Xerox 4215/MRP Manuel de service
XEROX
Xerox MRP Family
4215/MRP, 4219/MRP, 4220/MRP, 4230/MRP
PCL 5 and PostScript
Printer Language Reference
March 1995
721P81072
Xerox Corporation
701 S. Aviation Boulevard
El Segundo, CA 90245
© 1994 and 1995 by Xerox Corporation. All rights reserved.
Copyright protection claimed includes all forms and matters of
copyrightable material and information now allowed by statutory
or judicial law or hereinafter granted, including without limitation,
material generated from the software programs which are
displayed on the screen, such as icons, screen displays, looks,
etc.
Printed in the United States of America
Publication number: 721P81072
Xerox® and all Xerox products mentioned in this publication are
trademarks of Xerox Corporation. Products and trademarks of
other companies are also acknowledged.
Changes are periodically made to this document. Changes,
technical inaccuracies, and typographic errors will be corrected in
subsequent editions.
This document was created on the Xerox 6085 Professional
Computer System using VP software. The typeface is Optima.
Notices
Installation caution
Your Xerox laser printer is not customer installable. Only a
qualified service representative should install the equipment.
Safety
CAUTION: This equipment generates, uses, and can radiate
radio frequency energy, and if not installed and used in
accordance with the installation requirements, may cause radio
interference to radio communications.
U.S.A.
Your printer has been tested and found to comply with the limits
for a Class A computing device pursuant to Subpart J of Part 15
of FCC rules, which are designed to provide reasonable
protection against such interference when operated in a
commercial environment. Operation of this equipment in a
residential area is likely to cause interference. In such cases, the
user at his or her own expense is required to correct the
interference.
Canada
This digital apparatus does not exceed the Class A limits for radio
noise emissions from digital apparatus as set out in the radio
interference regulations of the Canadian department of
communications.
Les present appareil numerique n’emet pas de bruits
radioelectriques depassant les limites applicables aux appareils de
Classe A prescitees dans le reglement sur le brouillage
radioelectrique edicte par les ministre des communications du
Canada.
Europe: 50 Hz, 220 to 240 V equipment
This equipment has been tested and certified in conformance
with European commission directive 82/499/ECC and VDE
0871/0875, Class A, relating to radio frequency interference.
XEROX MRP FAMILY PCL 5 AND POSTSCRIPT PRINTER LANGUAGE REFERENCE iii
NOTICES
Laser safety
Your printer complies with appropriate safety standards.
Specifically regarding lasers, the equipment complies with laser
product performance standards set by governmental,
international and national agencies as a Class 1 laser product. It
does not emit hazardous light; the beam is totally enclosed
during all phases of customer operation and maintenance.
WARNING: Use of controls or adjustments or performance of
procedures other than those specified herein may result in
hazardous radiation exposure.
Be aware of all labels that warn you against removing panels or
covers. See the example below of a label located behind the
front cover, below the on/off switch.
DANGER - Invisible laser radiation
when open and interlock
defeated for service.
AVOID DIRECT EXPOSURE TO
BEAM
Instructions for safe service are
in SERVICE MANUAL.
These laser warning labels are placed on panels that cover areas
that are not operator serviceable. These panels are not to be
removed.
Operational safety
Your Xerox equipment and supplies are designed and tested to
meet strict safety requirements. These include safety agency
examination, approval, and compliance with established
environmental standards.
Attention to the following notes ensures the continued safe
operation of your equipment.
Do this
Always connect equipment to a properly grounded power source
receptacle. If in doubt, have the receptacle checked by a
qualified electrician.
WARNING: Improper connection of the equipment grounding
conductor can result in electrical shock.
Always place equipment on a floor with adequate strength for
the weight of the machine.
Always have your qualified service representative move or
relocate the equipment.
Always use materials and supplies specifically designed for your
Xerox equipment.
iv XEROX MRP FAMILY PCL 5 AND POSTSCRIPT PRINTER LANGUAGE REFERENCE
NOTICES
WARNING: Use of unsuitable materials may result in poor
performance and can possibly create a hazardous condition.
Always use a Xerox specified cordset with the Equipment Leakage
Circuit Interrupter/Residual Current Device (ELCI/RCD).
Use caution when installing or modifying telephone lines.
Do not do this
Never use an extension cord with the ELCI/RCD.
Never use the ELCI/RCD where water may enter the casing.
Never attempt any maintenance function that is not specifically
described in this document.
Never remove any covers or guards that are fastened with screws
unless otherwise instructed. There are no operator-serviceable
areas within these covers.
Never override or “cheat” electrical or mechanical devices.
Never operate the equipment if you notice unusual noises or
odors. Disconnect the power cord from the power source
receptacle and call Xerox service to correct the problem.
Never install telephone wiring during a lightening storm.
Never install telephone jacks in a wet location unless specifically
designated for wet locations.
Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
Avoid using a telephone (other than a cordless type) during an
electrical storm. There may be a remote risk of electrical shock
from lightening.
Never use a telephone to report a gas leak in the vicinity of the
leak.
