Williams Sound WIR 135 Manuel utilisateur

VERVIEW

Thank you for purchasing the WIR 135 Listening System from Williams Sound Corp. Anyone

needing auditory assistance to overcome background noise, reverberation, or distance from the

sound source can benefit from the WIR 135.

You can use the WIR 135 for listening to the TV or other audio equipment, or for hearing assis-

tance in conference rooms. You can also use your RX8 Receiver in most facilities which have

an infrared transmitter operating on 95 kHz, such as theaters, cinemas, or churches.

YSTEM

OMPONENTS

1. TX95 Transmitter 2. RX8 Receiver

•TV Microphone (MIC 084) • (2) AA Batteries

• 1m Audio Cable with dual RCA plugs (WCA 078) •Earphone

• Power Supply

TEP

1: S

TX95 T

RANSMITTER

The WIR TX95 Transmitter may be placed on top of a TV or shelf. Place the TX95 Transmitter where it is

clearly visible from your listening position.

Infrared light behaves like visible light, so it is blocked by solid objects. This confines the signal to the room

where the transmitter is located. The transmitter cannot be placed inside or behind anything except glass. The

maximum operating distance is approximately 30 feet (9 m).

WIR 135 Listening System Instructions

Model WIR TX95 Transmitter, WIR RX8 Receiver

Williams Sound

Helping People Hear



Receiver

Charging 

Indicator

Right

Battery

Charging

Indicator

Left

Battery

Charging

Indicator

Infrared

Transmitting

Diodes

Infrared

Transmitting 

Diodes

(only for WIR 

RX95 Receiver)

RX95 Receiver Charging Cradle (not used in this system)

BAT AP97A

Battery

Charging Port

(not used in

this system)

BAT AP97A

Battery

Charging Port

(not used in

this system)

Ideally, the TX95 Transmitter should be at ear-level height or above. The infrared light pattern is

much like a floodlight “cone” as it leaves the transmitter, with the best reception inside the cone.

Sunlight can cause infrared interference by reducing the operating distance. Thus, the system can-

not be used outdoors and may not work properly inside if a lot of direct sunlight is present.

Closing drapes or blinds will help if sunlight is a problem.

Any number of receivers may be used with the TX95 Transmitter, but use only one transmitter

in a room at the same time. Otherwise, interference between transmitters will occur.

TEP

2: C

ONNECT THE

RANSMITTER

OWER

UPPLY

Plug the Power Supply cord into the “DC 12V” jack on the back of the TX95. Then plug the

Power Supply into an AC outlet.

TEP

3: C

ONNECT THE

RANSMITTER TO THE

UDIO

OURCE

You may also use the Audio Cable supplied to connect the TX95 Transmitter directly to TV,

VCR, or other equipment output jacks . The WIR 135 is a mono system, so the Left and Right

inputs are mixed together. The Left or Right input jack may be used with a mono sound source.

When the Audio Inputs are used, the Mic input is disabled.

If you are using the TV Microphone , plug it into the “Mic” jack on the TX95 as shown. Use

the Velcro strip supplied to attach the microphone near the loudspeaker of your TV. The micro-

phone will allow you to play the TV at lower volume for other listeners and will pick up other

important sounds like the telephone or doorbell ringing.

The TX95 has an automatic shut-off feature that turns the Transmitter off several minutes after

the audio signal is no longer present.

Williams Sound

Helping People Hear



RDC12V LM

POWER SUPPLY

TELEVISION,

VCR,

STEREO

MICROPHONE

TX95

TV, VCR, STEREO

TV Mic

- OR -

ETTING UP THE

TX95 T

RANSMITTER

4: I

NSTALL THE

ECEIVER

ATTERIES

Open the Battery Compartment on the RX8 Receiver

and install the two AA alkaline batteries. Be sure to

insert the battery “plus” and “minus” terminals

correctly as shown in the bottom of the battery com-

partment. DO NOT force the batteries in backwards.

If you are using rechargeable, Ni-Cad batteries (BAT

026), charge the batteries for 12–14 hours before

using the receiver.

Make sure the Receiver Volume Control Switch

(shown above) is turned OFF while charging.

