZyXEL AG-225H Quick Start Guide

1. Wi-Fi Finder Mode (User Interface)

ZyXEL AG-225H Quick Start Guide

1.1 LCM Description

Security Information

WEP security is enabled.

WPA security is enabled.

Wireless security is disabled

(no security)

Entr

Display the current

entry of the detected

Access Points. Users

can detect up to 15

networks at one time.

Channel

Display the radio

channel of the

detected network.

Detect Mode

Display up to 15 detected

networks in the order of the

signal strength

Display the detected networks

without any security setting

(free hot spot).

Display the dedicated network

you choose to use

SSID

The SSID identifies the Service Set

to the network users detect. When

the length of SSID is longer than 12

characters, it will be scrolled

horizontally.

Power

Display Low Battery

Display Full Battery

Signal

Indicate A/B/G World Wide Radio

Band.

5 levels of signal strength.

802.11a mode at 5 GHz band

802.11b mode at 2.4 GHz band

802.11g mode at 2.4 GHz band

ZyXEL AG-225H Quick Start Guide

1.2 Basic Operation

1. Power on the ZyXEL AG-225H

2. The ZyXEL AG-225H will automatically detect the available wireless

networks in 6~7 seconds.

3. The site survey information will be

displayed on the LCM including the SSID,

channel, signal strength, wireless network

protocol (IEEE802.11a/b/g), and the type

of wireless security/encryption (WEP or

WPA)

4. Push the “Next” button to see more access points you have detected.

For advanced features of the ZyXEL AG-225H, there are totally 3 modes to

choose:

Mode mode is set by default for most users to detect the Wi-Fi

networks.

Mode

(Free Mode)

Hold the “Seek” button for 1 second to switch to mode.

In mode, push the “Seek” button to detect the free hot

spots or available WLAN that you can connect to the Access

Point without any security setting.

ZyXEL AG-225H Quick Start Guide

Mode When you need to connect the specific Aceess Point and lock

on it, push the “Next” button to select the desired Aceess

Point. To dedicate tracking a certain AP, hold the “Seek”

button to swith to mode.

Then push “Seek” button once again to periodically do the

site survey automatically in mode. By doing so, the modes

can be changed from mode to mode.

When ZyXEL AG-225H Wi-Fi Finder is not used for 1~2 minutes, the device

will enter into the power saving mode untill you push the “Seek” button again

for searching the access points.

Charging

When low power icon appears , recharge the ZyXEL

AG-225H with your USB port on your laptop or desktop PC.

The LCM will display when the device is charging and

display when the device finishs charging.

Note: To save power, switch off the ZyXEL AG-225H when not using Wi-Fi

Finder.

ZyXEL AG-225H Quick Start Guide

1.3 LED Display

The following table describes the LEDs on the ZyXEL AG-225H (Wi-Fi Finder

Mode)

LED COLOR STATUS DESCRIPTION

On The ZyXEL AG-225H is power on.PWR

Blue

Off The ZyXEL AG-225H is either power off or entering

into the Power Saving Mode.

On The ZyXEL AG-225H is detecting the wireless networkLINK

Blue

Off The ZyXEL AG-225H is not detecting the wireless

network.

ZyXEL AG-225H Quick Start Guide

1.4 Button Display

The following table describes the Buttons on the ZyXEL AG-225H (Wi-Fi Finder

Mode).

BUTTON DESCRIPTION

SEEK

Push “SEEK” to detect the wireless networks.

Push “NEXT” to see the wireless networks you detect.

Switch right to power on the ZyXEL AG-225H.

OFF/ON

Switch left to power off the ZyXEL AG-225H.

ZyXEL AG-225H Quick Start Guide

2. Installation Requirements for Adapter Mode

Before installation, make sure you have the following requirements.

