Yamato DKS-3002 Manuel utilisateur
DKS-3002 Operation ManualDKS-3002 Operation Manual
MODEL DKS-3002
OPERATING INSTRUCTIONS
DIGITAL SCALES
YCO-1039-08-99A
YAMATO CORPORATION
1775S.MurrayBlvd.
ColoradoSprings, CO 80916 USA
Tel(719)591-1500 Fax(719)591-1045
YAMATO TECH CORPORATION
#112-19425LangleyBy-Pass
Surrey,B.C. V3S6K1 Canada
Tel(604)533-2338 Fax(604)533-0827
www.YamatoCorp.com
Notes:______________________________________________
YCO-1039-08-99A
DKS-3002 Operation ManualDKS-3002 Operation Manual
INSTRUCTIONS FOR USE
TO FIT BATTERY
Remove the cover on the underside of the scale and push the
connector firmly onto the battery terminals. Refit the cover. (Use
9 V Alkaline battery for suitable power output.)
TO SWITCH ON
Place the scale on a flat, stable surface. Press the ON/Zero key
once (quite firmly) in the center. The display will show "8888"
then "0:0" (or "0".)
CLEANINGAND CARE
• If the scale is not being used for a long period of time, re
move the battery. Remove dead batteries immediately.
• Clean scale with damp cloth, do not immerse the scale in
water or use chemical/abrasive cleaning agents.
• All plastic parts should be cleaned immediately after contact
with fats, spices, vinegar or strongly flavored/colored foods.
Avoid contact with acids such as citrus fruit juices.
• Avoid placing your scale directly next to a microwave oven if
both will be used at the same time. (Some microwave ovens
emit interference which, at close range, can cause the dis
play of the scale to fluctuate.)
TECHNICAL SPECIFICATION
Power Supply:
One9VAlkalinebattery
Accuracy:
To within +/- one increment or 1% of applied load
2 7
DKS-3002 Operation ManualDKS-3002 Operation Manual
1. Is the scale level?
Make sure that all the feet are resting firmly on the supporting
surface.
2. Is the scale turned on?
If the scale does not work at all, depress the ON/Zero key,
Repeat once or twice. Scale will automatically turn off if not
used for two minutes (thirty seconds with a zero reading) to
preserve battery life.
3. "Err" indication?
When the weight of the scale platform exceeds 105% of the
capacity of the scale, "Err" will appear on the digital display,
Reduce load.
4. Is movement of the scale restricted in any way?
Make sure that no foreign objects are wedged between the
platform and the scale body. Verify that platform is not
rubbing against surrounding objects.
5. "Lo" indication?
Remove battery cover and install new 9 Volt Alkaline battery.
If any of these actions fail to correct the problem, the scale
needs to be serviced by a qualified technician.
TO CONVERT WEIGHT UNITS
Press the LB/G key to convert between metric and imperial units.
This can be done at any time during weighing.
MINOR TROUBLE SHOOTING
36
DKS-3002 Operation ManualDKS-3002 Operation Manual MINUS READINGS
"----" indicates a minus reading, i.e. less than zero. For
example, if the scale is set to zero with a bowl on the platform
then the bowl is removed, the display will show "----". To reset
to zero, either replace the same bowl or press the ON/Zero key.
TO SWITCH OFF
Press the OFF button once to switch off. Switching your scale
off immediately after use will increase battery life. An automatic
switch-off will operate after 30 seconds if the display has been
showing zero continuously for that time, or after 2 minutes if a
weight reading has been displayed continuously for that time.
USING A BOWL
This scale may be used with any bowl or container which
weighs less than 1 kg or 2 lb 3 oz.
Place the bowl on the platform then press the ON/Zero key.
The display will show "tArE" for 2 seconds, then it will reset to
"0:0" (or "0"), ready to weigh.
4 5
Table des matières
Autres manuels Yamato Échelle
Yamato
Yamato DP-6700 Manuel utilisateur
Yamato
Yamato SPC - Solar Manuel utilisateur
Yamato
Yamato DSR-400 Manuel utilisateur
Yamato
Yamato UDS-1V-WP Manuel utilisateur
Yamato
Yamato AW-300P Manuel utilisateur
Yamato
Yamato DSR-400 Manuel utilisateur
Yamato
Yamato DSR-200 Manuel utilisateur
Yamato
Yamato Clock MINI DF301 Manuel utilisateur
Yamato
Yamato PLS Series Manuel utilisateur
Yamato
Yamato CPC-2000 Manuel utilisateur
Yamato
Yamato PB-200 Manuel utilisateur
Yamato
Yamato PPC-300 Manuel utilisateur
Yamato
Yamato DP-6200 Manuel utilisateur
Yamato
Yamato PPC-200W Manuel utilisateur
Yamato
Yamato DSR-200 Manuel utilisateur
Yamato
Yamato DP-8100 Manuel utilisateur
Yamato
Yamato CPS series Manuel utilisateur
Yamato
Yamato SPC Series Manuel utilisateur
Yamato
Yamato PPC-300WP Manuel utilisateur
Yamato
Yamato DP-6700 Manuel utilisateur