5: P

LUG IN THE EARPHONE OR HEADPHONE

Next, plug the earphone or headphone into the jack

on top of the receiver

6: U

SING THE

ECEIVER

Rotate the Receiver Volume Control knob to turn the

receiver on and adjust the volume to a comfortable

level. Make sure your TV or audio source is turned

on. You should be able to hear the signal from the

Transmitter in the Receiver. The infrared receiver

“eye” is located on the front of the RX8. Do not

cover it up or you will lose reception.

Be sureto turn the Receiver OFF when it is

not in use.

ASE OF

IFFICULTY

If the system does not seem to be functioning:

1. Make sure that your television is plugged in and

turned on.

2. Make sure that the TX95 Transmitter is plugged

in and correctly connected to the TV or VCR’s

audio output.

3. If you’re using the TV Mic and not getting a sig-

nal: 1) Be sure the audio cable is not plugged

into the TX95; 2) Try turning the TV volume up

slightly; 3) Try positioning the TV mic directly

over the TV speaker.

4. Make sure that the RX8 Receiver has a working

battery.

5. Make sure you are not covering the RX8’s

infrared “eye.” Remove any objects obstructing

the line between the TX95 Transmitter and the

RX8 Receiver.

6. If you’ve installed the TX95 Transmitter other

than on top of the TV, make sure that its front

panel is facing the RX8 Receiver.

7. If the system still does not function, call your

Williams Sound Dealer.

ARRANTY

The WIR 135 Listening System carries a five year

parts and labor warranty on the TX95 Transmitter

and RX8 Receiver. The TV microphone, earphones,

headphones, rechargeable batteries, adaptors, and AC

to DC Power Adaptor carry a 90 day warranty. Be

sure to fill out and mail the Warranty Card to register

your serial number and warranty.

Williams Sound

Helping People Hear



Volume 

Control

& Switch

Earphone 

Jack

Infrared

"Eye"

Sound PlusSound Plus

®®

Infrared Receiver

Williams Sound

INFRARED LISTENING SYSTEM SPECIFICATIONS

Infrared Transmitter, Model WIR TX95-01 (EURO), TX95-02 (UK)

Size, Weight, Color: 6.25” L x 3.25” W x 1.25” H (15.9 cm x 8.3 cm x 3.2 cm), 5.1oz. (140g), Gray

Power Input: 12 VDC (center is positive) on DC connector, 200 mA Class II wall transformer

TFP 032 Power Supply, 2 pin Euro plug

TFP 033 Power Supply, 3 pin UK plug

Subcarrier Frequency: 95 kHz FM, 35 kHz wide-band modulation, 50 µS pre-emphasis

Auto Power On/Off: Transmitter shuts off after several minutes when audio signal is removed

Microphone Input: 3.5 mm jack for MIC 084 Electret TV Microphone, 1.5 kΩinput impedance

Line Inputs: 2 RCA jacks for mono or stereo line-level sources (bridged to mono)

200 mV min. to 10 V rms max. input level, 5.1 kΩinput impedance

Automatic Level Control: 35 dB compression range

Infrared LEDs, Pattern: 6 IR LEDs, 45 degree cone-shaped coverage pattern to -6dB intensity,

30ft. (9m) line of sight

Warranty: 5 years*

WIR RX8 Lavalier Receiver Specifications:

Size and Weight: 3.625” L x 2.375” W x .875” H (9.2 cm x 6 cm x 2.2 cm) 4.48 oz. (127 g)

Material and Color: Shatter-resistant polypropylene, gray

Battery Type: 1.5V (AA) x 2, Alkaline (BAT 001) or Rechargeable AA Ni-Cad (BAT 026)

Battery Life: 30 hours with BAT 001, 15 hours/charge with BAT 026, 25 mA, nom. current

drain

Charging: Contacts on side for CHG 200 dual charger or CHG 1600 multi-charger

Modulation Frequency: 95 kHz FM, 50 µS de-emphasis

Frequency Response: 200 Hz to 8 kHz, ± 4 dB

Signal to Noise Ratio: 55dB

Controls: Combination volume/On-Offrotary knob

Switched Low-Cut tone control (Lo: 20 Hz / Mid: 120 Hz / Hi: 700 Hz)

Audio Output: 3.5 mm stereo mini phone jack, 250 mW maximum into 16Ω

Acoustic Output: 130 dB MAX SSPL90 with EAR 013

Compatibility: Compatible with most wide-band 95kHz IR Transmitters

Warranty: 5 years*

The RX8 Receiver can be used with a Neckloop TeleCoil Coupler (NKL 001) to magnetically couple into a hearing aid

that has a telephone pick-up coil.