U.S. only: If you need any additional safety information
concerning the equipment or Xerox supplied materials, call the
following toll-free number: 1-800-828-6571.
Approvals and certification
60 Hz, 115 V Listed by Underwriters Laboratories, UL1950 (UL). Meets CSA
standards, C22.2 NO 950 (CSA).
50 Hz, 220 to 240 V Meets the British Standards Institution, IEC950 (BSI).
Safety feature
Your printer equipped with an Equipment Leakage Circuit
Interrupter/Residual Current Device (ELCI/RCD). This safety
device protects you if an electric outlet supplying power to the
printer is improperly wired.
XEROX MRP FAMILY PCL 5 AND POSTSCRIPT PRINTER LANGUAGE REFERENCE v
NOTICES
U.S. configuration of ELCI/RCD
1 Window
2 Reset button
International configuration of ELCI/RCD
1 Window
2 Reset button
If power is interrupted to the printer, follow these steps:
1. Locate the safety device, using the U.S. or International
Configuration (above).
2. Check to see if a red flag displays in the window of the
safety device.
3. If the red flag does not display, press and release the black
Reset button.
The red flag displays and power is restored to the system.
If power is not restored by this procedure or if the device
interrupts power to the machine again, call your service
representative.
vi XEROX MRP FAMILY PCL 5 AND POSTSCRIPT PRINTER LANGUAGE REFERENCE
Table of contents
Notices iii
Installation caution iii
Safety iii
Laser safety iv
Operational safety iv
Introduction ix
About this manual ix
Text conventions ix
1. PostScript mode 1-1
Device-dependent features 1-1
Fonts available with the PostScript Language mode 1-1
Downloadable font types 1-2
Internal fonts 1-2
Adobe Type Manager fonts 1-3
Page Device setup 1-4
Page Device features 1-4
Resources 1-9
Compatibility operators 1-9
Miscellaneous PostScript features 1-9
2. HP LaserJet Emulation mode 2-1
HP PCL 5 compatibility 2-1
Job Control commands 2-2
Page Control commands 2-3
Image area 2-7
Fonts 2-7
Downloading fonts 2-7
Appendices A. HP PCL command quick reference A-1
B. HP-GL/2 command quick reference B-1
C. Related publications C-1
Index INDEX-1
XEROX MRP FAMILY PCL 5 AND POSTSCRIPT PRINTER LANGUAGE REFERENCE vii
Introduction
The Printer Language Reference is intended as an aid to
programmers using PostScript Page Description Language (PDL)
or Hewlett-Packard (HP) Printer Control Language (PCL) 5 to
write programs for a laser printer.
About this manual
This reference does not cover all aspects of HP PCL or PostScript
PDL.
Before using this manual, become familiar with its contents and
conventions.
Text conventions
The following text and procedure conventions are used
throughout this guide.
italics Italics are used for document and library names (for example, the
Xerox MRP Family 4220/MRP, 4230/MRP Operator Guide).
CAUTION: Cautions are associated with equipment safety.
WARNING: Warnings are associated with the safety of people.
NNotes: Hints that help you perform a task or understand the
text.
MB Megabyte.
K-byte Kilobyte.
K-bit Kilobit.
gsm Grams per one square meter of paper.
menus, modes, options, and commands These use downstyle capitalization (for example, Configuration
menu, Duplex mode, and Raster Graphics command).
XEROX MRP FAMILY PCL 5 AND POSTSCRIPT PRINTER LANGUAGE REFERENCE ix
Autres manuels pour 4215/MRP
1
Ce manuel convient aux modèles suivants
3
Table des matières
Autres manuels Xerox Imprimante
Xerox
Xerox 6200DX - Phaser Color Laser Printer Guide de référence rapide
Xerox
Xerox PHASER 340 Guide de configuration
Xerox
Xerox Phaser 7300DN Manuel utilisateur
Xerox
Xerox DocuColor 8000 Mise à jour du firmware
Xerox
Xerox Document Centre 240 ST Instructions d'utilisation
Xerox
Xerox Phaser 7750 Manuel utilisateur
Xerox
Xerox Phaser 3110 Manuel utilisateur
Xerox
Xerox Phaser 5500 series Manuel
Xerox
Xerox DocuPrint 180 NPS Series Manuel utilisateur
Xerox
Xerox CX PRINT SERVER 550 Manuel utilisateur
Xerox
Xerox VersaLink C8000 Manuel utilisateur
Xerox
Xerox Phaser 8560 Manuel utilisateur
Xerox
Xerox XES 8855 Manuel utilisateur
Xerox
Xerox Phaser 7100N Manuel utilisateur
Xerox
Xerox Phaser 6022 Manuel d'utilisation
Xerox
Xerox Phaser 7300 Fiche technique
Xerox
Xerox 3250D - Phaser B/W Laser Printer Manuel utilisateur
Xerox
Xerox DocuPrint C3290 FS Manuel utilisateur
Xerox
Xerox Phaser 6500 Manuel utilisateur
Xerox
Xerox Phaser 3052 Manuel d'utilisation
