Xvive Audio U3 Manuel utilisateur

U3 SET MANUAL
MICROPHONE
WIRELESS SYSTEM

WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK: DO NOT REMOVE SCREWS.
NO USER-SERVICEABLE PARTSINSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THE APPLIANCE TO RAIN OR
MOISTURE.
Radio Approvals: FCC Part 15.249, FCC Part 15 B, RSS-210
(Canada), EN 300 440 (Europe), EN 301.489 (Europe), MIC
Notice No.88 Appendix No.43(Japan)
This Class B digital apparatus complies with Canadian
ICES-003.
IC Caution: RSS-Gen Issue 4 December 2014"&"CNR-Gen 4e
Décembre 2014:
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference, and
(2)
This device must accept any interference, including interference
that may cause undesired operation of the device.
Le présentappareilestconforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence.
L'exploitationestautorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareildoit accepter tout
brouillageradioélectriquesubi, mêmesi le brouillageest
susceptible d'encompromettre le fonctionnement.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CERTIFICATION
01
210-119489

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE
RECEIVED, INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
WARNING:
Changes or modifications not expressly approved in writing
by Xvive may void the users authority to operate this equipment.
RF EXPOSURE STATEMENT:
This transmitter must not be co-located or operated in
conjunction with any other antenna or transmitter.
NOTE:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC CERTIFICATION
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interfer-
ence to radio communications. There is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following
MEASURES:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
02

1. Observe all instructions carefully in the U3 manual.
2. Do not to perform service operations beyond those
described in the U3 manual. Services required when the
apparatus has been damaged in any way, such as:
t-JRVJEIBTCFFOTQJMMFEPSPCKFDUTIBWFGBMMFOJOUPUIF
apparatus
t5IFVOJUIBTCFFOFYQPTFEUPSBJOPSNPJTUVSF
t5IFVOJUEPFTOPUPQFSBUFOPSNBMMZPSDIBOHFTJO
performance in a significant way
t5IFVOJUJTESPQQFEPSUIFFODMPTVSFJTEBNBHFE
WARNING: BEFORE USING YOUR XVIVE U3 MICROPHONE WIRELESS SYSTEM,
CAREFULLY READ THE OPERATING INSTRUCTIONS.
IMPORTANT SAFETY INSTRUCTIONS
PLEASE READ THESE INSTRUCTIONS
IN A SAFE PLACE
3. Do not place near heat sources, such as radiators, heat
registers, or appliances which produce heat.
4. Guard against objects or liquids entering the device.
Do not use or place unit near water.
5. Clean only with a dry cloth.
6. Only use attachments/accessories specified by the
manufacturer.
7. Prolonged listening at high volume levels may cause
irreparable hearing loss and/or damage. Always be sure to
practice “safe listening.”
03

U3 SET PRODUCT INTRODUCTION
1PCS
1PCS
1PCS
1PCS
1PCS
U3 Transmitter
U3 Receiver
USB Cable
Manual
Bag
PACKAGE DETAILS
04
t(I[CBOEJTPQUJNBMGPSEZOBNJDNJDSPQIPOFXJSFMFTT
system, Approved for use in worldwide.
t-FTTUIBONT-BUFODZ4JNVMUBOFPVTCSPBEDBTUTPO
channels.
t#SPBE)[o,)[GSFRVFODZSFTQPOTF
t6QUPGFFUBDUVBMSBOHFEFQFOETPO3'TJHOBMBCTPSQUJPO
reflection and interference )
t)PVSTPGCBUUFSZMJGFSFDIBSHFBCMFCBUUFSZGPSCPUI
Transmitter & Receiver)
t8PSLTXJUI9-3EZOBNJDNJDSPQIPOFBOECBUUFSZQPXFSFE
condenser microphones.
t
Mic mode for microphone and Line mode for other Gear output
t)JHI3FTPMVUJPOCJULQCT"VEJP
t%ZOBNJD3BOHFE#
t4JHOBMUP/PJTF3BUJPJTE#
t6XJSFMFTTBJNTUPUBLFUIFDPNQMFYJUZBOEGSVTUSBUJPOPVU
of traditional wireless microphone systems. Creating a
nFYJCMFBMMJOPOFTPMVUJPOUIBUNBLFTBOZZPVSGBWPSJUF
dynamic microphones into wireless.
t
Wireless audio system for active MPVETQFBLFST

05
QUICK START
1. Plug the Transmitter into the XLR dynamic microphone
and battery-powered condenser microphones.
2. Plug the Receiver into the Mixer.

06
QUICK START
3. Turn on the Transmitter and the
SFDFJWFSBOEDIFDLUIF$IBOOFM
4. After connecting successfully,
the LED lights on receiver will
stay on.
$IFDLUIFDPOOFDUJPOCZUBMLJOH
through the microphone.
Hello!

07
.JD*O9-3NJDSPQIPOFJOQVUKBDL
2 Spring: Circumferential ground spring providing an
accurate connection to the mating shell
.JD-PDLTFDVSFTUSBOTNJUUFSUPUIFNJDSPQIPOF
4 Input level switch: MIC = 0dB input
LINE = -10dB input
5 Power switch: switches unit on/off
6 Channel status LED: indicates selected channel
7 Channel switch: selects Channels 1-6
8 USB charging port
9 Power status LED: indicates power status:
Led off = 100% ~ 30%
Solid red = 29% ~ 11%
'MJDLFSJOHSFEMFTTUIBO
10 Antenna.
BASIC OPERATION
U3 TRANSMITTER
2
3
4 5
1
7
8
9
6
10

08
9-30659-3NJDSPQIPOFJOQVUKBDL
2 Power switch: switches the unit on and off
3 Channel status LED: indicates selected channel
4 Channel switch: selects Channels 1-6
5 USB Port: For charging the battery
6 RF Status LED:
0/5SBOTNJUUFSJTPOBOEMJOLJTFTUBCMJTIFE
Flashing = Signal connection interference
0''5SBOTNJUUFSPõPSVOMJOLFE
7 Power status Led: indicates power status.
Led off = 100% ~ 30%
Solid red = 29% ~ 11%
'MJDLFSJOHSFEMFTTUIBO
8 Antenna.
BASIC OPERATION
U3 RECEIVER
1
4
6
2
8
7
5
3

Tuning Bandwidth
8PSLJOH3BOHF
Audio Frequency Response
Dynamic Range
Battery Life
RF Sensitivity
Total Harmonic distortion
RF Output Power
Operating Temperature Range
Channel Count
o.)[
Up to 90ft. Actual Range Depends On Rf Signal Absorption, Reflection
And Interference.
)[o,)[E#%FQFOEFOU0O.JDrophone Type Or Input Signal.
110dB
Up To 5 Hours
-88dBm
0.2%
10 mW E.I.R.P. max
-18ȭto 57ȭ. Battery Characteristics May Limit This Range.
Up To 6 Channels
09
SPECIFICATIONS
U3 MICROPHONE WIRELESS SYSTEM
Autres manuels pour U3
1
Table des matières
Manuels Système de microphone populaires d'autres marques

Sennheiser
Sennheiser Evolution Wireless Digital EW-DX EM 2 Manuel utilisateur

Alpha Technologies
Alpha Technologies RBMS Manuel utilisateur

SWIT Electronics Co.,LTD.
SWIT Electronics Co.,LTD. CW-S150 Manuel utilisateur

Shure
Shure UA844 Manuel utilisateur

Panasonic
Panasonic SHFX70 - DVD HOME THEATER WIRELESS SYSTEM Manuel utilisateur

Pyle
Pyle PDWM5000 Manuel utilisateur