*90 day warranty on accessories

Williams Sound Corp.

10399 West 70th St., Eden Prairie, MN 55344-3459

U.S.A. 800-328-6190 / 952-943-2252 / FAX: 952-943-2174

www.williamssound.com

Ce manuel convient aux modèles suivants

Autres manuels Williams Sound Récepteur

Williams Sound

Williams Sound TGS PRO 737 Mode d’emploi

Williams Sound

Williams Sound Portable FM Listening System TGS 173 Mode d’emploi

Williams Sound

Williams Sound PPA VP 37 Mode d’emploi

Williams Sound

Williams Sound SoundPlus WIR RX22-4 Instructions de montage

Williams Sound

Williams Sound PPA T21 Manuel utilisateur

Williams Sound

Williams Sound WIR 100 Manuel utilisateur

Williams Sound

Williams Sound SoundPlus Infrared Receiver WIR RX238 Manuel utilisateur

Williams Sound

Williams Sound FM Listening System PPA 575 Manuel utilisateur

Williams Sound

Williams Sound Whisper R863 Instructions de montage

Williams Sound

Williams Sound R801 Guide de dépannage

Williams Sound

Williams Sound Digi-Wave DLT-100 Manuel utilisateur

Williams Sound

Williams Sound PPA VP Manuel utilisateur

Williams Sound

Williams Sound Personal PA R35 Instructions de montage

Williams Sound

Williams Sound Whisper R863 Manuel utilisateur

Williams Sound

Williams Sound PPA T46 Manuel utilisateur

Williams Sound

Williams Sound TGS 100 Manuel utilisateur

Williams Sound

Williams Sound SoundPlus Infrared System WIRTX900 Manuel utilisateur

Williams Sound

Williams Sound PPA R35-8 Instructions de montage

Williams Sound

Williams Sound PPA VP 37 Mode d’emploi

Williams Sound

Williams Sound PPA VP 37 Mode d’emploi

Williams Sound

Williams Sound PPA R751 Manuel utilisateur

Williams Sound

Williams Sound PPA R37 Instructions de montage

Williams Sound

Williams Sound Digi-Wave DLR 400 ALK Manuel utilisateur

Williams Sound

Williams Sound Digi-Wave DLT 400 Manuel utilisateur

Manuels Récepteur populaires d'autres marques

Garmin

Garmin GA 23 Manuel utilisateur

Aiphone

Aiphone PS-12F Manuel utilisateur

IMES

IMES TCS-01CA-PMI Manuel utilisateur

BWI Eagle

BWI Eagle AIR-EAGLE SR Manuel

AMIMON

AMIMON AMN12310 WHDI Manuel utilisateur

Dual

Dual DMCPA79BT Mode d'emploi

Sound Associates

Sound Associates SA652P Manuel utilisateur

Sherwood

Sherwood NewCastle R-772 Manuel utilisateur

Audio

Audio A10-RX Series Manuel utilisateur

AllSee

AllSee PushShare PSRV1.1 Manuel utilisateur

DEMAG

DEMAG DRC-DR D2 Manuel utilisateur

Teleco

Teleco TVRCL868A02 Manuel utilisateur

Bosch

Bosch RF3222E Manuel utilisateur

Kramer

Kramer 631R Manuel utilisateur

Xpress

Xpress xmc10 Manuel utilisateur

JVC

JVC KD-MR1BTS Manuel utilisateur

Omega Engineering

Omega Engineering UWTC-REC3 Manuel utilisateur

e-survey

e-survey E300 Pro Manuel utilisateur