SpecificSafety Rules
DO NOT let comfort or familiaritywith pillardrill (gainedfrom repeated
use) rep ace strict adherence to rotary hammer safety mles. if you use this
pillardrii
S—“éSAEVT‘
5’9)
10.
ii.
i2.
13.
14.
15.
16.
i7.
unsafelyor incorrectly,you can suffer serious personalinjury.
ways wear CE approvedeye protection.
ways use sharp drill bits
ever use sub-standard or blunt drill bits
ever use excessive force on the drill handle
ways ensure the pillardrill is securely mounted to asolid
orkbench or stand
ever remove the guard
ways disconnect the tool from the power source when setting
up. adjusting, or changing accessories.
Do not wear gloves, scarves, or loose clothing.
Aways clamp the workpiece and brace against column to prevent
rotation.
Be sure the bit is secured in place before operation.
Aways be sure you have afirm footing. Be sure no one is below
when using the pillardrill in high locations.
Keep hands away from movingparts.
Do not leave the pillardrill running.
Some material contains chemicals which may be toxic. Take
care to prevent dust inhalation and skin contact. Follow material
supplier safety data.
Use recommended speed for drill accessory and workpiece
rotation.
Be sure drill bit or cuttingtools is securely locked in the chuck,
Be sure chuck key is removed from the chuck before connecting
to power source or turningpower ON.
>ZE>ZZ>>
19.
20.
21.
22.
23.
24.
25.
26.
27.
8. Adjustthe table or depth stop to avoid drillinginto the able. Shut
off the power, remove the drill bit. and clean the table before
leavingpillardrill.
Do not connect tool to power source or operate until it is completely
assembled and installed according to the instructions. fany part
of your pillar drill malfunctions or has been damaged or broken. do
not operate until the part is properly repaired or replaced.
Never place your fingers in a positionwhere they could contact the
drill or other cutting if the workpiece should unexpectedly shift.
Never use your hand to hold the object while drilling.
Aways clamp
the object tight on the work table or use a drill vice to prevent
accidental injury.
Do not touch the bit or parts close to the bit immediate yafter
operation; they may be extremely hot and could burn skin,clothing
etc.
Never performany operation by moving the head unit or table with
respect to one another. Do not turn the switch ON or sart any
operation before checking that the head and table lock handles are
clamped tightto column and head and table support collars are
correctlypositioned.
Before engaging the power switch ON, make sure the belt guard is
down and the chuck is installed properly.
Turn the switch OFF when leaving the pillar drill. Do not perform
layout,assembly or set-up work on the table while the cutting tool
is rotating, switched on or connected to apower source.
Firmlyclamp or bolt you pillardrill to aworkbench or table.
Mount your pillardrill to either aworkbench or mounting board;
iailure to complycould result in possible serious injury.
Wolf—106302 .Page to