•Pentium II 300MHz or above

•A minimum of 20 MB available hard disk space

•A minimum of 64 MB RAM

•A CD-ROM drive

•A computer with an available USB port

•USB1.1 Interface (USB 2.0 strongly recommended)

•Windows XP/2000

2.1 ZyXEL Utility/Driver Setup in Adapter Mode

The installation procedures are similar for all supported Windows versions.

Windows XP screen shots are shown unless otherwise specified.

)DO NOT insert the ZyXEL AG-225H at this point.

1. Insert the support CD into the CD-ROM drive on your computer. The

installation program will automatically run. If it does not, locate and double-

click setup.exe on the support CD.

ZyXEL AG-225H Quick Start Guide

2. Click Install Utility to start

installation.

3. Client utility and driver will be automatically installed.

4. A welcome screen displays. Click Next.

5. Click Next to accept the default file

location or click Browse to select an

alternate folder.

6. Click Finish to complete the installation.

7. After installation is completed, a Z icon will appear in your system

tray.

8. Locate an available USB port on the computer (USB 2.0 Port Preferred).

9. Connect the ZyXEL AG-225H to your USB port via the included USB

cable.

10. The LED turns on if the ZyXEL AG-225H is properly plug in.

Autres manuels pour AG-225H

Table des matières

Autres manuels ZyXEL Communications Adaptateur

ZyXEL Communications

ZyXEL Communications NWD-490 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications G-320H Mode d’emploi

ZyXEL Communications

ZyXEL Communications AG-220 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications G-210H Manuel utilisateur

ZyXEL Communications

ZyXEL Communications G-202 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications PLA-402 V2 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications PLA-401 Series Manuel utilisateur

ZyXEL Communications

ZyXEL Communications 802.11g Wireless Ethernet Adapter 1-G-470 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications NWD6505 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications NWD-211AN - Manuel utilisateur

ZyXEL Communications

ZyXEL Communications ZyXEL ZyAIR 100 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications WPA-1000 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications PLA5456 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications PLA-401 - V3.0.5 Mode d’emploi

ZyXEL Communications

ZyXEL Communications FN-300 Series Manuel utilisateur

ZyXEL Communications

ZyXEL Communications DMA-1000W Manuel utilisateur

ZyXEL Communications

ZyXEL Communications ZyAIR G-160 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications NWD217N Manuel utilisateur

ZyXEL Communications

ZyXEL Communications Omni TA128 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications G-202 Mode d’emploi

ZyXEL Communications

ZyXEL Communications DMA-1000 Series Manuel

ZyXEL Communications

ZyXEL Communications ZyXEL NWD2105 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications PLA4215 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications WPA-1000 Manuel utilisateur

Manuels Adaptateur populaires d'autres marques

PCB Piezotronics

PCB Piezotronics 090B274 Manuel utilisateur

Auvidea

Auvidea J20 Manuel du produit

Gossen MetraWatt

Gossen MetraWatt AT3-III E Manuel utilisateur

Akribis

Akribis ITF-21-BISS-MIT Manuel utilisateur

Tenda

Tenda W54U Manuel utilisateur

ROHO

ROHO AGILITY Manuel utilisateur

PROLiNK

PROLiNK WN2001 Manuel utilisateur

Hawking

Hawking HUF2 Manuel utilisateur

Airlink101

Airlink101 AWLC4030 Manuel utilisateur

NETGEAR

NETGEAR XAV101v1 - Powerline AV Ethernet Adapter Manuel utilisateur

Philips

Philips SWA4554S/10 Manuel utilisateur

JVC

JVC TS-C9D2B Manuel d'instructions

NETGEAR

NETGEAR A6100 Manuel utilisateur

D-Link

D-Link DWA-121 Manuel utilisateur

Philips

Philips SWA2037 Manuel utilisateur

Basalte

Basalte 0610-20 Manuel utilisateur

Yealink

Yealink EHS40 Manuel utilisateur

Balluff

Balluff BIC 1B0-IT1A7-Q40KFU-SM4A4A Manuel utilisateur