XPR Access MTTS-EXIT Manuel utilisateur
www.xprgroup.com 1
Touch button switch
EN
MTTS-EXIT / MTTBK-EXIT
INSTALLATION
Introduction
Mounting instructions
WIRING AND APPLICATIONS
Features Speciications
MTT is a request-to-exit switch, It will work independently (standalone) or can equally be connected via a controller to provide exit
from a secured area (Push Button Input). With its slim looks and die-cast metal (or ABS) body, the MTT combines elegance and
aesthetics with ruggedness and reliability.
- Feather light touch control
- Works in Pulse and Latch mode
- Ideal for a wide range of applications
- Vandal-resistant (MTTS-EXIT version)
- Resin Potted Electronics
Audio and Visual indications:
- Front dual light indication
- Buzzer sound on every touch
Input voltage:
Current consumption:
Relay Output:
Panel Connection:
Indicators-LED:
Operating Temperature:
Operating Humidity:
Dimension (mm):
Housing:
Touch Plate:
Protection:
1224 VDC; 1524 VAC;
max.65mA
2A at 24V DC / 120V AC
Cable,
0.5 m
Normal - RED
Relay Operation – GREEN
-20° to 50°C
Non-condensing up to 95%92L
x 51W x 25H (Metal)
92L x 51W x 27H (ABS)
Die-cast Aluminium alloy or
bABS Mild Steel Painted
IP65
1. Identify a suitable location on wall or lat surface.
2. Stick the Drilling Template provided on chosen location. Drill 3 holes as indicated in the diagram.
3. Insert 3 nos. of 5 mm wall plugs provided into the drilled holes.
4. Route the cables through the holes provided in the BackPlate.
5. Fix the Backplate irmly on the wall using 3nos. of 3x30mm CSK screws
6. Connect wires.
7. After wiring, place the Housing over the ixed backplate and guide the slot into the backplate tab and slide it downwards.
8. Fix the Housing to the Back-Plate with a M3 x 6 mm Security Screw on the bottom of the Housing using a Security Screwdriver provided.
- Light switches
- Exit button (Access control)
- Elevator buttons
- Industrial panels
V4A
Important Note: Several layers of protection are provided against transient voltages from static discharge,lightning and power
supply spikes. For protection to be fully eective, earthing should be done correctly.
www.xprgroup.com 2
View
Output Connection for AC Device - Fail Secure
Application & Wiring
Output Connection for DC Device - Fail Open
OPERATION
Backlight ON/OFF
MTT operates in Latch and Pulse mode.
The time is set by Dipswitch setting.
Note: Set the operating time only before
switching on power to the MTT.
If the operating time is to be changed,
select a new time setting and then wait a
few seconds for the circuit to re-adjust
before switching back the power.
The table illustrates the dipswitch settings in dierent modes
Approvals and Safety standards
Immunity: Meets to EN500822 (EN6100042, EN6100043, EN6100044, EN6100045 and EN6100046)
Operation Switch 1 Switch 2 DipSwitch
Latch Mode ON ON
10 Seconds ON OFF
5 Seconds OFF ON
3 Seconds OFF OFF
This product herewith complies with requirements of EMC directive 2014/30/EU. In addition it complies with RoHS2 directive EN50581:2012
Ω
Ce manuel convient aux modèles suivants
1
Autres manuels XPR Access Changer
