Wixey WR25 Manuel utilisateur
Wixey
TM
Model WR25 Patented US Patent no. 7,580,804
Mini Digital Height Gauge
Instructions
SAFTEY FIRST
•Always turn off the power and unplug power tools before using any gauge.
•Never use power tools without properly installed blade guards. Guards
may not be shown for clarity.
Readout Operation
ON/OFF
and ZERO
PUSH MOMEN
TARILY TO TURN
OFF AND ON
HOLD FOR 3-5 SECONDS TO SET
TO 0.000 (ABS MODE ONLY)
IN/MM
TOGGLES BETWEEN INCHES AND
MILLIMETERS
INCH MODE
MILLIMETER MODE
ABS/INC
ABSOLUTE MEASURING M
ODE
TOGGLES BETWEEN ABSO
LUTE
AND INCREMENTAL
INCREMENTAL MODE RE
-
SETS
TO 0.000
TOG
GLE BACK TO ABS MODE
AND THE CALIBRATED
DIMENSION IS REMEMBERED
Problem Possible
Cause
Solution
Flashing Digits Low
Voltage
Replace Battery
No Display Low
Voltage
Replace Battery
No Display Bad
Contact
Clean Battery
Erratic or
Frozen Display
Internal
Error
Remove Battery
Wait 1 Minute
and Replace
Trouble Shooting
INSTALL CR2032
BATTERY
SCALE LOCK
KNOB
Battery installation and locking the scale
Using the Gauge
1. Set the base of the Height Gauge on a flat reference surface and lower the scale until
it lightly touches the surface. Set the display to 0.000
2. Set your or router bit or saw blades to the desired position as shown.
3. Install the plunger and zero the gauge for measuring depths as shown below
Barry Wixey Development
5306 Umbrella Pool Road
Sanibel, FL 33957
For more info on this and other Wixey products visit: www.wixey.com
Table des matières
Autres manuels Wixey Instrument de mesure
Manuels Instrument de mesure populaires d'autres marques
Endress+Hauser
Endress+Hauser Proline Promag 50 Caractéristiques techniques
Siemens
Siemens SITRANS F Coriolis FCT030 Manuel de la liste des pièces
KLINGER
KLINGER CMF V Series Manuel utilisateur
EXFO
EXFO FTB-2 Manuel d'exploitation et d'entretien
Keysight
Keysight M8290A Manuel utilisateur
ADTEK
ADTEK MW-5 Manuel utilisateur